Handleiding Uniden 1100 Telefoon

Handleiding

Important Information

NOTICE: This product meets the applicable Industry Canada technical

specications.

Operation is subject to the following two conditions: (1) This device may not cause

interference, and (2) This device must accept any interference, including interfer-

ence that may cause undesired operation of the device.

The equipment must be installed using an acceptable method of connection. The

customer should be aware that compliance with the above conditions may not

prevent degradation of service in some situations.

Repairs to certied equipment should be made by an authorized Canadian

maintenance facility designated by the supplier. Any repairs or alterations

made by the user to this equipment, or equipment malfunctions, may give

the telecommunications company cause to request the user to disconnect the

equipment.

Users should ensure for their own protection that the electrical ground

connections of the power utility, telephone lines and internal metallic water pipe

systems, if present, are connected together. This precaution may be particularly

important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but

should contact the appropriate electric inspection authority, or electrician, as

appropriate.

NOTES: This equipment may not be used on coin service provided by the

telephone company.

Interference Information

This equipment generates and uses radio frequency energy which may interfere

with residential radio and television reception if not properly installed and used

in accordance with instructions contained in this manual. Reasonable protection

against such interference is ensured, although there is no guarantee this will not

occur in a given installation. If interference is suspected and veried by switching

this equipment on and o, the user is encouraged to try to correct the interference

by one or more of the following measures: Reorient the radio/television receiver’s

antenna, relocate the equipment with respect to the receiver, plug the equipment

and receiver into separate circuit outlets. The user may also wish to consult a

qualied radio/television technician for additional suggestions. This equipment

has been fully tested and complies with all limits for Class B computing devices

pursuant to part 15 FCC Rules and Regulations. Operation is subject to the follow-

ing two conditions: (1) This device may not cause interference, and (2) This device

must accept any interference, including interference that may cause undesired

operation of the device.

Telephone Network Information

Should your equipment cause trouble on your line which may harm the telephone

network, the telephone company, where practicable, may notify you that

temporary discontinuance of service may be required. Where prior notice is not

practicable and the circumstances warrant such action, the telephone company

may temporarily discontinue service immediately.

The telephone company may make changes in its communications facilities,

equipment, operations or procedures where such action is required in the

operation of its business. If these changes are expected to aect the use or

performance of your telephone equipment, the telephone company will likely

give you adequate notice to allow you to maintain uninterrupted service.

Notice must be given to the telephone company upon termination of your

telephone from your line.

REN Number

On the bottom of this equipment is a label indicating, among other information,

the Ringer Equivalence Number (REN) for the equipment.

The REN is useful in determining the number of devices you may connect to

your telephone line and still have all of these devices ring when your telephone

number is called. In most (but not all) areas, the sum of the RENs of all devices

connected to one line should not exceed 5. To be certain of the number of devices

you may connect to your line as determined by the REN, you should contact your

local telephone company.

REN Number is located on the cabinet bottom.

Licensing

Licensed under US Patent 6,427,009.

Before You Begin

Telephone Jack Requirements

To use this phone, you need an RJ11C (CA11A) type

modular telephone jack, which might look like the one

pictured here, installed in your home. If you don’t have a

modular jack, call your local phone company to nd out

how to get one installed.

Important Installation Information

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is specically

designed for wet locations.

• Never touch non-insulated telephone wires or terminals, unless the

telephone line has been disconnected at the network interface.

• Use caution when installing or modifying telephone lines.

• Temporarily disconnect any equipment connected to the phone such as faxes,

other phones, or modems.

Handset Layout

Hearing Aid Compatibility (HAC)

This telephone system meets FCC/Industry Canada standards for Hearing Aid

Compatibility.

Introduction

Your telephone is designed to give you exibility in use and high quality

performance. To get the most from your new telephone, we suggest that you take

a few minutes right now to read through this instruction manual.

CAUTION: When using telephone equipment, there are

basic safety instructions that should always be followed.

Refer to the IMPORTANT SAFETY INSTRUCTIONS provided

with this product and save them for future reference.

NOTE: This phone uses Touch-Tone dialing service only. For

this telephone to function properly, you must use Touch-Tone

service available through your local telephone company.

Modular

telephone line

jack

Wall plate

Model 1100

Series Slimline

Phone User’s Guide

Model 1100

Printed in China

Visit the our website at: www.uniden.com

Installing the Phone

Your telephone should be placed on a level surface such as a desk or table top, or

you can mount it on a wall. A desktop/wall mounting pedestal is built into the

base of the phone.

1. Slide the RINGER volume switch (on the handset) to the desired volume.

2. Set the receiver volume switch (on the handset) to the desired listening

volume.

3. Plug the telephone line cord into a modular wall phone jack.

4. Store the extra cord in the grooves in the base.

Wall Mount Installation

Your telephone may also be mounted on a wall plate (not included).

NOTE: To prevent the handset from falling out of the cradle

while the phone is hanging on the wall, you must reverse the

handset hook (located on the base).

