Handleiding Bimar VP438A Ventilator

Handleiding



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Bimar (Italy).

The pages must be reproduced and folded in order to obtain

a booklet A5 (+/- 148.5 mm width x 210 mm height). When

folding, make sure you keep the good numbering when you

turn the pages of the I/B. Don’t change the page numbering.

Keep the language integrity.

8

/

24

Assembly page 8/24

Fax +32 030 9904733

•

D

o not use the device at room temperatures above 40 °C.

•

D

o not move the appliance when it is in function.

•

D

o not leave the device exposed to the weather (sun, rain, etc.).

•

D

o not pull on the cord to disconnect the plug from the socket.

•

I

f the supply cord is damaged, it must be replaced by the manufactuer, its service agent or similarly

qualified persons in order to avoid a hazard.

INSTALLATION

• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not use

it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails,

etc.) must be kept out the reach of children because they are potential sources of danger. Attention:

any stickers or advertising material applied to the grid removed before using the appliance. The

manufacturer declines all responsibility in case this is not safe working practices will be respected.

• Before connecting the appliance, check that the voltage values shown on the data plate (220-240V~

50Hz) correspond to those of the electricity supply network. In the event of incompatibility between

the electric outlet and the plug of the appliance, have the outlet replaced with another more suitable

type by professionally qualified personnel, who will make sure that the section of the wires of the

outlet is appropriate for the absorbed power of the heater. In general, the use of adapters or extension

cords is not recommended; if their use is indispensable, they must conform to existing safety standards

and their current capacity (amperes) must not be less that the maximum of the appliance.

• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.

• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to

avoid the risk of it falling in.

• Do not place the appliance near an open flame, cooking or other heating appliance.

• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air

intake grille; make sure that the front is free of unstable materials (dust, etc.).

•

T

he appliance must not be used in dusty environments or in the presence of extremely volatile

materials which could obstruct grid or of inflammable products.

• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or

wrapped around the appliance.

• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance

could upset).

• Do not use the appliance with a timer or a programmer or with a system that can switch on the

appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or

positioned incorrectly.

• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance

could upset).

• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally

qualified help: repairs made by unqualified persons can be dangerous and render void the warranty.

ASSEMBLY

Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power

cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person

with similar qualifications, in order to avoid any risk.

If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly,

refer to figure.

Attention: the fan can be used only when completely and correctly assembled, that is complete with its

base and protection grid.

Attention: always unplug the appliance before you assemble.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Bimar VP438A Ventilator. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Bimar. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Bimar VP438A Ventilator in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Bimar Ventilatoren
Meer handleidingen voor Ventilatoren

Veelgestelde vragen over Bimar VP438A Ventilator

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Bimar VT25 Ventilator

Handleiding

Bimar VT11 Ventilator

Handleiding

Bimar VC82 Ventilator

Handleiding

Bimar VC90A.NE Ventilator

Handleiding

Bimar VT45 Ventilator

Handleiding

Bimar VS58 Ventilator

Handleiding

Bimar VT35 Ventilator

Handleiding

Orbegozo HF 2500 Ventilator

Gerelateerde categorieën