Handleiding Silverlit Sky Falcon Radiobestuurbare helikopter

Handleiding

Helicopter

Parts Identification

Troubleshooting

Battery Installation & Charging

Symptom Cause Correction

The helicopter does not response. - The helicopter and/ or the transmitter is switch

off ("OFF").

- The battery of the helicopter is weak.

- Band selection on transmitter is not correct.

- Set the power switch to "ON".

- Recharge the battery of the helicopter.

- Select the correct frequency band.

Suddenly stop and drop down when

flying.

- Recharge the battery of the helicopter.

- The battery of the helicopter is weak.

- Another infrared control device using the

same frequency band.

- Affected by strong lighting.

- Tail rotor blade is deformed or distorted.

- Avoid these if possible, or choose another place

to operate the helicopter.

- Change another environment to avoid direct

lighting.

- Replace the tail rotor blade with the spare one

provided.

Loss of control.

ENGLISH 1

ENGLISH 3

4 ENGLISH

2 ENGLISH

1. Open the battery compartment by

loosening the screw.

2. Insert 6 AA batteries in the battery

compartment with correct polarity.

3. Close the battery compartment.

Note: 1. The helicopter can operate for about 4 - 5 minutes per every 20 - 30 minutes charging.

2. Before recharging the battery, wait 10 - 15 minutes for it to cool down.

Note:

When the power indicator on the transmitter starts blinking, replace the batteries.

Transmitter Battery Installation (*Make sure the power switch is on “OFF” position.)

1. Pull out the cover and take out the

charging plug from the transmitter.

2. Switch off the helicopter. Insert the

charging plug into the charging socket on

the helicopter.

3. Switch on the transmitter. The charging

process will begin automatically and the

green charging indicator will light up.

Unplug the charging plug after the

charging indicator turns off, charging is

completed.

EI-3901

Silverlit SAS, Espace Green Parc, Route de Villepecle, 91280 Saint Pierre du Perray / France.

©

2012 Silverlit. All rights reserved.

Stabiliser

Stabiliser linkage

Main rotor blade

Tail rotor

Charging socket

Power switch

Battery compartment Battery compartment

LED headlight

Press the headlight button once to switch the LED headlight on. Press the button again to switch the LED off.

5. Helicopter headlight:

Charging Helicopter

OFF/CHARGE

ON

Battery requirements transmitter:

Battery requirements helicopter:

Special notes to adults:

- Parents: Please read the operating instructions carefully with your children prior to the first

use.

- Only operate the toy indoor under adult supervision.

- Assembly should be performed under adult supervision (changing batteries/ spare parts,

trimming etc.).

- Parental guidance is recommended when installing or replacing batteries.

This helicopter is equipped with a LiPo rechargeable battery,

please pay attention to the following cautions for safety use:

- Do not dispose the battery in fire or heat.

- Do not use or leave the battery near a heat source such as fire or heater.

- Do not strike or throw the battery against hard surface.

- Do not immerse the battery in water, and keep the battery in a cool dry environment.

- When recharging, only use the battery charger specifically for that purpose.

- Do not over-discharge the battery.

- Do not connect the battery to an electrical outlet.

- Do not directly solder the battery and pierce the battery with a nail or other sharp object.

- Do not disassemble or alter the battery.

- Charge the battery every 6 months.

- Do not transport or store the battery together with metal objects such as necklaces, hairpins etc.

- As for a used battery, please recycle after covering the battery terminals with insulation tape or

inserting it to an individual poly-bag.

Care and Maintenance:

- Always remove batteries from the toy when it is not being used for a long period of time.

(Transmitter only)

- Regularly examine for damage to the plug, enclosure and other parts. In the event of any

damage, the toy must not be used with the transmitter charger until the damage has been

repaired.

- Wipe the toy gently with a clean cloth.

- Keep the toy away from direct heat.

- Do not submerge the toy into water that can damage the electronic assemblies.

Notes:

- Under the environment with electrostatic discharge, the toy may malfunction and require

user to reset the toy.

- New alkaline batteries are recommended to use in this toy to obtain best and maximum

performance.

- This toy must only be used with the recommended charger.

