Handleiding Sony CDX-1000RF Autoradio

Handleiding

L

R

AUDIO OUT

T

O

P

TO

P

Installation

Precautions

•Do not tamper with the four holes on the upper surface of the unit. They are for tuner adjustments to be

done only by service technicians.

•Choose the installation location carefully so that the unit will not hamper the driver during driving.

•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or

hot air from the heater, or where it would be subject to dust, dirt, or excessive vibration.

•Use only the supplied mounting hardware for a safe and secure installation.

Mounting example

Installation in the dashboard

2

With the TOP marking up

Bend these claws, if necessary.

1

4

3

Dashboard

Fire wall

To support the unit

Mounting the unit in a Japanese car

You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony dealer.

TOYOTA NISSAN

to dashboard/center console

Bracket

to dashboard/center console

7 max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

7 max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

Note

To prevent malfunction, install only with the supplied screws 7.

1

3 max. size M4 × 6 mm

(

3

/16 ×

1

/4 in.)

2

4

Bracket

7 max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

7 max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

7

6

6

7

max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

7

6

1

2

Bracket

Bracket

Existing parts supplied with your car

Mounting angle adjustment

Adjust the mounting angle to less than 60°.

1

10 mm (

13

/32 in.)

4 mm (

3

/16 in.)

90º

2

9

Insert the supplied tool 9 between the unit and the frame, and rotate 90° to

release the hidden mounting spring. Repeat on the opposite side and remove

the frame.

Insert a flathead screwdriver between the bracket and mounting spring. Gently

pry the spring toward the unit while pulling the unit out a little. Repeat on the

opposite side and remove the unit.

Removing the unit

1

Note

To prevent malfunction, install

only with the supplied screws 7.

Caution

•This unit is designed for negative ground 12 V DC operation only.

•Before making connections, disconnect the ground terminal of the car battery to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

•Be sure to connect the red power input lead to the positive 12 V power terminal which is energized

when the ignition key is in the accessory position.

•Run all ground wires to a common ground point.

•Connect the yellow cord to a free car circuit rated higher than the unit’s fuse rating.

If you connect this unit in series with other stereo components, the car circuit they are connected to

must be rated higher than the sum of the individual component’s fuse rating.

If there are no car circuits rated as high as the unit’s fuse rating, connect the unit directly to the

battery.

If no car circuits are available for connecting this unit, connect the unit to a car circuit rated higher

than the unit’s fuse rating in such a way that if the unit blows its fuse, no other circuits will be cut

off.

•The use of optical instruments with this product will increase eye hazard.

Reset button

When the installation and connections are complete, be sure to press the reset button with a ball-point

pen, etc.

Parts for Installation and Connections

The numbers in the list are keyed to those in the instructions.

5

1

× 2

2

6

7

3

8

4

× 4

Caution

Cautionary notice for handling the bracket 1.

Handle the bracket carefully to avoid injuring your fingers.

9

Connection example

From car antenna

Red

Yellow

Black Blue/White

AUDIO OUT

8

TO

P

TO

P

Fuse

AMP REMOTE OUT

Max. supply current 0.3 A

REMOTE IN

Speaker system

Car audio

Antenna connector*

3

Rotary commander RM-X4S*

2

(not supplied)

Fuse

To a metal point of the car

First connect the black ground lead, then connect the yellow

and red power input leads.

To the +12 V power terminal which is energized at

all times

Be sure to connect the black ground lead first.

To the +12 V power terminal which is energized in

the accessory position of the ignition key

Be sure to connect the black ground lead first.

Existing parts supplied with your car

Reset button

DSPL

SHUF

AMS

REPEAT

OFF

Connections

0.5 m

(1 ft. 8 in.)

0.5 m

(1 ft. 8 in.)

0.5 m

(1 ft. 8 in.)

0.5 m

(1 ft. 8 in.)

1.9 m (6 ft. 3 in.)

0.5 m

(1 ft. 8 in.)

*

1

You can only connect a car audio which has both a remote

amplifier input (AMP REMOTE IN) and an audio input (AUDIO IN).

Note

Do not connect an external amplifier to the audio output (AUDIO

OUT) of this unit. Otherwise, the volume of the connected

speakers cannot be adjusted.

If you have a Sony car audio with the Sony BUS terminal, the optional source selector

XA-107 can be used in your system.

max. size 5 × 6 mm

(

7

/32 ×

1

/4 in.)

RCA pin cord

(not supplied)

To AUDIO IN

of the car audio*

1

To AMP REMOTE IN

of the car audio*

1

BUS CONTROL IN

AUDIO IN

AUDIO OUT

AUDIO IN

AUDIO OUT

MASTER

Sony car audio

Source selector

XA-107

CDX-1000RF

With the TOP marking up

5

*

2

You can also control the following functions with the rotary cammander

RM-X4S:

Power on – Press SOURCE.

Power off – Press OFF.

Locate a specific track

– Rotate the SEEK/AMS control momentarily and release.

Locate a specific point within a track

– Rotate the SEEK/AMS control and release when the desired point is found.

Adjust the volume – Rotate the volume control.

*

3

An adaptor (optional) may be necessary for your car and car audio system.

In such a case, consult your dealer.

182 mm (7

1

/

4

in.)

53 mm

(2

1

/

8

in.)

CDX-1000RF

Car audio with FM tuner

CDX-1000RF

Car audio with FM tuner

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Sony CDX-1000RF Autoradio. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Sony. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Sony CDX-1000RF Autoradio in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Sony Autoradio's
Meer handleidingen voor Autoradio's

Veelgestelde vragen over Sony CDX-1000RF Autoradio

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Sony XAV-AX205DB Autoradio

Handleiding

Sony WX-800UI Autoradio

Handleiding

Sony XAV-AX8500 Autoradio

Handleiding

Sony CDX-GT160S Autoradio

Handleiding

Sony CDX-GT625UI Autoradio

Handleiding

Sony CDX-GT660UE Autoradio

Handleiding

Sony CDX-S22S Autoradio

Handleiding

Sony CDX-GT730UI Autoradio

Gerelateerde categorieën