EN- Self-priming swimming pool pump
This mode allows making a correct installation with optimal results of your swimming pool pump. Carefully
read this instruction manual.
Your new pump is a one-stage self-priming, centrifugal pump, designed for use with a swimming-pool
filtering system. It is designed to be used with clean water for temperatures between 5 ºC and 35 ºC. It is
manufactured from high quality materials subject to strict hydraulic and electrical tests. A correct installation
of this pump is assured by following the instructions from this manual. We decline all responsibility for
damages caused by use different to that explained in this instruction manual.
IMPORTANT
This manual contains basic information on the safety measures to be adopted during installation and start-
up. The fitter and the user must therefore read the instructions before installation and start-up.
GENERAL SAFETY REGULATIONS
The machines indicated in this Manual are especially designed for the pre-filtering and recirculation
of water in swimming pools
Install them in line with the specific instructions for each installation
All modifications to the pump require prior authorisation from the manufacturer. Original spare parts
and accessories authorised by the manufacturer ensure greater safety. The pump manufacturer is
exempt from all liability regarding any damage caused by unauthorised spare parts or accessories.
When working on each machine or on the units linked to them, disconnect the unit from the power
supply and the startup devices, as the electrical parts of the pump are live during operation.
All assembly and maintenance work must be carried out by qualified and authorised personnel who
have carefully read the installation and service instructions.
To guarantee safety when operating the machine, you must comply with that set out in the
installation and service instructions.
In the event of defective operation or faults, contact your supplier or nearest representative.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified personin order to avoid
Make sure that water is unable to enter the motor or the live electrical parts.
Avoid contact at all times - even accidentally - with moving machine parts while the machine is
running and/or before it comes to a complete standstill
Wait for the machine to come to a halt before handling it.
Before any electrical or mechanical maintenance operation, disconnect the unit from the power
supply and block the start-up devices.
To reduce risk of injury, children should not use this product
.
Do not bury the electric cable. Lay the cable so it cannot be damaged by machinery, like mowing
machines, etc.
Do not start the pump before it is correctly connected to the swimming pool.
To reduce risk of electric shock, change the electric cable immediately when damaged.
To reduce risks of electric shock, do not use extension cables to connect the pump to a power
supply. Connect it to a correctly installed electricity outlet.
Do not use the pump without water!
INSTALLATION
Only authorised and qualified personnel should install the pump and its cabling, respecting the
current legislation.
The pump should be installed horizontally, screwing it to the support, to avoid vibration and
unwanted noise.
The pump should be installed far from any corrosive or flammable products.
The pump should have sufficient drainage to avoid risk of flooding and should be protected from
excessive humidity.
Install independent water inlet and outlet valves.
Praat mee over dit product
Laat hier weten wat jij vindt van de Gre PP200 Zwembadpomp. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.