Handleiding Schumacher IP-180 Instant Power Accubooster

Handleiding

Schumacher Electric Corporation

Models: IPD-1800, IP-180

OWNER’S MANUAL

INSTANT POWER™ Jump Starter & DC Power Source

THIS PRODUCT HAS A SEALED LEAD-ACID BATTERY INSIDE THAT SHOULD BE KEPT AT FULL CHARGE FOR LONGER LIFE.

RECHARGE WHEN FIRST RECEIVED (EVEN IF GREEN ‘FULL POWER’ LIGHT GLOWS), AFTER EACH USE AND EVERY 3 MONTHS.

IMPORTANT SAFETY INSTRUCTIONS

Save these instructions

OPERATING INSTRUCTIONS

Warning: Failure to follow instructions may cause

damage or an explosion. Read entire instruction

manual before use.

1. Turn ignition off before making cable connections.

2. Use in a well-ventilated area.

3. Clamp the red clamp to the positive terminal of the battery.

(For a negative grounded system.)

4. Clamp the black clamp to an unpainted and unmoving part of

the chassis or engine block.

5. Keep clear of fan blades, belts, pulleys and other parts that

may cause injury.

6. After 2 seconds, a battery status LED will light and the internal

relays will click.

7. You can now crank the engine. If the engine does not start,

wait at least 3 minutes before attempting to start vehicle again.

(This permits the battery and relays to cool down.)

8. After the engine starts, first disconnect the black clamp and

then the red clamp in that order. Store the clamps on the ears

located on the sides of the case.

9. Recharge the product as soon as possible after use.

10. Never allow clamps to touch together or to contact the same

piece of metal to prevent sparking.

LED INDICATORS

To check the internal battery’s status, press the red button on the

front of the product.

The led lights will indicate as follows:

1. A red light indicates a 50% or less charge and you should

immediately recharge product.

2. A yellow light indicates a 50 to 75% charge. The product may

be used but should be recharged as soon as possible.

3. A green light indicates the internal battery is fully charged.

CHARGING of internal battery with plug-in wall charger.

After removing the product from the carton, charge it overnight

before using even if the green Full Power light glows.

1. To charge, plug wall charger cord into the socket on the back

of the product.

2. Plug the wall charger into a 120V AC source.

3. The red light on the back of the product will glow while

charging.

4. The light will glow green when the battery has reached full

charge. This could take up to 72 hours on some charges due to

age and condition of the battery. The charger will automatically

drop into a float mode and maintain the battery at full charge.

CHARGING of IPD-1800 internal battery in cradle/tray.

After removing the IPD-1800 from the carton, charge it overnight

before using even if the green Full Power light glows.

1. To charge, plug wall charger cord into the socket on the side

of the cradle/tray.

2. Plug the wall charger into a 120V AC source.

3. The green “charge complete” light on the cradle/tray will glow.

4. Place the IPD-1800 in the cradle/tray.

5. The “charge complete” light will glow red while charging.

6. The light will glow green when the battery has reached full

charge. This could take up to 72 hours on some charges due

to age and condition of the battery. The charger will

automatically drop into a float mode and maintain the battery

at full charge.

WARNING: Keep moisture, flammable materials and metal away

for the cradle/tray. The metal contacts are electrically live and may

spark when in use.

MULTI-PURPOSE POWER SUPPLY

The product is a power source for all 12 volt DC accessories that

are equipped with a cigarette lighter adapter plug. The DC socket

has a 30 amp automatic overload protection circuit breaker. Reset

the breaker by pushing the breaker button located on the back of

the product.

Do not permit the battery in the product to freeze. Never attempt

to recharge a frozen battery.

WARNING: Handling the cord on this product or cords associated

with accessories sold with this product, will expose you to lead, a

chemical known to the State of California to cause cancer and

birth defects or other reproductive harm.

Wash hands after

handling.

12 VOLT DC POWER SOURCE CHART

Appliance Type Estimated Wattage Estimated Time

Cell Phones 4 Watts 30 Hours

Fluorescent Lights 4 Watts 30 Hours

Radios 9 Watts 21 Hours

Depth Finders 9 Watts 21 Hours

Fans 9 Watts 21 Hours

Camcorders, VCRs,

Spot Lights 15 Watts 12 Hours

Electrical Tools,

Bilge Pumps 24 Watts 7 Hours

Electrical Coolers 48 Watts 3 Hours

00-99-000505/0205

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Schumacher IP-180 Instant Power Accubooster. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Schumacher. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Schumacher IP-180 Instant Power Accubooster in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Schumacher Accuboosters
Meer handleidingen voor Accuboosters

Veelgestelde vragen over Schumacher IP-180 Instant Power Accubooster

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Schumacher SL1327U Accubooster

Handleiding

Schumacher XP750C Instant Power Accubooster

Handleiding

Schumacher IP-1825FL Instant Power Accubooster

Handleiding

Schumacher IPD-1800 Instant Power Accubooster

Handleiding

Schumacher XP500 Instant Power Accubooster

Handleiding

Schumacher XP400 Instant Power Accubooster

Handleiding

Denver JST-9200 Accubooster

Handleiding

Kraftwerk 31319 Accubooster

Gerelateerde categorieën