Handleiding Westinghouse 6338800 Lamp

Handleiding

Mini-Pendant Kit

Installation and Safety Instructions

Warning: Be sure the electricity to the wires you are working on is shut off; either the fuse is removed

or the circuit breaker is shut off.

GENERAL

You don't need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should

a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type

heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.

INSTALLATION

Important: Do not attach fixture directly to outlet box.

Step 1: Thread mounting screw (A) into the matching hole of mounting bar (B).

Step 2: Secure the mounting bar (B) to outlet box with outlet box screws (C) (not provided).

ADJUSTING LENGTH OF CORD IF NEEDED

These steps should only be performed by someone familiar with working with electrical wiring. Care must be taken when adjust-

ing the length of the cord to ensure insulation on internal wires is not damaged. If not familiar with these steps, seek the aid of a

qualified electrician.

Step 1: Loosen the screw in strain relief (Q) until cord slides easily, being careful not to completely remove screw.

Slide canopy down cord until the fixture is the desired distance below the canopy. Tighten the screw in the strain

relief until cord does not slide.

Step 2: Cut excess cord approximately six to seven inches (6”-7”) above canopy.

Step 3: Leaving at least one inch (1”) of outer insulation above the canopy, carefully cut through outer insulation of cord,

being careful not to damage inner insulation. Remove outer insulation. Strip inner insulation from end of both

wires, leaving approximately 1/2 inch of wire exposed.

Step 4: For cords without differently colored inner insulation, identify the tracer lines on the new ends of the inner wires

to match the labels on the original ends and connect to house wiring as described in the appropriate step listed

below in the Grounding and Wiring Instructions section.

GROUNDING AND WIRING INSTRUCTIONS

Step 1: Insert the green grounding screw (G) into the hole with two raised dimples on the mounting bar (B). Wrap the bare

grounding wire (F) from the fixture canopy (D) around the green grounding screw's stem (G) on the mounting bar (B)

leaving enough excess wire.

Step 2: Connect the green grounding wire (H) from hanging cord and excess grounding wire (F) from the fixture canopy (D)

with the grounding wire (I) from outlet box by using a wire connector (P), then wrap the wire connector (P) with

electrical tape for a more secure connection. WARNING: Never connect grounding wire to black or white power

supply wires.

Step 3: Connect the black house wire with the black wire from the fixture by wire connector (P), and wrap the wire connector

(P) with electrical tape for a more secure connection.

Step 4: Con

nect the white house wire with the white wire from the fixture by wire connector

(P)

, and wrap th

e wire connector

(P) with electrical tape for a more secure connection.

Note: Try to gently pull the wire connectors (P) off of the wires. If you can pull the connector off, carefully repeat steps

2, 3 and 4 above, and check again for a firm connection. Make sure no bare wires can be seen protruding outside of

the wire connectors.

Step 5: Tighten green grounding screw (G). Do not over tighten.

FINAL ASSEMBLY

Step 1: After wires are connected, tuck them carefully inside outlet box. Raise canopy (D) allowing the

mounting screw (A) to protrude through the hole in the canopy (D), and secure with ball nut (E).

***For shade with a closed bottom, please follow below instruction (see figure 1):

Step 2a: Take off the retaining ring (L) from the socket (J). Install adaptor (M) to socket (J) with retaining ring (L) (if applicable).

Step 3a: Install lamp (not included). (Please do not exceed the maximum lamp wattage recommended on the socket).

Step 4a: Install the shade (Ka) to adaptor (M) and secure it by using thumb screws (N).

Step 5a: Turn on the switch (O) on the socket (if applicable).

***For shade with open bottom, please follow below instruction (see figure 2):

Step 2b: Take off the retaining ring (L) from the socket (J). Secure the adaptor (M) onto the shade (Kb) with thumb screw(s) (N)

(if applicable).

Step 3b: Install the shade (Kb) and adaptor (M) assembly onto the socket (J) and secure the retaining ring (L).

Step 4b: Install lamp (not included). (Please do not exceed the maximum lamp wattage recommended on the socket).

Step 5b: Turn on the switch (O) on the socket (if applicable).

CLEANING

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or

powders, steel wool or abrasive paper.

Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.

www.westinghouselighting.com

, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF

are trademarks of Westinghouse Electric Corporation.

Used under license by Westinghouse Lighting.

All rights reserved.

Made in China

W-562

062818

*NOT SUPPLIED

*NOT SUPPLIED

P

B

H

Q

G

I

A

*C

F

D

E

M

N

L

Ka

J

O

B

H

Q

G

P

I

A

*C

F

D

E

J

O

L

Kb

M

N

FIGURE 1.

FIGURE 2.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Westinghouse 6338800 Lamp. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Westinghouse. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Westinghouse 6338800 Lamp in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Westinghouse Lampen
Meer handleidingen voor Lampen

Veelgestelde vragen over Westinghouse 6338800 Lamp

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Westinghouse 6339540 Lamp

Handleiding

Westinghouse 6106640 Lamp

Handleiding

Westinghouse 6581540 Lamp

Handleiding

Westinghouse 6372740 Lamp

Handleiding

Westinghouse 6308840 Lamp

Handleiding

Westinghouse 6400940 Lamp

Handleiding

Westinghouse 6331240 Lamp

Handleiding

Westinghouse 6371940 Lamp

Gerelateerde categorieën