Handleiding Black and Decker WD9610 Kruimeldief

Handleiding

6

ENGLISH

(Original instructions)

u Insert the charger cord into the curved slot in the wall

mount bracket leaving approximately 8-9 inches excess.

u Hang the appliance on the wall by placing the opening

on the base of the vac over the hooks in the wall mount

bracket.

Assembly

Accessories (g .B)

These models may be supplied with some of the following

accessories:

u A squeege tool (12) for wet use on hard surfaces.

(WD4810N, WD7210N and WD9610N Only)

u A powered brush head (13) for vacuuming on cut pile

carpeting. The brush head is particularly useful for picking

up hair, threads, etc. (DV9610PN Only)

Fitting (Fig. D)

u Insert the appropriate accessory into the front of the appli-

ance. Make sure that the accessory is pushed fully in.

Use

u Before rst use, the battery must be charged for at least

24 hours.

u Place the appliance on the charging base whenever it is

not in use. (WD4810N, WD7210N and WD9610N Only)

Warning! Before charging, be sure to empty all liquid contents

and dry thoroughly, to avoid damage to your appliance.

Charging the battery (Fig. E & F)

u Make sure that the appliance is switched off. The battery

will not be charged with the on/off switch in the on posi-

tion.

u Plug the jack plug of the charger (6) into the charging

socket (4) of the appliance (Fig. E). (DV4800N and

DV9610PN Only)

u Place the appliance on the charging base (7) (Fig. F).

(WD4810N, WD7210N and WD9610N Only)

u Plug in the charger. Switch on at the mains. The charging

indicator (3) will be lit.

u Leave the appliance to charge for at least 16 hours.

While charging, the charger may become warm. This is

normal and does not indicate a problem. The appliance can

be left connected to the charger indenitely. The charging

indicator (3) will be lit as long as the appliance is connected to

the plugged-in charger.

Warning! Do not charge the battery at ambient temperatures

below 4 °C or above 40 °C.

Switching on and off (g. G)

u To switch the appliance on, slide the on/off switch (1)

forward to position 1.

u To switch the appliance off, slide the on/off switch (1) back

to position 0.

Dry pick up (DV4800N, DV9610PN)

u For everyday spills of dry material.

Wet and dry pick up (WD4810N, WD7210N and

WD9610N Only)

u For everyday spills of dry material, use your appliance

without the squeegee accessory.

Warning! Your product is designed for light spills only.

u This appliance can also be used to pick up everyday liquid

spills. Use the squeegee accessory on non-absorbent,

hard surfaces. On absorbent surfaces, such as carpet,

your appliance will pick up wet spills better without the

accessory.

u For best performance on hard surface wet pickups, insert

squeegee into the bowl nozzle opening.

u For best results when using this accessory, hold the appli-

ance at an angle of 45° and pull it slowly towards you.

u Do not ll the bowl beyond the end of the intake chute. If

there is any liquid in the bowl, do not turn the unit upside

down, sideways, point the nozzle upward, or shake the

vac excessively.

u After picking up liquid substances clean the appliance and

lter immediately. Mold and mildew may form if the unit is

not properly cleaned after wet pickups.

u Before charging, be sure to empty all liquid contents and

dry thoroughly, to avoid damage to your appliance.

Optimising the suction force

In order to keep the suction force optimised, the lters must be

cleared regularly during use.

Emptying and cleaning the product.

Removing the dust bowl and lters (g. H, I, J & K).

Warning! The lters are re-usable and should be cleaned

regularly.

u Press the release latch (2) and pull the dust bowl (5)

straight off.

u While holding the dust bowl over a bin or sink, pull out the

lter to empty the contents of the bowl.

u To replace the dust bowl, place it back onto the handle

until it “clicks” rmly into position.

Warning! Never use the appliance without the lters. Opti-

mum dust collection will only be achieved with clean lters.

Foam insert (g. J) (WD4810N, WD7210N and

WD9610N)

u Place the foam insert (10) into the centre of the wet/dry

deector (11).

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Black and Decker WD9610 Kruimeldief. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Black and Decker. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Black and Decker WD9610 Kruimeldief in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Black and Decker Kruimeldieven
Meer handleidingen voor Kruimeldieven

Veelgestelde vragen over Black and Decker WD9610 Kruimeldief

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Black and Decker NVB215W-RGGB Kruimeldief

Handleiding

Black and Decker HC432 Kruimeldief

Handleiding

Black and Decker PD1800EL Kruimeldief

Handleiding

Black and Decker DV1810EL Kruimeldief

Handleiding

Black and Decker CHV9610 Dustbuster Kruimeldief

Handleiding

Black and Decker PV1200AV Kruimeldief

Handleiding

Black and Decker BDCDB18N Kruimeldief

Handleiding

Black and Decker DV1610 Kruimeldief

Gerelateerde categorieën