Handleiding Foster S4000 Mirror Wing Afzuigkap

Handleiding

INSTRUCTION ON MOUNTING AND USE

GB

Installation

The cooker hood must be placed at a minimum distance of 65

cm from the cooking plane for electric cookers and 75cm for

gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater

distance, this has to be taken into account.

Do not tile, grout or silicone this appliance to the wall. Surface

mounting only. Do not fix chimney flue to furniture or fly over

shelves unless the chimney flue can be easily removed, in

case maintenance is ever required.

Use

The cooker hood is provided with an upper air exit B for

discharging fumes externally for models including chimney

flue C ( Suction Version A- exhaust pipe not supplied).

If cooking fumes and vapours cannot be externally discharged,

the cooker hood can be used in the recirculating version

F: the installation of 1 active charcoal filter F allows the

recirculation of fumes and vapours through the upper grid G.

Electrical connection

Operation TSL2

Make sure that there is a power socket near the hood and

that the system has a 30 mA differential. The mains voltage

must be the same as that on the label inside the hood. The

hood has a 1250 mm power cable with or without plug: if it

does have a plug, connect the hood to an accessible

approved socket; or if it does not (connection direct to the

mains), fit an approved bipolar switch with a minimum

contact opening of no less than 3 mm (accessible). This

installation and electrical connection must be executed by a

qualified technician.

Check also the drawings on the initial pages with the alphabetical

and numerical references in the explanatory text.

Closely follow the instructions in this manual. We cannot

accept liability for any faults, detriment or fire damage to the

appliance due to non-compliance with the manual’s

instructions. Installation and electrical connections must be

executed by a qualified technician. You should affix the hood

to a wall of sufficient weight-bearing capacity, so not to one

made of plasterboard. Do not install it inside a cupboard.

Attach it to the wall using the anchors provided:( Fig. 3 diameter

12, Fig. 5 diameter 8.)

A C B D E F

With the hood switched off, pressing any key will activate

the control panel in stand-by mode. The symbols are backlit

by a white light, allowing you view and select the desired

function.

Pressing one of the keys again will start the corresponding

function, and its symbol will light up. After all functions have

been switched off, the control panel will remain in stand-by

mode for around 30 seconds and then switch off automatically.

A: Light ON/OFF key: press this touch sensor to switch on

or off the lights of the hood.

C: Motor ON/OFF key (4 speed): press this touch sensor

to switch on the hood extractor fan at the same speed as it

was when last switched off. Use the „D“ and „B“ keys to

vary the speed (power) of extraction.

B: Decrease extraction speed (power) key: press this

touch sensor to reduce the extraction speed of the hood.

D: Increase extraction speed (power) key: press this

touch sensor to increase the extraction speed of the hood.

E: Timer key: when this touch sensor is pressed,

independently of the extraction speed selected, the timer

function will be activated. Press once to set the timer for 5

minutes, press a second time for 10 minutes and a third time

for 20 minutes. During this phase, the „E“ symbol will flash.

To reset the timer, press the motor key, „C“

F: Reset filters key: press this touch sensor to reset the

signal that warns that the metal grease filter (1) is saturated

and the charcoal filter (2) should be replaced.

(1) After 40 hours of using the hood, the „F“ symbol

will flash to indicate the necessity of cleaning the

metal grease filters.

(2) After 120 hours of using the hood, the „F“ symbol

will light up to indicate the necessity of replacing

the activated charcoal filters.

Sensor function: pressing the „B“ and „D“ keys at the

same time will activate the sensor. In this mode the extraction

speed sets itself automatically and the „B e D“ key flashes

intermittently. To return to manual operation, press either the

„B“ or the „D“ key.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Foster S4000 Mirror Wing Afzuigkap. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Foster. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Foster S4000 Mirror Wing Afzuigkap in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Foster Afzuigkappen
Meer handleidingen voor Afzuigkappen

Veelgestelde vragen over Foster S4000 Mirror Wing Afzuigkap

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Foster S4000 120 Afzuigkap

Handleiding

Foster Wing 60 Afzuigkap

Handleiding

Foster S4000 Mirror 90 Afzuigkap

Handleiding

Foster Wing 75 Afzuigkap

Handleiding

Foster S4000 Mirror 120 Afzuigkap

Handleiding

Foster 2504 194 Afzuigkap

Handleiding

Foster Peraria Afzuigkap

Handleiding

Foster Pitagora 90x90 Afzuigkap

Gerelateerde categorieën