Caring For Your Brewer
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning.
Brewer Exterior
Keep your Keurig® brewer looking its best by cleaning the exterior
from time to time. Just clean with a damp, soapy, lint-free, non-
abrasive cloth. Never immerse the brewer in water or other liquids.
Pod Holder
Lift the handle. Push up while
grabbing the sides of the pod
holder assembly. Pull away
from brewer. Pull out the pod
holder assembly and base. Press
the release buttons on both
sides of the pod holder assembly.
Seperate the pod holder from
the housing. Clean the pod
holder (1), housing (2), and base
(3) with a damp, soapy, lint-free,
non-abrasive cloth and rinse
thoroughly. After all pieces are
cleaned, reassemble the pod
holder assembly by inserting
the pod holder back into the
housing. Place the base, then
the pod holder assembly into the
brew head. Lower the handle.
CAUTION: Sharp needles. Do not put
fingers in chamber.
Cleaning the Exit Needle
If a clog arises in the exit needle,
push the lever of the pod holder
to reveal the exit needle. Use
a paper clip or similar tool to
loosen the clog. Rinse thoroughly
with hot water. After all the
pieces are cleaned, place the
base then the pod holder
assembly into the brew head.
Lower the handle.
CAUTION: Sharp needles. Do not put
fingers in chamber.
Cleaning Entrance Needles
Lift the brewer handle and locate the top entrance needles on the
underside of the lid. To clean both holes in the needles, hold the
brewer handle in the upward position and with your other hand,
carefully insert a straightened paper clip into the holes. Gently move
it around to loosen any coffee grounds. Lower the handle completely
and run two water-only brew cycles. Do not insert a K-Cup® pod.
TIP: Refer to support.Keurig.com for video instructions on cleaning the
entrance/exit needles.
NOTE: You can also use a Brewer Maintenance Accessory tool to clean the entrance
needles. Reach out to Customer Service to get a Brewer Maintenance Accessory.
Drip Tray
The drip tray can hold up to 8 ounces of overflow and should be
emptied and cleaned occasionally. To remove, slide it toward you,
keeping it level to avoid spilling. Rinse and clean with a damp, soapy,
lint-free, non-abrasive cloth.
Water Reservoir & Reservoir Lid
The water reservoir lid and water reservoir should be periodically
cleaned with a damp, soapy, non-abrasive cloth and rinsed
thoroughly. The water reservoir lid and water reservoir should
not be put into the dishwasher. Do not dry the inside of the water
reservoir with a cloth as lint may remain. If needed, repeat
above procedures.
CAUTION: Please rinse the water reservoir thoroughly after cleaning. This will ensure
that no cleaning solutions remain in this area as they may contaminate the water supply
in the brewer.
Recycling K-Mug® and K-Carafe® Pods
The plastic cups of K-Mug® and K-Carafe® pods can be recycled wherever #5 plastic is accepted. #5 plastic
may not be recyclable in your community today, so please check locally with your municipality or waste
hauler, or visit KeurigRecycling.com for more information. #5 plastic is recyclable everywhere in Canada.
Once separated,
discard the lid and the
attached filter. Recycle
the plastic cup wherever
#5 plastic is accepted.
Once brewing is
complete and pod is
cool, separate the lid
and filter from the cup.
The filter will adhere
to the lid.
5
Keurig Green Mountain, Inc.
33 Coffee Lane
Waterbury, VT 05676
1.866.901.BREW (2739)
P/N | Pièce n
º
| Pieza n.
º
DC0000001093 REV A 09/17
Access Settings
Explore everything your Keurig®
Plus Series brewer has to offer
by accessing the Settings Menu.
From the home screen, select
the settings button.
Use the arrows to scroll through
the menu. To exit, press the
back button.
For all settings, press SAVE to confirm your selection or use the BACK BUTTON to return to the Settings Menu.
Choose Language
Press English, Spanish, or
French to select the language.
Set Clock
Time: Set the current time using
the arrows, then choose AM
or PM.
Display: Choose DIGITAL or
ANALOG. For digital only, use
the toggle to select 12 HR or 24
HR (military).
TIME
11
:
32
SAVE
12 HR 24 HR
DIGITAL ANALOG
12
:
00
SAVE
DISPLAY
Temperature
The temperature setting
provides even more control over
the brewing process.
