Handleiding AMSEC ESL10XL Kluis

Handleiding

OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS FFOORR TTHHEE EESSLL1100XXLL EELLEECCTTRROONNIICC SSAAFFEE LLOOCCKK

Your AMSEC ESL10XL Electronic Safe Lock has a Factory Combination of:

CC--11--22--33--44--55--66--##

To open the lock simply press the “C” key to clear and wake up the electronics. Now

press the keys of the combination one at at time and finish with the “#” key. If the com-

bination keyed is correct, the lock will cycle open for three (3) seconds. During this 3-

second period, turn the handle of the safe to the unlocked position and pull the door

open.

Here are a few things to remember:

aa..

With each keystroke the red lamp on the keypad will flash and a chirp will be

heard.

bb..

If four (4) incorrect combinations are entered, the lock will go into a “Penalty

Lockout” for 15 minutes to prevent trial and error manipulation attempts at

opening the lock. The red lamp will flash once every 5 seconds during the penalty

period. If you press any key during the lockout period, the red lamp will flash with

a chirp 8 times rapidly to indicate the lockout condition.

cc..

Before keying the combination, be sure that the handle of the safe is in fully locked

position to allow the lock to open freely.

dd..

If the lock fails to open or acts strange, replace the batteries with good quality fresh

ALKALINE 9 volt batteries. To replace the batteries, simply turn the keypad housing

counter-clockwise to the stop and pull it away from the base. Un-snap the old

batteries and clip on the new one. Position them in the pocket at the bottom of the

housing and replace it watching that the wires are not pinched. You should replace

the batteries once a year to prevent corrosion damage from leak.

ee..

During the input sequence, if you make a mistake, you can press “C” to clear the

previous input and start over again.

ff..

The ESL10XL uses a fixed length six (6) digit combination.

gg..

Use only your fingers to key the combination. Sharp objects will result in damage

which is not covered by the warranty.

hh..

If at any time during opening or combination changing the unit is left wihtout input

for ten (10) seconds, it returns to a resting condition. If this occurs during a combi-

nation change, the Old Combination is retained.

ii..

At any time during opening or combination changing the unit will register the first 5

digits of the combination into the “buffer” that receives input. The 6th digit will be

the last numeric key pressed. For example, if you press

CC--11--22--33--44--55

-7-4-5-2-7-

66--##

the program recognizes only the C-1-2-3-4-5-6-# input. The last numeric key

pressed continues to replace the one prior until the “#” key is pressed to indicate

completion. This is a security feature that allows you to baffle an on-looker that may

be trying to memorize your combination.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je AMSEC ESL10XL Kluis. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met AMSEC. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van AMSEC ESL10XL Kluis in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor AMSEC Kluizen
Meer handleidingen voor Kluizen

Veelgestelde vragen over AMSEC ESL10XL Kluis

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.