Handleiding Bauknecht BBI9P8HT2SK Oven

Handleiding

• Tap “PAUSE” if you want to pause the timer. You can

then tap “RESUME” to restart the timer.

• Tap “CANCEL” to cancel the timer or set a new

timer duration.

• Tap “+1 min” to increase the duration of 1 minute.

LIGHT

To switch on or off the oven lamp.

STEAM CLEAN

The action of water vapor released during this special

cycle of cleaning by means of a low temperature,

facilitates removal of grime. Activate the function

when the oven is cold.

FAST DRY

After a pure steam cycle, the oven will automatically

suggest to start the fast dry cycle to help to remove

the moisture from the cavity, which at least does not

compromise the correct functioning of the appliance.

Follow the instructions on the display. Clean the drip

tray below the door with a soft cloth of absorbent

paper to remove the water drops.

DESCALE

This special function, activated at regular intervals,

allows you to keep the steam system in the best

condition. Once the function is started, follow all the

steps indicated on the display. The average duration

of the full function is around 140 minutes.

Descale can be initiated anytime by the user from the

Cleaning Menu.

The display will show you when it is time to run a

Descale cycle (see the table below).

DESCALE MESSAGE MEANING

<DESCALE RECOMMENDED>

It appears after around 15

hours of steam cycles*

It is recommended to run a

Descale cycle.

<DESCALE NEEDED>

It appears after around 20

hours of steam cycles*

Descale is mandatory. It is not

possible to run a Steam cycle

until a Descale cycle will be

carried out.

*considering the default value (4 - Hard) of water

hardness level. The number of hours of steam cycles

that must pass before the Decale messages are shown

depends on the water hardness level set on the

appliance.

The descaling procedure can also be performed

whenever the user desires a deeper cleaning of the

internal steam circuit.

Before to run the descaling phase, the appliance will

check if some residual water is contained into the

boiler, and a Drain cycle could be performed, if

needed. In this case, you will have to empty the

drawer after the Drain cycle, before continuing with

the Descale Phase.

Please note: to ensure that the water is cold, it is not

possible to perform this activity before 30 minutes have

elapsed from the last cycle (or the last time the product

was powered). During this waiting time, the display will

show the following feedback “WATER IS HOT”.

» PHASE 1/2: DESCALING (70 MIN)

When display will show <ADD 0.25 L OF SOLUTION>,

please pour the descaling solution in the drawer. For

best results in descaling, we recommend filling the

tank with a solution composed of 75 g of the specific

WPRO product and 250 ml of drinking water. WPRO

descaler is the suggested professional product for the

maintenance of the best performance of your steam

function in the oven. For orders and information

contact the after sales service or www .bauknecht. eu.

Bauknecht will not be held responsible for any

damage caused by the use of other cleaning products

available on the market.

1+

= 75 g

+2

250 ml

3

Once the descaling solution is poured inside the

drawer, press to start the main descaling process.

The descaling phases do not need you to stay in front

of the appliance. After each phase is completed, an

acoustical feedback will be played and the display

will show instructions to proceed with the next

phase.

Once the descaling phase has been completed, the

boiler will be drained: the descaling solution used

during this phase will be poured into the extractable

drawer.

» PHASE 2/2: RINSING (30 MIN.)

To remove descale residuals from the drawer and

the steam circuit, rinse cycle has to be done. When

display shows <ADD 0.25 L OF WATER> fill the tank

with 0,25 L of drinking water, then press to start

the rinsing. Do not turn off the oven until all the steps

required by the function have been completed.

Please note: if needed from the system, it could be

requested to emty the drawer and to repeat this

operation.

When Descale procedure is completed, it is suggested

to dry the cavity from potential water residuals. It will

be then possible to use all the steam functions.

Please note: during the Descale cycle, some noise

could potentially be heard since the oven pumps are

activated in order to guarantee the optimal descale

efficiency.

Once the maintenance cycle has started, do not remove

the drawer unless requested by the appliance.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Bauknecht BBI9P8HT2SK Oven. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Bauknecht. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Bauknecht BBI9P8HT2SK Oven in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Bauknecht Ovens
Meer handleidingen voor Ovens

Veelgestelde vragen over Bauknecht BBI9P8HT2SK Oven

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Bauknecht HIS5 EP8VS3 ES Oven

Handleiding

Bauknecht ESN 3460/01 BR Oven

Handleiding

Bauknecht ESZB 5463 IN Oven

Handleiding

Bauknecht ESZ 4466/01 IN Oven

Handleiding

Bauknecht HVR2 NN5F IN Oven

Handleiding

Bauknecht ESN 5860 IN Oven

Handleiding

Bauknecht ESZP 5460 WS Oven

Handleiding

Bauknecht ESN 4467 SW Oven

Gerelateerde categorieën