Use the left and right arrows
to choose from low, low/
medium, medium, medium/high,
and high.
High Altitude
To ensure your brewer works
properly at higher altitudes
(5,000 feet), ENABLE the high
altitude mode.
Wallpaper
You can customize your touch-
screen color. Simply press
a color window to select a
wallpaper for the home screen.
If you are using a Keurig® Water
Filter, select ENABLE to activate
the water filter reminder.
Water Filter Reminder
Restore Factory Settings
Press YES to restore your brewer
to the default settings.
Restoring defaults erases
preferred brew settings,
temperature, wallpaper, auto
on/off, and nightlight settings.
The clock will be set to 12:00 AM.
Press NO to return to the
Settings Menu.
Settings Menu
PREFERRED BREW SETTINGS
K-CUP
1 OF 3
Auto On/Off
You can leave your brewer on at
all times so it is always ready to
make your perfect cup, or you
can set the auto on, auto off,
or energy saver mode.
Energy Saver: Set the brewer
to turn off in increments of 15
minutes after the last brew.
Auto Off: Select ENABLE to
activate auto off. Use the
arrows to set the time for
the brewer to automatically
turn off.
Preferred Brew Settings
The preferred brew settings
menu allows you to change
the default settings for each
KEURIG BREW number.
See the Settings and Touch
Screen Controls page for a
full list of available KEURIG
BREW settings.
Use the arrows to set your
preferred brew setting. Press
SAVE to confirm your selection
or use the BACK BUTTON to
return to the Settings Menu.
SAVE
TURN BREWER OFF WHEN IDLE FOR:
0
:
15
ENABLE
SAVE
TURN BREWER ON AT:
7
:
00
ENABLE
SAVE
TURN BREWER OFF AT:
10
:
00
ENABLE
AUTO ON/OFF
AUTO ON
AUTO OFF
ENERGY SAVER
Descaling Your Brewer
You should descale your brewer every 3-6 months. Properly follow
the descaling procedure.
Depending on the mineral content of your water, calcium deposits
or scale may build up in your brewer. Scale is non-toxic but if left
unattended can hinder brewer performance. Regularly descaling
your brewer every 3-6 months helps maintain the heating element,
and other internal parts that come in
contact with water. Calcium deposits
may build up faster, making it necessary
to descale more often. You should
promptly descale when the touch screen
indicates “Time to descale the brewer!”
Descaling Procedure
Before you begin, you will need a large ceramic mug, fresh water,
Keurig® Descaling Solution, and access to a sink. Do not use a paper
cup. Ensure that there is no beverage pod in the K-Cup® pod holder.
Please allow approximately 45 minutes for the descaling procedure.
Empty the water from the water reservoir. If there is a Keurig®
Water Filter, remove and set aside.
STEP 1: Descaling Solution Rinse
Press and hold the power button to power the brewer off.
Pour the entire bottle of Keurig® Descaling Solution into an emptied
water reservoir. Then fill the empty bottle with water and pour into
the water reservoir. Press and hold the power button to turn the
brewer back on.
Place a large mug on the drip tray and run a cleansing brew by
lifting and lowering the handle, selecting the largest brew size and
pressing the brew button.
STEP 2: Descaling Rinse & Repeat
Repeat the rinsing brew process until the touch screen indicates
“More Water Please”. Do not use a K-Cup® pod. Let the brewer
stand for at least 30 minutes while still on.
After 30 minutes, discard any residual solution from the water
reservoir and rinse thoroughly.
STEP 3: Fresh Water Rinse
Fill the water reservoir with fresh water to and not beyond the
MAX line.
Place a large mug on the drip tray plate and run a rinsing brew using
the largest brew size.
Do not use a K-Cup® pod. Pour the contents of the mug into the sink.
Repeat brew process until you have completed at least 12 rinsing
brews. You may need to refill the water reservoir at least one time
during this process.
NOTE: The cleaning action of Keurig® Descaling Solution may result in a “foam”
dispensed from the brewer. This is natural, as the solution is reacting with the scale inside.
For a brewer that is heavily scaled, the brewer may not fill properly after the descaler is
added. If this occurs, you may see only a small or no output dispensed, followed by the
sound of air blowing out. If this occurs:
Turn off and unplug the brewer.
