Handleiding Clarke CI800 Stroomomvormer

Handleiding voor je Clarke CI800 Stroomomvormer nodig? Hieronder kun je de handleiding gratis bekijken en downloaden als PDF in het Nederlands en/of Engels. Dit product heeft 0 veelgestelde vragen, 0 comments en heeft 0 stemmen. Is dit niet de handleiding die je zoekt, neem dan contact met ons op.

Is je product kapot en biedt de handleiding geen oplossing meer? Dan kun je voor reparatie gratis terecht bij Repair Café.

Handleiding

Loading…

Safety Precautions
WARNING:
To ensure reliable service from your power inverter, you must ensure it is installed
and used according to these operator instructions, please read these instructions
thoroughly before attempting to use the inverter.
Pay particular attention to the WARNING and CAUTION statements in this manual.
CAUTION statements advise against certain conditions and practises that could result
in damage to your inverter.
WARNING statements identify conditions or practises that could result in personal
injury.
CAUTIONS
1. DO NOT use with positive earth systems (the majority of modern vehicles’s, lorries, boats
etc., are negative earth). Reverse polarity connection will result in a blown fuse and
may cause permanent damage to the inverter.
2. This inverter will not operate high wattage appliances.
3. DO NOT use if it is wet.
4. DO NOT install inside the engine compartment - inverter MUST be installed in a well
ventilated area.
5. This inverter is not tested for use with medical devices.
WARNINGS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY:
1. DO NOT connect to an AC supply.
2. Before making adjustment etc., to the appliance being run by the inverter, ALWAYS
disconnect the appliance from the inverter beforehand.
3. DO NOT make or break any electrical connections in explosive areas such as garage
forecourts etc. This applies to all types of connection including cigarette lighter type
plugs.
IMPORTANT CABLE INFORMATION
Attention must be paid to the cable used between the appliance and the inverter. It must
be of the correct diameter and length, otherwise power loss or reduced operating time
may occur.
Marine installations are also subjected to vibration and stresses that exceed those of other
mobile installations. Therefore ensure all connections are tight, water resistant and have
suitable strain relief for DC cables etc.
Cable installation must be the correct type for the environment.
-3-
6. PROTECTION FEATURES OF INVERTER
Your inverter monitors the following potentially hazardous conditions:
Low Battery Voltage - This condition is not harmful to the inverter but could damage the
power source. An audible alarm will sound when input voltage drops to 10.5 volts. The
inverter automatically shuts down when input voltage drops to 10.0 volts. When the
condition is rectified, the unit may be restarted.
Over Voltage Protection - The inverter will automatically shut down when the input
voltage exceeds 15 volts DC.
Short Circuit Protection - The inverter will shut down. Remove the short circuit and inverter
will auto reset.
Overload Protection - The inverter will automatically shut down when the continuous
draw exceeds the specified watts.
Thermal Overload Protection - When the temperature sensor reaches 65
O
C (150
O
F),
the unit will automatically shut down. Allow the unit to cool for at least 15 minutes before
attempting to restart. Unplug unit while cooling.
Low Battery Alarm - An alarm will sound when the voltage from the battery drops to
10.5 volts. The user should stop operation of the appliance at this time since the inverter
will shut down automatically shortly thereafter, when the battery voltage drops to 10 volts.
Start your engine to recharge the battery.
If the low voltage alarm sounds when the battery is fully charged, follow the steps for
solving lack of output power in the Troubleshooting Guide.
The alarm will sound when the inverter is overloaded, in thermal shutdown, or if there is an
excessive voltage drop between the battery and inverter.
7. COMMON PROBLEMS
Buzzing” sound in audio systems:
Some inexpensive stereo systems and ‘boom boxes’ emit a buzzing sound from their
speakers when operated from the inverter. This occurs because the power supply in the
electronic device does not adequately filter the modified sine wave produced by the
inverter. The only solution to this problem is to use a higher quality sound system that
incorporates a higher quality power amplified supply.
Television Interference:
The inverter is shielded to minimize interference with TV signals. However, in some instances,
some interference may still be visible, particularly with weak TV signals. Try the following
corrective measures:
-8-
Position the inverter as far as possible from the television, the antenna and the
antenna cables. Use an extension cable, if necessary
Adjust the orientation of the inverter, the antenna cables and the TV power cord
to minimize interference
Make sure that the antenna feeding the television provides an adequate (“snow
free) signal and that high quality, shielded antenna cable is used.
Download de handleiding in het Nederlands en/of Engels (PDF, 1.9 MB)
(Denk aan het milieu en print deze handleiding alleen als dat echt noodzakelijk is)

Loading…

Beoordeling

Laat ons weten wat je van de Clarke CI800 Stroomomvormer vindt door een beoordeling achter te laten. Wil je je ervaringen met dit product delen of een vraag stellen? Laat dan een bericht achter onderaan de pagina.
Bent u tevreden over de Clarke CI800 Stroomomvormer?
Ja Nee
Beoordeel dit product als eerste
0 stemmen

Praat mee over dit product

Laat hier weten wat jij vindt van de Clarke CI800 Stroomomvormer. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Clarke CI800 Stroomomvormer. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Clarke. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Clarke CI800 Stroomomvormer in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Merk Clarke
Model CI800
Categorie Stroomomvormers
Bestandstype PDF
Bestandsgrootte 1.9 MB

Alle handleidingen voor Clarke Stroomomvormers
Meer handleidingen voor Stroomomvormers

Handleiding Clarke CI800 Stroomomvormer

Gerelateerde producten

Gerelateerde categorieën