Handleiding GE TFT26PRDAAA Koel-vries combinatie

Handleiding

AUTOMATIC ICEMAKER & DISPENSER

(on some models)

How it Works

7

The automatic icemaker makes ice continually. The dispenser

dispenses water, ice cubes or crushed ice through the freezer

compartment door. Here’s how they work.

Water flows from the household supply through a

(1)dual solenoid valve

to the

(2)water tubing and to the

(3)automatic icemaker

as needed.

Water is frozen in the

(4)cube mold and ejected

into the

(5)storage bin where a

motor-powered auger

moves cubes forward.

Cubes dispense through the chute in the door when the

dispenser pad is pressed.

When the Crushed pad is pressed (on some models), a

baffle channels cubes through the crusher and crushed ice falls

through a chute into the glass.

When the Water pad is selected (on some models), water

flows through the

(6)tubing in the door and is dispensed when the dispenser pad is

pressed.

(7)A light switch (on some models) turns the night light in the

dispenser on or off.

The light also comes on when the dispenser pad is pressed.

The light in the dispenser should be replaced with a 10 watt maximum

bulb when it burns out.

If you cannot locate the correct bulb, see your local dealer.

Electronic Monitor & Diagnostic System Automatic Icemaker & Dispenser

3

7

6

4

5

1

2

Important Facts About Your Ice & Water Dispenser

• If this is your first icemaker you’ll hear occasional sounds that

may be unfamiliar. These are normal ice-making sounds and are not

cause for concern.

• Your icemaker will produce eight cubes per cycle—approximately

120 cubes in a 24-hour period—depending on freezer compartment

temperature, room temperature, number of door openings and other

use conditions.

• Intermittent dispensing of ice is normal. If ice flow interruption is

more than brief, ice clump(s) may be the cause and should be

removed following instructions in this section.

• Avoid over-filling glasses with ice and using narrow or extra-tall

glasses. This can jam the chute or cause the door in the chute to

freeze shut. Periodically open the freezer compartment door and look

down into the chute. If ice is blocking the chute, poke it through with

a wooden spoon.

• To help keep bits of ice from being sprayed beyond the glass,

place the glass close to the ice chute—but not so close that it blocks

out-coming ice.

• Add ice before adding beverage to prevent splashing.

• Beverages and foods should not be quick-chilled in the ice

storage bin. Cans, bottles or food packages in the storage bin may

cause the icemaker or auger to jam.

• Do not add ice from trays or bags to the storage bin. It may not

crush or dispense well.

CAUTION: Some products such as water ices should not be

consumed too cold.

Before Using Your Icemaker and Dispenser

If you use your refrigerator before the water

connection is made, raise the ice access door

and make sure the icemaker feeler arm is in the

(up) position. When the water supply has

been connected to the icemaker, move the

feeler arm to the (down) position.

At first there will be a delay before water is dispensed and ice is made.

On models with a water dispenser, if no

water is dispensed when the refrigerator is

first installed, there may be air in the water line

system. Press the dispenser pad for at least two

minutes to remove trapped air from the water

line and to fill the water system.

The ice cube mold will automatically fill with water AFTER cooling

to freezer temperatures. The first cubes normally freeze after

several hours.

NOTE: With a newly-installed refrigerator, allow about 24 hours

for the freezer compartment to get cold enough to make ice.

(continued next page)

Feeler arm in

(up) position

stops icemaking

Feeler arm in

(down) position

begins icemaking

Push the dispenser pad

until the water line is filled.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je GE TFT26PRDAAA Koel-vries combinatie. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met GE. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van GE TFT26PRDAAA Koel-vries combinatie in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor GE Koel-vries combinaties
Meer handleidingen voor Koel-vries combinaties

Veelgestelde vragen over GE TFT26PRDAAA Koel-vries combinatie

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

GE PTV19SAMR Koel-vries combinatie

Handleiding

GE PTQ530SAMR Koel-vries combinatie

Handleiding

GE GSS23GGPBB Koel-vries combinatie

Handleiding

GE GSE25GYPFS Koel-vries combinatie

Handleiding

GE GLE12HSPSS Koel-vries combinatie

Handleiding

GE GYE18JYLFS Koel-vries combinatie

Handleiding

GE PTU463SAMR Koel-vries combinatie

Handleiding

GE GSE23GGPWW Koel-vries combinatie

Gerelateerde categorieën