If there is Keurig® descaling solution in the water reservoir, discard the contents,
rinse the water reservoir thoroughly and refill with water.
Plug the brewer back in, power on, and repeat the Step 3 Fresh Water Rinse cycle.
The brewer should begin to function normally as the solution is rinsed out and the
scale is removed. If problem persists, allow brewer to sit unplugged for at least 30
minutes before continuing with the rinse.
NOTE: If “Time to descale the brewer!” alert is still indicated on the touch screen, repeat
the descaling procedure.
CONTINUE
Time to descale
the brewer!
NOT NOW
Warranty
LIMITED ONE YEAR WARRANTY
Keurig Green Mountain, Inc. (Keurig) warrants that your brewer will
be free of defects in materials or workmanship under normal home
use for one year from the date of purchase. It is recommended
that you register your brewer on Keurig.com/new so that your
purchase information will be stored in our system. Keurig will, at its
option, repair or replace a defective brewer without charge upon its
receipt of proof of the date of purchase. If a replacement brewer is
necessary to service this warranty, the replacement brewer may be
new or reconditioned. If a replacement brewer is sent, a new limited
one year warranty will be applied to the replacement brewer.
This warranty only applies to brewers operated in the United States
and Canada. This warranty gives you specific legal rights, and you
may also have other rights that vary from state to state and, in the
case of Canada, from province to province.
Only the use of Keurig® K-Cup® brand pods and accessories will
guarantee the proper functioning and lifetime of your Keurig®
brewer. Any damage to or malfunction of your brewer resulting
from the use of non-Keurig® pods and accessories may not be
covered by this warranty or may result in a service fee if the
damage or malfunction is determined to be caused by such use.
OTHER LIMITATIONS
THIS WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY
OTHER EXPRESS WARRANTY, WHETHER WRITTEN OR ORAL.
IN ADDITION, KEURIG HEREBY SPECIFICALLY DISCLAIMS
ALL OTHER WARRANTIES WITH RESPECT TO YOUR K400
SERIES BREWER, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
Some states or provinces do not allow disclaimers of such implied
warranties or limitations on how long an implied warranty lasts, so
the above limitation may not apply to you depending on the state or
the province of purchase.
HOW DO YOU OBTAIN WARRANTY SERVICE?
Keurig® brewers are high-quality appliances and, with proper care,
are intended to provide years of satisfying performance. However,
should the need arise for warranty servicing, simply call Keurig
Customer Service at our toll free phone number 1.866.901.BREW
(2739). Please do not return your brewer for servicing without first
speaking to Keurig Customer Service to obtain a Return Materials
Authorization (RMA) number. Keurig® brewers returned without a
RMA number will be returned to the sender without servicing.
WHAT IS NOT COVERED BY THE LIMITED WARRANTY?
THIS WARRANTY DOES NOT COVER CONSEQUENTIAL OR
INCIDENTAL DAMAGES SUCH AS PROPERTY DAMAGE AND DOES
NOT COVER INCIDENTAL COSTS AND EXPENSES RESULTING
FROM ANY BREACH OF THIS WARRANTY, EVEN IF FORESEEABLE.
Some states or provinces do not allow the exclusion or limitations
of incidental or consequential damages, so the above limitation or
exclusion may not apply to you depending on the state or province
of purchase.
Nor does this warranty cover damages caused by use of non-Keurig®
pods or accessories, services performed by anyone other than
Keurig or its authorized service providers, use of parts other than
genuine Keurig® parts, or external causes such as abuse, misuse,
inappropriate power supply, or acts of God.
your new Keurig® brewer
and receive a special
savings offer
your favorite coffees with
our customized taste quiz and
get personalized recommendations
REGISTER
DISCOVER
Fully experience the benefits that come with your new Keurig® brewer at
KEURIG.COM/NEW
Auto On: Select ENABLE to
activate auto on. Use the
arrows to set the time for the
brewer to automatically turn on.
•
•
•
SETTINGS
LANGUAGE
CLOCK
AUTO ON/OFF
1 OF 3
BACK BUTTON
SETTINGS
Praat mee over dit product
Laat hier weten wat jij vindt van de Keurig K450 Koffiezetapparaat. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.