Home > Huis & Inrichting > Spiegels > Conair Spiegels > Conair BE151T Spiegel

Handleiding Conair BE151T Spiegel

Handleiding voor je Conair BE151T Spiegel nodig? Hieronder kun je de handleiding gratis bekijken en downloaden als PDF in het Nederlands en/of Engels. Dit product heeft 1 veelgestelde vraag, 0 comments en heeft 0 stemmen. Is dit niet de handleiding die je zoekt, neem dan contact met ons op.

Is je product kapot en biedt de handleiding geen oplossing meer? Dan kun je voor reparatie gratis terecht bij Repair Café.

Handleiding

IMPORTANT SAFETY

INSTRUCTIONS

WHEN USING ELECTRICAL APPLIANCES, BASIC

SAFETY PRECAUTIONS SHOULD ALWAYS BE

TAKEN, INCLUDING THE FOLLOWING:

READ ALL INSTRUCTIONS

BEFORE USING APPLIANCE

KEEP AWAY FROM WATER

DANGER – TO REDUCE THE RISK

OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS

APPLIANCE FROM THE ELECTRICAL OUTLET

BEFORE CLEANING.

WARNING – TO REDUCE THE RISK

OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO

PERSONS:

1. Unplug from outlet before putting on or taking

off parts.

2. This mirror should not be used by or near children

or individuals with certain disabilities.

3. Use this mirror only for its intended use as

described in these instructions. Do not use

attachments not recommended by the manufacturer.

4. Never operate this mirror if it has a damaged cord

or plug, if it is not working properly, if it has been

dropped or damaged, or dropped into water. Return

the mirror to a service center for examination and

repair.

5. Keep the cord away from heated surfaces.

6. Never drop or insert an object into any opening.

7. Do not use outdoors.

8. Do not operate where aerosol (spray) products are

being used or where oxygen is being administered.

9. To disconnect, turn all controls to the OFF position,

then remove plug from outlet.

10. Do not leave appliance unattended when it is

plugged in.

11. Be sure mirror is not in a position where it can

reflect sunlight; reflected sunlight can cause fire.

12. Do not use on a soft surface such as a bed,

where openings may be blocked.

13. Turn switch to OFF position, allow unit to cool

and unplug cord before replacing light bulbs.

14. Do not place or store appliance where it can fall

or be pulled into a tub or sink.

15. If an appliance falls into water, unplug it

immediately. Do not reach into the water.

16. To protect against electrical hazards, do not use

while bathing or in the shower.

17. Never use while sleeping.

18. Do not use a bulb greater than 20 watts.

Use on any 120 volt 60 hertz AC electric outlet

(ordinary house current). Do not use it on any other

electrical outlet.

FOR HOUSEHOLD USE ONLY

SAVE THESE

INSTRUCTIONS

OPERATING

INSTRUCTIONS

To reduce the risk of electric shock, this mirror has a

polarized plug (one blade is wider than the other). This

plug will fit in a polarized outlet only one way. If the

plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician

to install the proper outlet. Do not change the plug in

any way.

CAUTION: BE SURE DIRECT SUNLIGHT DOES

NOT STRIKE MIRROR WHEN LEFT UNATTENDED;

REFLECTED SUNLIGHT CAN CAUSE FIRE.

1. Your circular, lighted makeup mirror will rotate

360º so that you can use either the normal view

or the 7x magnification view located on the

opposite side.

2. Plug cord into any standard 120 volt wall outlet.

To turn on light, simply turn the switch on the line

cord to ON setting.

3. After use, always turn switch to the OFF position.

4. The beauty and design of this mirror complement

any decor. Therefore, you may wish to leave the

mirror displayed. However, if you choose to store

the mirror, see section about storage for detailed

information.

TO REPLACE BULB

CAUTION: TURN OFF POWER AND UNPLUG.

ALLOW TO COOL AT LEAST 3 MINUTES BEFORE

REPLACING BULB.

Contact a Conair

Service Center at 1-800-3-CONAIR

for replacement bulb information (ask for replacement

bulb RP-BE151T. Bulbs are $1.50 each; includes

shipping and handling).

1. Remove the two screws located on each side of the

mirror. (Fig. 1).

2. Carefully lift off the removable housing from the half

that is affixed to the stand.

3. Unscrew the old bulb and replace with new bulb.

(Fig. 2)

4. Carefully replace the removable half after aligning

the screw holes to the fixed half.

5. Insert screws into screw holes and tighten.

Figure 1

Figure 2

09PM16534_be151t_ib_MECH.indd 109PM16534_be151t_ib_MECH.indd 1 10/9/09 4:09:03 PM10/9/09 4:09:03 PM

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Conair BE151T Spiegel. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Conair. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Conair BE151T Spiegel in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Merk	Conair
Model	BE151T
Categorie	Spiegels
Bestandstype	PDF
Bestandsgrootte	0.2 MB

Alle handleidingen voor Conair Spiegels
Meer handleidingen voor Spiegels

Beoordeling

Laat ons weten wat je van de Conair BE151T Spiegel vindt door een beoordeling achter te laten. Wil je je ervaringen met dit product delen of een vraag stellen? Laat dan een bericht achter onderaan de pagina.

Bent u tevreden over de Conair BE151T Spiegel?
Ja Nee

Beoordeel dit product als eerste

0 stemmen

Praat mee over dit product

Laat hier weten wat jij vindt van de Conair BE151T Spiegel. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.

Veelgestelde vragen over Conair BE151T Spiegel

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.