Handleiding Black and Decker IR1375SC Strijkijzer

Handleiding

Please Read and Save this Use and Care Book.

IMPORTANT SAFETY

INSTRUCTIONS

When using your iron, basic safety precautions should

always be followed, including the following:

❍ READ ALL INSTRUCTIONS BEFORE USING.

❍ Use iron only for its intended use.

❍ To protect against a risk of electric shock, do not immerse

the iron in water or other liquids.

❍ The iron should always be turned to the minimum (min)

setting before plugging or unplugging from outlet. Never

yank cord to disconnect from the outlet; instead grasp

plug and pull to disconnect.

❍ Do not allow cord to touch hot surfaces. Let iron cool

completely before putting away. Loop cord loosely around

iron when storing.

❍ Always disconnect iron from electrical outlet when filling

with water or emptying, and when not in use.

❍ Do not operate iron with a damaged cord, or if the iron

has been dropped or damaged. To avoid the risk of

electric shock, do not disassemble the iron; take it to a

qualified service person for examination and repair, or

call the appropriate toll-free number on the cover of this

manual. Incorrect reassembly can cause a risk of electric

shock when the iron is used.

❍ Close supervision is necessary for any appliance being

used by or near children. Do not leave iron unattended

while connected or on an ironing board.

❍ Burns can occur from touching hot metal parts, hot water

or steam. Use caution when you turn a steam iron upside

down or use the surge of steam—there may be hot water

in the reservoir. Avoid rapid movement of iron to minimize

hot water spillage.

❍

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

❍

Children should be supervised to ensure that they do

not play with the appliance.

❍

The iron must be used and rested on a stable surface.

- When placing the iron on its stand, ensure that the

surface on which the stand is placed is stable.

- The iron is not to be used if it has been dropped, if

there is visible signs of damage or if it is leaking.

SPECIAL INSTRUCTIONS

❍ To avoid a circuit overload, do not operate another high-

wattage appliance on the same circuit.

❍ If an extension cord is absolutely necessary, a cord rate

at 15-ampere cord should be used. Cords rated for less

amperage may overheat. Care should be taken to arrange

the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS.

This product is for household use only.

POLARIZED PLUG (120V MODELS ONLY)

This appliance has a polarized plug (one blade is wider than the other).

To reduce the risk of electric shock, this plug is intended to fit into a

polarized outlet only one way. If the plug does not fit fully into the outlet,

reverse the plug. If it still does not fit, contact a qualified electrician.

Do not attempt to modify the plug in any way.

TAMPER-RESISTANT SCREW

Warning: This appliance is equipped with a tamper-resistant screw

to prevent removal of the outer cover. To reduce the risk of fire or

electric shock, do not attempt to remove the outer cover. There are

no user-serviceable parts inside. Repair should be done only by

authorized service personnel.

Note: If the power supply cord is damaged, it should be replaced

by qualified personnel or in Latin America by an authorized service

center.

How to Use

This appliance is intended for household use only.

GETTING STARTED

• Remove all labels, tags and stickers attached to the body, cord or soleplate

of the iron.

• Remove and save literature.

FILLING WATER TANK

1. With iron on a flat surface with soleplate down or tilted at a 45-degree angle,

open the water-fill cover.

2. Using a clean measuring cup, pour water into opening until water reaches

the MAX level mark on the side of the water tank. Do not overfill.

Note: This iron can be filled with ordinary tap water; if your water is hard or

soft, you may want to use distilled water. Do not use water processed through

a home softening system.

3. Close the water-fill cover securely.

4. Stand the iron on the heel rest.

Tip: To refill iron at any time during ironing session, unplug iron and follow

above procedure.

PREHEATING YOUR IRON

1. Plug in the iron into a polarized, 120V AC electrical outlet. Power indicator

light illuminates and you hear a beep for about 1 second.

2. Press

▲

to select your desired fabric setting, scroll up or down to select

fabric. The selected fabric setting light blinks and iron starts heating. Once

iron reaches the temperature, the light stays on and the power indicator

light shuts off.

Note: For optimum performance allow the iron to stand on the heel rest about

two minutes before beginning to iron.

SUGGESTIONS SELECTING FABRIC TEMPERATURE

1. Read fabric labels to help determine fabric type to be ironed.

Tip: If unsure of fabric’s fiber content, test a small area (on the inside seam or

hem) before proceeding to iron the entire garment or cloth.

When ironing a garment with mixed fabrics, select the fabric setting for the

most delicate fabric. For example, when ironing a shirt that is 65% cotton and

35% polyester, use for polyester.

2. Press

▲

to select your desired fabric setting scroll up or down for fabric

selection.

3. Whenever temperature setting is changed to a higher or lower temperature,

allow the iron to stand a minute or so to allow the iron to heat up or

cool down. Test garment by pressing a small hidden area to make sure

temperature of iron is correct.

Important: Always stand the iron on its heel rest when powered on but not

in use.

DRY IRONING

Ironing without steam (dry ironing) can be performed at any setting.

1. It is not necessary to empty the water tank; simply move the variable steam

selector to .

2. To select desired setting refer to directions under SUGGESTIONS

SELECTING FABRIC TEMPERATURE.

3. When finished ironing, scroll down to the lowest setting.

4. Stand the iron on its heel rest and allow it to cool off.

Important: Always stand the iron on its heel rest when powered on but not

in use.

• VARIABLE STEAM IRONING

This iron allows for using the Surge of Steam at settings 3 (Cotton Blend /

Wool) and 4 (Cotton / Linen). Push the steam selector to select the amount

of steam desired; this will help remove set in creases and wrinkles. Make

sure there is water in the tank.