Battery warnings:

- Non-rechargeable batteries are not to be recharged.

- Rechargeable batteries are to be removed before being charged. (Transmitter only)

- Rechargeable batteries are only to be charged under adult supervision.

- Different types of batteries or new and used batteries are not to be mixed. (Transmitter only)

- Only batteries of the same or equivalent type as recommended are to be used.

- Batteries are to be inserted with correct polarity.

- Exhausted batteries are to be removed from the toy. (Transmitter only)

- The supply terminals are not to be short-circuited.

- Do not mix old and new batteries. (Transmitter only)

- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

(Transmitter only)

The crossed-out dustbin symbol indicates that batteries, rechargeable batteries,

button cells, battery packs, etc. must not be put in the household waste. Batteries

are harmful to health and the environment. Please help to protect the environment

from health risks. Tell your children to dispose of batteries properly by taking them to

the local collecting points. This way batteries are recycled safely.

Waste Electrical and Electronic Equipment (WEEE)

When this appliance is out of use, please remove all batteries and dispose of them

separately. Bring electrical appliances to the local collecting points for waste electrical

and electronic equipment. Other components can be disposed of in domestic refuse.

WARNING:

CHOKING HAZARD - Small parts.

Not for Children under 3 years.

Safety precautions:

Warning:

Conversion or modifications to this product not expressly approved by the party responsible

for compliance could void the user's authority to operate the product.

- The transmitter-charger is tailor-made for the LiPo rechargeable battery used in helicopter. Do not use

it to charge any battery other than that in the helicopter.

Instructions manual

Delivery contents

Precautions, Warnings & Statements

- Never take apart or attempt to modify the product. This could damage the product.

- Helicopter piloting requires specific skills and should be learned under direct supervision of an

experienced adult.

- Never operate this product if it has damaged parts.

- This product is designed for indoor use only. Wind and short transmission range can lead to loss of

control.

- Attention! Do not fly the helicopter near persons and animals.

- Do not fly the helicopter in the vicinity of water and power lines.

- For better flight results, make sure you choose a sufficiently large room, free of obstacles such as

lamps, loose objects, etc.

- Always keep your eyes on the helicopter and prevent it from landing or crashing near your head, your

body, or on other people.

- Stand during operation in order to get out of the way of the helicopter quickly if necessary.

- Always switch the helicopter and the transmitter off when not operating.

- Warning! Do not touch the running rotors. Keep hands, hair and loose clothes away from moving

parts to avoid injury.

- Never hold or throw any objects into the running rotors.

- Attention! Risk of eye injuries! Keep a safety distance of at least 1 metre.

- Keep this instruction manual for future reference.

Tip! Safety hints

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference, and

2)This device must accept any interference received, including interference that may cause undesired

operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installat

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is enco:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Statements

Power supply :

Battery ratings : DC 9 V , 2 W

Batteries : 6 x 1.5 V "AA"/LR6/AM3 (not included)

Power supply :

Battery ratings : DC 3.7 V , 2.96 W

Batteries : 1 x 3.7 V Li-Po Rechargeable Battery Pack (included)

Capacity : 90 mAh

Tool for Tail Rotor

Blade Replacement

Spare tail

rotor blade

For Ages 10+

Ab 10 Jahre

Pour 10 ans et plus

Voor leeftijd 10+

Para 10+ años

Dai 10 anni in su

Helicopter

Transmitter

Age classification: not suitable for children under 8 years of age

Alterseinstufung: Nicht für Kinder unter 8 Jahren geeignet

Catégorie d’âge: ne convient pas à des enfants de moins de 8 ans

Leeftijdsclassificatie: niet geschikt voor kinderen onder de 8 jaar

Clasificación de edad: Este producto no es apto para niños menores de 8 años

Età dell'utente: non adatto a bambini di età inferiore a 8 anni

Transmitter

Landing gear

1

2

Caution:

Spare tail rotor blade

only to be replaced by adult.

Tool for Tail

Rotor Blade

Replacement

IR diodes

CHARGE/

ON

OFF

Minimum throttle position

Battery compartment

Power indicator

Direction stick

Yaw trim button

Power switch

Charging indicator

Charging plug

Throttle stick

Band selector

Light button

- For controlling the sticks on transmitter, try not to push the sticks immediately any extreme

positions. It should be like steering a bicycle rather than pressing computer game sticks.