1. Push the handset hook up and out of the slot on the base with your

thumb, rotate the hook 180°, and replace it back in the slot.

2. Plug the telephone line cord into a modular wall phone jack.

3. Slip the mounting holes on the base over the wall plate posts and rmly

slide the unit down into place (wall plate not included).

Telephone Operation

Redial

This unit redials up to 32 digits. To automatically redial the last number you called:

1. Pick up the handset and wait for a dial tone.

2. Press the redial button.

Flash

Press the ash button to activate custom calling services such as call waiting or

call transfer. Custom calling services are provided by the phone company.

Receiver Volume

You may control the listening level with the volume switch on the bottom of the

handset. It has 3 levels: lo, mid, and high.

Ringer Volume

You may control the ringer volume level with the switch located above the touch

tone pad on the handset.

= ringer tone will be loud

= ringer tone will be low

= telephone will not ring

Troubleshooting Tips

No dial tone.

• Press and release the hook switch. Check the hook switch: Does it fully

extend when the handset is lifted from the cradle?

Phone doesn’t ring.

• Make sure RINGER switch (located on the handset) is set to loud or low.

• Are you using too many phones on one line? (The total REN of all phones on

the same line should not be greater than the maximum REN for your calling

area. See Equipment Approval Information).

Other party cannot hear you.

• Make sure phone cord is securely plugged in.

• Make sure extension phones are on the hook at the same time you’re using

the phone. It is normal for the volume to drop when additional extension

phones are used at the same time.

Phone “howls” when handset is placed near the base and handset volume

level is too high.

• This is normal feedback due to handset volume level being set to maximum.

General Product Care

To keep your telephone working and looking good, follow these guidelines:

• Avoid putting the phone near heating appliances and devices that generate

electrical noise (for example, motors or uorescent lamps).

• DO NOT expose to direct sunlight or moisture.

• Avoid dropping and other rough treatment to the phone.

• Clean with a soft cloth.

• Never use a strong cleaning agent or abrasive powder because this will

damage the nish.

• Retain the original packaging in case you need to ship the phone at a later

date.

One-year limited warranty

IMPORTANT: Evidence of original purchase is required for warranty service.

WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”) ELEMENTS OF

WARRANTY: Uniden warrants, for one year, to the original retail owner, this

Uniden Product to be free from defects in materials and craftsmanship with

only the limitations or exclusions set out below.

WARRANTY DURATION: This warranty to the original user shall terminate

and be of no further eect 12 months after the date of original retail sale.

The warranty is invalid if the Product is (A) damaged or not maintained

as reasonable or necessary, (B) modied, altered, or used as part of any

conversion kits, subassemblies, or any congurations not sold by Uniden,

(C) improperly installed, (D) serviced or repaired by someone other than an

authorized Uniden service center for a defect or malfunction covered by this

warranty, (E) used in any conjunction with equipment or parts or as part of

any system not manufactured by Uniden, or (F) installed or programmed by

anyone other than as detailed by the owner’s manual for this product.

STATEMENT OF REMEDY: In the event that the product does not conform

to this warranty at any time while this warranty is in eect, warrantor will

either, at its option, repair or replace the defective unit and return it to you

without charge for parts, service, or any other cost (except shipping and

handling) incurred by warrantor or its representatives in connection with

the performance of this warranty. Warrantor, at its option, may replace the

unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH

ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT

AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE

WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION

OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY

DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF

INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this

exclusion or limitation of incidental or consequential damages so the above

limitation or exclusion may not apply to you.

LEGAL REMEDIES: This warranty gives you specic legal rights, and you may

also have other rights which vary from state to state. This warranty is void

outside the United States of America and Canada.

PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after

following the instructions in the owner’s manual you are certain that the

Product is defective, pack the Product carefully (preferably in its original

packaging). The Product should include all parts and accessories originally

packaged with the Product. Include evidence of original purchase and a note

describing the defect that has caused you to return it. The Product should be

shipped freight prepaid, by traceable means, to warrantor at:

Uniden America Service

4700 Amon Carter Blvd.

Fort Worth, TX 76155

Uniden America Corporation

Ft. Worth, TX

Touche

redial

Commande

de volume

de sonnerie

Touche

ash

Commande

de volume

de l’écouteur

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Uniden 1100 Telefoon. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Uniden. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Uniden 1100 Telefoon in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Uniden Telefoons
Meer handleidingen voor Telefoons

Beoordeling

Gerelateerde producten

Handleiding

Uniden 1260 Telefoon

Handleiding

Uniden DECT 1588 Telefoon

Handleiding

Uniden SS E17+1 Telefoon

Handleiding

Uniden DECT 2188 Telefoon

Handleiding

Uniden 1360BK Telefoon

Handleiding

Uniden 1380BK Telefoon

Handleiding

Uniden CEZ260 Telefoon

Handleiding

Uniden D1788 Telefoon

Gerelateerde categorieën