Handleiding Sierra Designs Hercules AST Tent

Handleiding

S I E R R A D E S I G N S

SIERRA DESIGNS 2011 Cherry Street, Unit 202 Louisville, CO 80027 Phone: 303-262-3050 Fax: 303-262-3051 Toll Free: 800-635-0461

HERCULES AST

Your Sierra Designs

HERCULES AST (Arc Support

Technology) tent is very easy

to pitch and maintain. Follow

these instructions to pitch

your tent quickly, safely

and easily.

First Pitch

In order to familiarize yourself with your new tent, we suggest that you “test pitch”

it before embarking on a wilderness trip.

Select a Site

Look for a level spot that is protected from the wind in order to ensure sleeping

comfort. Clear the area of debris such as sharp stones and sticks which might abrade

or puncture the tent floor. Choose an area that will drain well when it rains.

Unfurl the Tent and Assemble the Poles

Unfurl the tent and lay the tent floor flat on the ground with the door unzipped.

There are four hub pole assemblies attached to the tent—one at the corner of each

tent. On each hub, insert the short poles attached to the hub into their corresponding

holes in the hub. Lay these down at the corners of the tents, untwisting the attached

webbing. There are also two pre-bent poles of equal length, and one “V-shaped”

vestibule pole. For these three poles, carefully unfold the shock corded pole sections

and allow them to slide together. Do not

allow the poles to snap together: This can

lead to serious pole damage. Make certain

that the insert of each pole section is fully

inserted into the next pole section (Figure 1).

Stake Out the Tent Floor

We recommend staking the floor prior to inserting the poles for greater pitching ease.

Although the Hercules AST is a totally free standing tent, we suggest that you always

stake the floor for greater stability, especially in high winds. First, stake each of the

webbing loops at points A and B (Figure 3).Then move to the front of the tent,

pulling the webbing loops at points C and D until the tent floor is squarely and

semi-tautly positioned, and then stake them down.

Erect the Tent

Start with one of the pre-bent poles. Insert one of the capped pole ends into the hub

attached to the stake loop at point A. Take care that both the webbing strap attached

to the hub and the stake loop are not twisted. Then, still working with the same hub,

insert the two pole tips on the ends of the short grommets at points E and F. Insert

the other end of the pre-bent pole into the hub attached to the stake loop at point D,

once again taking care that none of the straps are twisted. Next, insert the two pole

tips on the two shorter pole sections coming out of this hub into the grommets at I

and J. Repeat this process for the other pole/hub combination that runs from B to C.

After the pole frame is erected, attach the clips to the pre-bent poles starting from the

bottom of the tent and working your way up. Clip the Clip-Loc

™

at point M around

both poles. Then, wrap the bungee cord on the Clip-

Loc tightly around both poles, and slide the cord into

the groove on the backside of the clip, to keep the

cord taught (Figure 4).

Flysheet

You now have one remaining “V-shaped” pole. Place the tips of this pole in the

grommets attached to the clips at points N and P, or O and Q on the tent body. Note

that the tent body is symmetrical, so the vestibule pole can go at either end of the

tent. Next, drape the fly over the tent, making sure that the vestibule (with the vinyl

window) is over the vestibule pole.

Wrap the Velcro

attachments on

the underside of

the fly at points

X, Y, and Z

around the

vestibule pole.

There is

another Velcro

attachment at point M. Wrap

this around the pole intersection at point

M. At points 1 through 4 on the inside of the fly there are small side release buckles.

Attach these buckles to their mates, points 1-4, on the tent body. At points A, G, J,

and C there are

3

/

4

" LadderLocs with adjustable grommeted webbing straps. Slip the

grommets over the pole ends at these points (Figure 5). Attach the

3

/

4

" side-release

“Fly Clip” (Figure 6) buckles at points B and D to their corresponding buckles on the

tent body. By first clipping the blue webbing strap on the rainfly to a blue webbing

strap on the body, you are guaranteed a fast, proper

rainfly set-up every time. Now, working your way

around the tent a few times, tighten the adjustable

straps until you have achieved the desired taughtness

in the fly. Next, stake out points S and R away from

the tent to improve ventilation. Finally, stake out

and tighten down the vestibule loops at points T, U,

and AA.

Ventilation

Proper ventilation is essential for creating a comfortable living space inside your tent.

The vestibule door panel can be rolled away for maximum ventilation. Because the

vestibule forms an awning over the door, you can often leave the door tied open in a

rainstorm, provided the door faces away from the wind. When the door in the rear of

the rainfly is left fully or partially open, it effectively improves flow-through

ventilation. Additionally, the zippers at the top of the vestibule and the back door can

be used to regulate ventilation.

Internal Guy System

Sierra Designs was the first to introduce the revolutionary Internal Guy System. This

system remains a very important feature in our Convertible and 4-Season tents. When

installed, this simple system will greatly increase the strength of your tent with the

weight of a few guy cords. This system is very useful in extreme weather conditions,

but is not necessary under normal conditions. Installation: All attachments are made

inside the tent. All that is needed are 4 pieces of guy cord of 100" lengths or longer,

(line tighteners may be used but are optional). Some guy cords and line tighteners are

provided with your tent, however, you can also purchase the “Internal Guy System”

accessory, which uses Swift Clips to eliminate the need to tie knots. There are nine

webbing loops sewn to the interior of the tent body; one in each corner of the floor at

points A, B, C, and D and four on the tent ceiling at points 5, 6, 7, and 8 (Figure 3).

For added strength along the sides of the tent, run the guy cords between points on

the tent as follows: A to 6, B to 5, C to 8, and D to 7. For added strength along the

front and rear of the tent, run the guy lines A to 7, B to 8, C to 5, and D to 6 (in this

configuration, the Internal Guy System will partially obstruct the doorway.) With

each guy cord, tie one end to the webbing loop in the ceiling. Secure the other end to

floor webbing loop with a double half-hitch or a line tightener.

Please note that 9 tent stakes and 6 guy cords were provided with this tent as a courtesy. If you

choose to use more than this when pitching your tent, additional stakes may be purchased at the

store where you originally purchased your tent.

Figure 3: Tent Body (top view)

HERCULES AST TENT CONTENTS

Tent Body & Rainfly: 1 Line Tighteners: 1

Tent Poles: 2 Pitching Instructions: 1

Tent Stakes: 9* Stake Sack: 1

Guy Cord: 4 Pole Sack: 1

Hub Assembly: 4

* Sierra Designs tents include stakes for pitching the body and fly under normal conditions.

Additional stakes may be required in severe conditons.

Figure 5: Flysheet (top view)

Figure 6: Fly Clip

Figure 1: Correct Pole Assembly

Figure 2: Assembled Poles

Figure 4: Clip Loc

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Sierra Designs Hercules AST Tent. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Sierra Designs. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Sierra Designs Hercules AST Tent in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Sierra Designs Tenten
Meer handleidingen voor Tenten

Veelgestelde vragen over Sierra Designs Hercules AST Tent

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.