Handleiding Casio Edifice EFR-549D-1A2VUEF Horloge

Handleiding

1

Operation Guide 5226

MA1101-EA

Your watch may differ somewhat from the one shown in the illustration. •

4(5



Day

Stopwatch second hand

Crown

(Normal position)

First click

(Day, day of week setting)

Second click

(Time setting)

Day of week

Second hand

Minute hand

Stopwatch minute handHour hand

Stopwatch hour hand

To set the time

When the second hand is at 12 o’clock, pull out the crown to the second click 1.

to stop it.

Set the hands by rotating the crown. Move the minute hand four or five minutes 2.

past the setting you want, and then back them up to the setting.

Push the crown back in on a time signal to resume timekeeping.3.

To set the day and day of the week

Avoid setting the day and day of the week between 9:00 p.m. and 6:00 a.m. The •

day and day of the week may not change in the following day if you do.

Pull out the crown to the first click.1.

Set the day by rotating the crown counterclockwise.2.

Set the day of the week by rotating the crown clockwise.3.

Push the crown back in to its normal position.4.

Using the Stopwatch

The stopwatch lets you measure elapsed time up to 11 hours, 59 minutes,

59 seconds.

The illustration shows a time of 2 hours, 20 minutes, 40 seconds. •

Do not try to perform stopwatch operations while the crown is pulled out either •

to the first or second click. If you try to press a button, you might accidentally

cause the crown to rotate and change the current time or day setting.

Once started, stopwatch timing continues until you press • A to stop it and even

if timing reaches the stopwatch limit defined above.

To measure elapsed time

Press 1. A to start the stopwatch.

Press 2. A to stop the stopwatch.

You can resume the measurement operation by pressing • A again.

Press 3. B to reset the stopwatch.

Adjusting the Stopwatch Hands Position

Use of the stopwatch can cause the starting positions of the stopwatch hour

hand, minute hand and second hand to become misaligned. Use the following

procedures to check hand alignment and to adjust the positions of the hands so

they point to 12 o’clock when the stopwatch is reset.

To adjust the positions of the stopwatch hands

Press 1. B to reset the stopwatch, and check the alignment of the stopwatch

hour hand, minute hand and second hand.

Pull out the crown to the second click.2.

Press 3. A to move the stopwatch second hand forward until it points to

12 o’clock.

If the stopwatch minute hand is aligned correctly, proceed to step 5. If the 4.

stopwatch hour hand and stopwatch minute hand are also misaligned, press B

so the stopwatch hour hand and the stopwatch minute hand jump to 12 (60).

After making the adjustments you want, push the crown back in to its normal 5.

position.

Note that pulling the crown out also stops the timekeeping second hand. After •

performing the above procedure, you should also adjust the timekeeping setting.

For a watch with an elapsed time bezel ■

Rotate the elapsed time bezel to align the

mark with the

minute hand.

After certain amount of time elapsed, read the graduation on

the elapsed time bezel which the minute hand points to.

The elapsed time is indicated.

Elapsed time bezel

Some water resistant models are equipped with a screw •

lock crown.

With such models, you must unscrew the crown in the •

direction noted in the illustration to loosen it before you can

pull it out. Do not pull too forcibly on such crowns.

Also note that such watches are not water resistant while •

their crowns are loosened. Be sure to screw the crowns

back in as far as they will go after making any setting.

Specifications

Accuracy at normal temperature: ± 20 seconds a month

Display: 3 analog hands (timekeeping hour and minutes, stopwatch seconds),

3 dials (timekeeping seconds, stopwatch hours and minutes), day, day of the

week

Stopwatch function: Measuring capacity: 11:59'59"

Measuring unit: 1 second

Measuring modes: Elapsed time

Battery: One silver oxide battery (Type: SR927W)

Approximately 5 years on type SR927W (assuming one stopwatch operation 60 min./day)

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Casio Edifice EFR-549D-1A2VUEF Horloge. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Casio. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Casio Edifice EFR-549D-1A2VUEF Horloge in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Casio Horloges
Meer handleidingen voor Horloges

Veelgestelde vragen over Casio Edifice EFR-549D-1A2VUEF Horloge

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.