OPERATOR’S MANUAL
www.zebralight.com
QUICK START
This light has 3 main levels (High, Medium, and Low) and a beacon-strobe
mode.
z When the light is Off:
One short-click turns on the light to High.
Two short-clicks turn on the light to Medium.
Three short-clicks turn on the light to the beacon-strobe mode.
Press-and-hold (for over 0.6 seconds) turns on the light to Low and
then Medium and High. Release at the desired level.
z When the light is On, a short-click turns off the light.
IMPORTANT SAFETY INSTRUCTIONS
z To reduce the risk of injury, close supervision is necessary when the product
is used near children.
z To reduce the risk of electrical shock, do not expose battery or internal
flashlight components to water or other liquids.
z Use only recommended batteries.
z Remove batteries from flashlight before performing any routine maintenance
or cleaning.
z Do not disassemble the flashlight. The LED cannot be replaced.
z Do not operate flashlight near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes.
z Do not permit children to use flashlight unsupervised.
z Do not expose battery or internal flashlight components to rain.
z Under extreme usage or temperature conditions, battery leakage may occur.
If liquid comes in contact with your skin, wash immediately with soap and
water. If liquid gets in your eyes, flush them with clean water for at least 10
minutes, then seek immediate medical attention.
z Do not crush, drop or damage batteries. Do not use batteries that have been
dropped or received a sharp blow. A damaged battery is subject to explosion.
Use a damaged battery can result in serious personal injury.
z Save these instructions. Refer to them frequently and use them to instruct
others who may use this product.
ADVANCED OPERATION
z To use another sub-level
For each of the three main levels (High, Medium and Low), there are two
corresponding sub-levels (H1 and H2, M1 and M2, L1 and L2).
1. Go to a main level with short-clicks or press-and-hold
2. Double-click to toggle between the two sub-levels (i.e. between
H1 and H2, M1 and M2, or L1 and L2)
The last sub-levels used in each main level are memorized and will come
back on when you go back to that main level. Sub-level settings are
memorized when the light is turned off and through battery changes.
z Programming the second sub-level
The first sub-levels (H1, M1, and L1) of each main level have fixed (none
configurable) brightness. The second sub-levels (H2, M2 and L2) can be
further programmed to different brightness levels.
1. Go to a main level with short-clicks or press-and-hold
2. Double-click 6 times to enter the programming mode for that main
level
3. On subsequent double-clicks the light will cycle through different
brightness levels.
4. When you have the choice you want, exit the programming mode
by performing a short-click.
Second sub-level settings are memorized when the light is turned off and
through the battery changes.
z Changing levels after the light is On
When the light is On, press-and-hold to cycle through Low, Medium and
High. Release at the desired level. Note that the light always cycle from Low
regardless which level you are currently in.
z Beacons and Strobes
The beacon-strobe mode can be accessed from 3 short-clicks when the light
is Off. Once in the beacon-strobe mode, you can double-click to cycle
through different types of beacons and strobes. Beacon-strobe settings are
memorized when the light is turned off and through battery changes.
z Battery Indicator
This light uses the main LED (flashing 1 to 4 times) to indicate the estimated
remaining capacity of the batteries. To start the battery indicator, short-click
4 times without pause.
Please refer to www.zebralight.com for information specific to this product.
WARRANTY
ZebraLight, Inc. warrants its products to be free from defects in materials and
workmanship. We will repair or replace, at our option, without charge, any
products or parts which is found to be defective under normal use and service
within 12 months from the date of purchase with proof of purchase. Such repair
or replacement shall be the purchaser's sole and exclusive remedy under this
warranty. This warranty does not cover normal maintenance and service and
does not apply to any products or parts which have been subject to
modification, misuse, abuse, negligence, accident, or improper maintenance or
repair by anyone other than ZebraLight.
Our guarantee is unconditional. If any purchase fails to meet your complete
satisfaction, for any reason, you may return it or exchange it within 30 days of
receipt of your shipment. Before returning any product, you MUST obtain a
Return Merchandise Authorization number (RMA) from a customer service
representative. Include the original invoice received with the merchandise and
send the package prepaid, via UPS or insured USPS Mail to:
ZebraLight, Inc.
Attention: Warranty/Repair Department
2908 Story Road W
Irving, TX 75038
U.S.A.
ZebraLight flashlight and headlamp products are designed and engineered in
the U.S. and manufactured in China. The distinctive shapes and styles of all
ZebraLight products are trademarks of ZebraLight, Inc. U.S. and international
patents are pending.
Praat mee over dit product
Laat hier weten wat jij vindt van de ZebraLight SC5c Mk II Zaklamp. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.