Handleiding Eureka Taron Basecamp 6 Tent

Handleiding

Contents of Carry bag

Tent body

Tent fly

Pole bag: 2 long straight main poles,

2 shorter curved side brim poles, 1 short straight fly pole

Stake bag: stakes & guyout cords

E!LUMINATE SYSTEM: 2 silver panels

Setting up the Tent Body

1. Spread the tent body out, floor side down. Locate the yellow webbing

stake out loop, as this marks the front of the tent. Also locate the grey fabric

main pole sleeves which cross in the top center of the tent body.

2. Assemble the two main poles (the two long straight poles)

3. Starting at the corner where the yellow webbing stake out loop is, follow

the sewn seam past the plastic clips and insert one of the main poles into

the grey fabric pole sleeve. Continue sliding the pole through the sleeve

until it reaches the black webbing stake out loop at the opposite corner.

Repeat process with second pole & sleeve. Correctly threaded, the poles

will make a large X shape, crossing in the middle of the tent. Confirm the

poles follow the seams of the tent, and the tips are aligned with the corner

webbing stake out loops.

4. Starting with the pole at the yellow webbing stake out loop, insert the tip of

the pole into the grommet (metal ring). Moving to opposite end of pole,

pressure the pole to bend it upwards & insert the pole tip into the grommet.

Repeat process with second pole.

5. Assemble the two side brim poles (the two shorter curved poles).

6.On the sides of the tent, locate the grey fabric sleeves. Insert & slide one

of the side brim poles through the sleeve, inserting the pole tips into the

grommets at each end. On opposite side of tent body, repeat process with

second pole.

7. Walk around the tent and connect all of the black plastic clips to their

respective poles.

8. Secure the tent to the ground using the stakes provided. Start at the

yellow webbing stake out loop, next proceed to opposite corner, and while

firmly pulling on the black webbing stake out loop hammer in the stake.

Repeat process with the other two corners. Also secure with stakes the

black webbing mid-point stake out loops on each side of the tent.

9.The tent body will now be erect, properly tensioned, and secured to the

ground.

Attaching the Fly Sheet

1. Assemble the fly pole (1 short straight pole)

2. Spread the flysheet on the ground with the inside upwards, the V3

small fly vestibule pole at your feet, and the yellow webbing strap with

buckle on your left.

3. Following the sewn seam from the top of the small fly vestibule pole,

locate the black webbing pocket with hook/loop closure, the hook/loop

closure at the top center of the fly, and the black webbing pocket at the

opposite end of the fly.

4. Insert fly pole end into the black webbing pocket at the opposite end

of the fly, secure the pole to the fly with the hook/loop closure at the top

center of the fly, and then secure the final end of the fly pole in the black

webbing pocket with hook/loop closure

5. Matching the fly’s yellow webbing strap to the tent body’s yellow

webbing stake out loop, drape the fly over the tent body, confirming the

inside of the fly is now facing the tent body.

6. Align and center the fly on the tent body so the 4 buckles match, and

the fly’s seams follow the tent body’s poles.

7. On the sides of the tent body, reach under the flysheet and carefully

align and then secure the flysheet’s hook/loop closure to the center of

the side brim pole’s grey fabric sleeve.

8. Locate the reflective webbing guyout loops on the outside of the

flysheet, reaching under the guyout loops, wrap the hook/loop closure

around the pole to secure the fly to the pole structure.

9. Now clip the buckles at each of the four corners, pulling the webbing

through the buckle to tension the fly.

10. Securing the V3 Vestibule: At the front of the tent, locate the two

black webbing stake-out loops on either side of triangular face of the V3

vestibule. Pulling equal tension on each loop, secure each loop with a

stake. To properly tension the V3 vestibule during staking, reach under

the fly & push the ground-level end of the V3’s pole away from you.

When completed, the V3’s small vestibule pole will be at approximately

a 45 degree angle from the ground when viewed from the side with the

door opened. During extreme weather, anchor the inside tip of the V3

small vestibule pole with a stake through the black webbing loop.

Additionally tie a provided guyout cord to reflective webbing guyout loop

and secure with a stake.

11. Securing the rear vestibule: for increased versatility in configuring

the vestibule, four adjustable stake out loops are provided. Minimally,

stake the two outermost stake out loops, adjusting the tension by pulling

the webbing through the triglide buckle.

E!Luminate System:

Increases the brightness of floor-level lighting provided by LED lanterns

inside the tent. Two removable triangular silver-reflective E!Luminate panels

install in the ceiling with small webbing loops & toggles and reflect a lantern’s

light downwards to the floor, increasing the brightness of floor-level light up to

3 times. A reinforced webbing hang loop with D-ring securely holds LED

lanterns at the tent’s peak. An elegant, yet simple & effective solution to

brighten the nighttime camping experience.

NOTE: Only for use with battery powered LED lanterns.

Dry Entry Marker: Located on the front V3 Vestibule door, keep rain out

of the tent when entering/exiting by stopping the fly’s zipper at the reflective

webbing marker

Snivel Locks: both front and rear vestibules’ door panels lock at bottom

with a side-release buckle to eliminate wind-driven opening

V3 Enhanced Tent System:

A series of individual features which create a system that enhances a tent’s

utility and comfort in the backcountry. This synergistic system is called the

V3-Enhanced Tent System.There are three primary design components to

the V3 Enhanced Tent System: the vertical strut vestibule pole, vectored

fly-to-tent-body pullouts, and hooded fly vents. Each design feature offers

several individual performance benefits, but when incorporated into a single

tent, a synergistic effect is observed.

12. Vectored Side Pullouts: As part of the V3 System, this tent features

fly-to-tent body pullouts. At the mid-point on each side of the tent, reach

under the fly’s edge, slide the black “dog bone” toggle through the

“O-Ring” located on the tent body. Attach a provided guyout cord to the

small webbing loop. Secure guyout cord with a stake. Repeat process

on other side of tent. The Vectored Side Pullouts enhance ventilation,

increase the tent’s interior living space, and strengthen the overall tent

during inclement weather.

13. Guyouts: This tent features preinstalled equalized guyouts.

Get in the habit of always using the guyouts even in good weather.

Eureka! Set-Up Instructions

Taron Basecamp 4 person (#2629041) &

Taron Basecamp 6 person (#2629043) Tents

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Eureka Taron Basecamp 6 Tent. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Eureka. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Eureka Taron Basecamp 6 Tent in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Eureka Tenten
Meer handleidingen voor Tenten

Veelgestelde vragen over Eureka Taron Basecamp 6 Tent

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Eureka Spitfire Solo Tent

Handleiding

Eureka N!ergy 1310 Tent

Handleiding

Eureka Mountain Pass 2XTE Tent

Handleiding

Eureka Sunrise EX 6 Tent

Handleiding

Eureka Tetragon HD 3 Tent

Handleiding

Eureka Taron 2 Tent

Handleiding

Eureka K2-XT Tent

Handleiding

Eureka Tetragon HD 5 Tent

Gerelateerde categorieën