Handleiding PC Line DX-10 Papiervernietiger

Handleiding

22

1

PAPER SHREDDER

INSTRUCTION MANUAL

IMPORTANT SAFETY NOTES

INSTALLATION:

- Place the waste bin upright on a stable, level surface.

- Place the shredder mechanism onto the waste bin.

- Make sure the slide switch (fig.1) is in position "ON/AUTO" and then plug

the machine into the mains supply.

- The socket-outlet shall be installed near the equipment and shall be

easily accessible.

The mains connection at the machine must be freely

accessible!

APPLICATION:

The document shredder

The unit should only be fed with paper! Shredding other types of

materials can cause injuries (e.g. by splinters of hard materials) or

may damage the shredder (e.g. destruction of the cutting system).

is a machine for the destruction of common written

material.

2

FEEDING THE PAPER:

- Move the slide switch (fig.1) to position "ON/AUTO".

- Feed paper through the inlet guide to the cutting system.

Machine switches automatically to forward and draws

paper in the machine. It switches off automatically after shredding.

-

PAPER JAM: If too much paper is fed to the shredder the cutting system will jam.

Proceed as follows:

- Move the slide switch (fig.1) to position "REV"

- Cutting system runs in reverse and frees excess paper.

- Carefully remove the paper to clear the opening.

- Move the slide switch to "FWD" to clear any paper left in the cutting system.

MOTOR PROTECTION:

The motor will shut down automatically, should it become overloaded. Unplug the

machine and allow the motor to cool down to room temperature before resuming

operation.

CHECKLIST IN CASE OF MALFUNCTION:

If the device does not function, check the following:

- Is the plug connected to the mains?

- Is there a paper jam? ---Follow the instructions under "PAPER JAM".

- Has the motor been overloaded? ---Wait until the motor has cooled, and then restart.

- Is the waste bin full?---switch off and then empty the waste bin.

If none of the above applies, contact your dealer.

MALFUNCTION / MAINTENANCE

TECHNICAL DATA

Cutting width: 7 mm (strips cut)

2

Cutting capacity: 5 sheets of 80g/m A4 paper

Supply voltage: 230~240V~50Hz

Rated current: 0.8A

Maximum continuous operation: 2 min

Never feed the shredder with a quantity of paper exceeding the

maximum indicated under "TECHNICAL DATA". Should the machine

be overfed, follow the instructions under "PAPER JAM".

OPERATION

Fig. 1

Fig. 2

Model: DX - 10

The machine cannot be operated by more than one person at

any given time! The machine was designed for safe operation

by "one person only".

During the shredding process no other work may be performed

on the machine (for example cleaning, etc).

Keep children away from the machine. This machine's design

and safety concept are based on adult dimensions to ensure

that it can be operated safely by adults only.

Repairs must be executed by a qualified service personnel.

Keep all loose articles of clothing, ties,

jewelry, long hair or other loose objects

away from opening. Injury may result!

Never insert fingers into opening. Serious injury may result!

In case of danger unplug the machine.

Always unplug the machine from the mains power supply

before opening the machine.

INITIATION

1

This symbol on the product or in the instructions means

that your electrical and electronic equipment should be

disposed at the end of life separately from your household

waste. There are separate collection systems for recycling

in the EU. For more information,please contact the local

authority or your retailer where you purchased the product.

ON/AUTO

REV

FW D

EXPLANATION OF THE CONTROLS

1= Slide switch (fig.1) (ON/AUTO/FWD/REV)

"ON/ " ---machine is ready for operation.

AUTO

"FWD" ---cutting blades are running forward.

"REV" ---cutting blades are reversing.

2= Sensor (forward run) (fig.2)

The shredding operation is started as soon as

a sheet of paper passes through the feed slot.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je PC Line DX-10 Papiervernietiger. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met PC Line. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van PC Line DX-10 Papiervernietiger in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor PC Line Papiervernietigers
Meer handleidingen voor Papiervernietigers

Veelgestelde vragen over PC Line DX-10 Papiervernietiger

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

PC Line SM10 Papiervernietiger

Handleiding

PC Line DX-20 Papiervernietiger

Handleiding

PC Line DX-5 Papiervernietiger

Handleiding

Royal Sovereign RDS-21C10 Papiervernietiger

Handleiding

United Office IAN 365280 Papiervernietiger

Handleiding

United Office IAN 375639 Papiervernietiger

Handleiding

Bonsaii C266-B Papiervernietiger

Handleiding

Iwata SHRED-X PRO Papiervernietiger

Gerelateerde categorieën