- For the novice pilot (after the trimming procedure is completed), it is highly recommended

to focus exclusively on learning to control the throttle stick first. If the helicopter turns

around by itself there is no need to keep it straight. For the first flight, it is important to

learn to keep the helicopter at a constant altitude of around 1 meter with very gentle inputs

on the throttle stick. Once the pilot masters this, he may start learning to take control with

the direction stick.

Flying Your Helicopter

Tip! Piloting hints

- If the helicopter is crashed, switched off the helicopter and the

transmitter. Examine the helicopter and ensure it has no damage before

switching them on again.

- Don’t operate the helicopter under the direct bright light it will affect the

control system of your helicopter.

- Don’t cover the IR diodes of the transmitter as it will block the IR signal.

- Don’t stick any other label onto the helicopter as it will affect receiving of

IR signal.

Tip! Operation hints

- Set the band on transmitter to the same as the helicopter's. Make sure that the transmitter is switched off.

- Switch on the helicopter, the power LEDs will flash.

- Place the helicopter on the ground with the tail point towards you and the nose pointing away.

- Make sure the throttle stick is at the minimum position, then switch on the transmitter.

2. Trimming the helicopter:

- Gently push the throttle up to raise your helicopter about 0.5 to 1 meter high.

- When the helicopter spirals

(fig. 4) or keeps turning

anticlockwise (fig. 5), press the

right side of the yaw trim button

("R") repeatedly until the

helicopter flies straight (fig.6).

Spiral anticlockwise

Keep turning anticlockwise

Spiral clockwise

- When the helicopter spirals (fig. 1)

or keeps turning clockwise (fig. 2),

press the left side of the yaw trim

button ("L") repeatedly until the

helicopter flies straight (fig. 3).

Keep turning clockwise

1. Flight Environment

Choose the place which meets the following condition:

1. Indoor environment with calm air. Beware of the air circulation from the air-conditioner.

2. Caution: There must not be any dangerous objects (electric fan, air-conditioner, reading lamp, etc) on the flight path.

fig. 1

fig. 2 fig. 5

fig. 4

ST.TRIM RL

fig. 6

ST.TRIM RL

fig. 3

90º

Hold the tail between fingers.

1 2 3

If the helicopter speeds forward

unintentionally, twist the tail

anticlockwise for about 30°.

If the helicopter speeds

backward unintentionally, twist

the tail clockwise for about 30°.

Release the tail.

- Tail alignment adjustment. If the helicopter speeds forward/ backward by itself.

- Put the helicopter on a smooth surface. Uneven floor surface will affect its lifting off.

- Slowly increase the throttle.

- Do not look at the transmitter but focus on the helicopter.

- As soon as the helicopter leaves ground, reduce the throttle slightly. (In the worst case, helicopter will go back to the floor but that is better than

crashing against the ceiling.)

- Very gently increase the throttle if the helicopter descends.

- Very gently reduce the throttle if the helicopter ascends.

- For turning, give short and small inputs to the direction stick. (Most beginners will easily overcontrol the helicopter.)

4. Lift-off procedures (after trimming procedure):

3. Flight control:

Hover up and down:

When the helicopter flies steadily, slowly push the throttle stick up to

make helicopter fly higher, or lower the stick a bit to make helicopter fly

lower. Only small amounts of stick position change are required for

smooth flying.

Turn left and right:

Maintain the helicopter at a certain height. Push the direction stick

toward left to turn the helicopter anticlockwise, and push the direction

stick toward right to turn it clockwise.

Hover up

Hover down

Forward and backward flight:

Maintain the helicopter at a certain height. Push the direction stick upward to fly

the helicopter forward. Push it downward to fly the helicopter backward.

Forward Backward

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Silverlit Sky Falcon Radiobestuurbare helikopter. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Silverlit. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Silverlit Sky Falcon Radiobestuurbare helikopter in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Silverlit Radiobestuurbare helikopters
Meer handleidingen voor Silverlit