Handleiding Horstmann ChannelPlus H21XL Thermostaat

Handleiding

BATTERY

The programmer is fitted with a non-rechargeable, long life battery, which will maintain the

programmed time settings for a minimum of ten months with the supply disconnected.

THIS SHOULD BE SUFFICIENT TO COVER POWER INTERRUPTIONS DURING THE LIFE OF THE UNIT.

During power interruptions the display will be blank, after 3 days the current time of day will be lost.

If the programmer is not to be used for a long period of time, the switch on the rear of the unit

should be returned to the BATTERYOFF position. These are both to prolong the battery life.

SERVICE AND REPAIR

This programmer is NOT user serviceable. Please do not dismantle the unit.

In the unlikely event of a fault developing please refer to the RESETTINGTHEPROGRAMMERsection of

this user guide located on page 2. If this fails to resolve the problem please contact a local heating

engineer or a qualified electrician.

QUESTIONSANDANSWERS

The display only reads bAt

The unit display has become frozen

The indicator neon fails to illuminate on

Hot Water or Central Heating channel

The indicator neon will illuminate but

the pump and/or boiler fails to

operate

There is no display on the

programmer

How do I know if the programmer is

still under warranty

How is the programmer removed from

the wall

When setting the programme times, the

setting ‘bounces’ by 10 minute periods

Turn the battery on.The switch on the rear of the unit must be in either the Fully Pumped

or Gravity position.

This could be due to local electrical interference

Using the RESET procedure may rectify the fault.

Using the RESET procedure may rectify the fault. If the problem persists the

programmer will need replacing.

This may indicate a problem elsewhere in your system;

E.g. A zone valve, etc. please contact a registered installer for advice.

Try the RESET procedure on page 2, if this fails to rectify the problem please have the

mains supply checked

The ChannelPlus XL range comes with a 5 year guarantee from the date of manufacture.

This date is located on the rear of the unit, indicated by a month over a year

WARNING: The ChannelPlus programmer must only be removed from it’s backplate by

either a qualified electrician or heating engineer; The programmer plugs in to a 9 pin

backplate located on the rear of the unit and is secured using 2 screws located on the

top surface of the unit. Undo these screws and pull forward and down in an arc motion

This indicates that you have reached an existing set time period, you will be unable to

set a new ON/OFF time unless there is an alteration to the existing timed period

LEAFLET No P32635

ISSUE 3

Page 1

Page 4

The following are some of the easy to operate features:-

1 or 2 Hour Boost on each channel

Advance control gives instant On/Off override

Independent timing on Hot Water and Heating

Up to 3 On/Off periods per channel in each 24 Hour operation

Programme options: Auto / All day / On constantly / Off

FULLY PUMPED OR GRAVITY SYSTEM

The installer will have set the programmer to suit the installed system. If this is a Fully pumped

system this will allow independent control of the Central heating and Hot water, however on a Gravity

system the Central heating and Hot water are linked so that it is not possible to use the Central

heating independently. This will allow only one common time setting for both Hot Water and Central

Heating.

Horstmann’s ChannelPlus H21XL - Two Channel Programmer Offers up

to three programmed operating periods per day with independent

Boost and Advance control on Fully Pumped Systems.

Can be used as a direct replacement for Horstmann 425 Diadem, Tiara

and H525(Allowing for new programmer position).

1

5

4

3

2

7

6

8

9

11

10

13

12

14

LCD DISPLAYFEATURES

1 Current TIME OF DAY

2 Switch time SETTING indicator

3 ADVANCE symbol

4 BOOST symbol

5 Current Hot water programme

6 Current Central heating programme

7 Next Central heating switch time

8 Next Hot water switch time

15 SET slider switch

16 SET Positions

Internal Slide Switch -

located under front cover

16

15

LED INDICATOR

9 Central heating ON indicator

10 Hot water ONindicator

EASY TOUSE PROGRAMMEANDFEATUREBUTTONS

11 Central heating ADVANCE(ENTER) button

12 Hot water ADVANCE (PLUS) button

13 Central heating BOOST button

14 Hot water BOOST (MINUS)button

Both the Central heating and Hot water SELECT

buttons are located under the front cover

Horstmann Controls Limited

Bristol

BS4 1UP

Email: [email protected]k

Website: www.horstmann.co.uk

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Horstmann ChannelPlus H21XL Thermostaat. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Horstmann. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Horstmann ChannelPlus H21XL Thermostaat in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Horstmann Thermostaten
Meer handleidingen voor Thermostaten

Veelgestelde vragen over Horstmann ChannelPlus H21XL Thermostaat

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.