• BURST STEAM.

Use for ironing in the vertical and horizontal position.

Press the surge steam button to generate a burst of steam. For best

performance, leave an interval several seconds between bursts.

Note: Only use this function at setting 4 (Cotton/Linen). Only use during the

setting 4 indicator light stays on, not blinking time.

SPRAY BUTTON

1. Press the spray button

CLEAN

MAX

MIN

to generate a spray of water. The water spray

can be used with dry or steam ironing as desired.

Tip: Use to dampen tough wrinkles and creases at any setting. Do not spray

silk.

3-WAY AUTOMATIC SHUT OFF

1. The iron will automatically switch to standby mode after 30 seconds of

inactivity if left on its soleplate or in its side. If left vertically on its heel

rest, it will turn off after 8 minutes.

2. You will hear 6 short beeps when auto shut off lights are blinking.

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified

service personnel.

CLEANING OUTSIDE SURFACES

1. Mare sure iron is unplugged and has cooled completely.

2. Wipe the soleplate and outer surfaces with a soft cloth dampened with

water. Add household detergent. Never use abrasives, heavy-duty cleaners,

vinegar or scouring pads that may scratch or discolor the iron.

3. After cleaning, steam iron over an old cloth to remove any residue from the

steam vents.

AUTO CLEAN

®

SYSTEM

To keep the steam vents free of any buildup, follow these instructions about

once a month.

1. Fill the water tank well below MAX line. Plug in the iron.

2. Select fabric setting 3 on the fabric selector and stand iron on its heel rest.

3. Wait 2 minutes for the iron to heat fully, them unplug the iron.

4. Hold iron over a sink with the soleplate facing down.

5. Press the Auto Clean® button.

Important: Be careful, as after several seconds, hot water and steam will

come out of the steam vents.

6. Continue to hold Auto Clean® button until all the water has emptied.

If necessary, move iron side-to-side and front-to-back.

7. When finished, release button, stand the iron on its heel rest and unplug

it in. Heat for about 2 minutes to dry out any remaining water.

STORING YOUR IRON

1. Unplug the iron and allow it to cool.

2. Check that the fabric-select is set to the minimum setting and that the

variable Steam Selector is set to dry .

3. Store vertically on its heel to prevent water leaking from the soleplate.

© 2011 Applica Consumer Products, Inc.

2013-6-5-29

When using your iron for the first time, you may notice water

residue inside the unit. This is normal.

is a registered trademark of The Black & Decker Corporation,

Towson, Maryland, USA

Made and Printed in People’s Republic of China

Printed on recycled paper.

Product may vary slightly from what is illustrated.

PROFESSIONAL IRON

USA/Canada 1-800-231-9786

Accessories/Parts 1-800-738-0245

Register your product at www.prodprotect.com/applica

MODELS ❍ IR1370C ❍ IR1375SC

NEED HELP?

For service, repair or any questions regarding

your appliance, call the appropriate 800 number

on cover of this book. Please DO NOT return the

product to the place of purchase. Also, please DO

NOT mail product back to manufacturer, nor bring

it to a service center. You may also want to consult

the website listed on the cover of this manual.

TWO-YEAR LIMITED WARRANTY

(Applies only in the United States and Canada)

What does it cover?

• Any defect in material or workmanship

provided; however, Applica’s liability will not

exceed the purchase price of product.

For how long?

• Two years from the date of original purchase

with proof of such purchase.

What will we do to help you?

• Provide you with a reasonably similar

replacement product that is either new or

factory refurbished.

How do you get service?

• Save your receipt as proof of date of sale.

• Visit the online service website at www.

prodprotect.com/applica, or call toll-free

1-800-231-9786, for general warranty

service.

• If you need parts or accessories, please call

1-800-738-0245.

What does your warranty not cover?

• Damage from commercial use

• Damage from misuse, abuse or neglect

• Products that have been modified in any way

• Products used or serviced outside the country

of purchase

• Glass parts and other accessory items that

are packed with the unit

• Shipping and handling costs associated with

the replacement of the unit

• Consequential or incidental damages (Please

note, however, that some states do not allow

the exclusion or limitation of consequential

or incidental damages, so this limitation may

not apply to you.)

How does state law relate to this warranty?

• This warranty gives you specific legal rights.

You may also have other rights that vary from

state to state or province to province.

































1. Sole plate

2. Spray nozzle

3. Water-fill cover

4. Variable steam selector

5. Steam button

6. Spray button

7. Comfort Grip® handle

8. 360˚ pivoting cord

9. Heel rest

10. Power/auto off light

11. Water tank

12. Fabric Selector

13. Auto clean® button

14. Fabric indicator light

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Black and Decker IR1375SC Strijkijzer. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Black and Decker. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Black and Decker IR1375SC Strijkijzer in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Black and Decker Strijkijzers
Meer handleidingen voor Strijkijzers

Beoordeling

Veelgestelde vragen over Black and Decker IR1375SC Strijkijzer

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Black and Decker C520 Strijkijzer

Handleiding

Black and Decker M405 Strijkijzer

Handleiding

Black and Decker X1030 Strijkijzer

Handleiding

Black and Decker XT2040 Strijkijzer

Handleiding

Black and Decker IR1925W Strijkijzer

Handleiding

Black and Decker D6000 Strijkijzer

Handleiding

Black and Decker F1055 Strijkijzer

Handleiding

Black and Decker IR0175W Strijkijzer

Gerelateerde categorieën