Handleiding Hikoki CS 51EA Kettingzaag

Handleiding

4

English

○ Make sure the automatic oiler is working. Keep the oil tank fi lled

with clean oil. Never let chain run dry on the bar.

○ All chain saw service, other than the items listed in the

operator’s/ owner’s manual, should be performed by HiKOKI

Authorized Service Centers. (For example, if improper tools are

used to remove the fl ywheel or if an improper tool is used to hold

the fl ywheel in order to remove the clutch, structural damage

to the fl ywheel could occur and could subsequently cause the

fl ywheel to burst.)

WARNING

○ Never modify the unit/machine in any way. Do not use your unit/

machine for any job except that for which it is intended.

○ Never use chain saw without any safety equipment or that has

faulty safety equipment. It could result in serious personal injury.

○ Using guide bar/chain other than recommended by the

manufacturer which are not approved, could result in a high risk

of personal accidents or injury.

Fuel safety

○ Mix and pour fuel outdoors and where there are no sparks or

fl ames.

○ Use a container approved for fuel.

○ Do not smoke or allow smoking near fuel or the unit/machine or

while using the unit/machine.

○ Wipe up all fuel spills before starting engine.

○ Move at least 3 m away from fueling site before starting engine.

○ Stop engine and let it cool for a few minutes before removing fuel

tank cap.

○ Empty the fuel tank before storing the unit/machine. It is

recommended that the fuel be emptied after each use. If fuel is

left in the tank, store so fuel will not leak.

○ Store unit/machine and fuel in area where fuel vapors cannot

reach sparks or open fl ames from water heaters, electric motors

or switches, furnaces, etc.

WARNING

Fuel is easy to ignite or get explosion or inhale fumes, so that pay

special attention when handling or fi lling fuel.

Cutting safety

○ Do not cut any material other than wood or wooden objects.

○ For respiratory protection, wear an aerosol protection mask

when cutting the wood after insecticide has been applied.

○ Keep others including children, animals, bystanders and helpers

outside the hazard zone. Stop the engine immediately if you are

approached.

○ Hold the unit/machine fi rmly with the right hand on the rear

handle and the left hand on the front handle.

○ Keep fi rm footing and balance. Do not over-reach.

○ Keep all parts of your body away from the muffl er and cutting

attachment when the engine is running.

○ Keep Bar/Chain below waist level.

○ Before felling a tree, the operator must be accustomed to the

sawing techniques of the chain saw.

○ Be sure to pre-plan a safe exit from a failing tree.

○ While cutting, hold the unit/machine fi rmly with both hands with

thumb fi rmly locked around front handle, and stand with feet well

balanced and your body balanced.

○ Stand to the side of the saw when cutting - never directly behind

it.

○ Always keep the spiked bumper face to a tree, because the

chain may suddenly be drawn into a tree, if so equipped.

○ When completing a cut, be ready to hold up the units as it breaks

into clear, so it will not follow through and cut your legs, feet or

body, or contact an obstruction.

○ Be alert against kickback (when saw kicks up and back at

operator). Never cut with the nose of the bar.

○ When relocating to a new work area, be sure to shut off the

machine and ensure that all cutting attachments are stopped.

○ Never place the machine on the ground when running.

○ Always ensure that the engine is shut off and any cutting

attachments have completely stopped before clearing debris or

removing grass from the cutting attachment.

○ Always carry a fi rst-aid kit when operating any power equipment.

○ Never start or run the engine inside a closed room or building

and/or near the infl ammable liquid. Breathing exhaust fumes

can kill.

Maintenance safety

○ Maintain the unit/machine according to recommended

procedures.

○ Disconnect the spark plug before performing maintenance

except for carburetor adjustments.

○ Keep others away when making carburetor adjustments.

○ Use only genuine HiKOKI replacement parts as recommended

by the manufacturer.

CAUTION

Do not disassemble the recoil starter. You may get a possibility

of personal injury with recoil spring.

WARNING

Improper maintenance could result in serious engine damage or

in serious personal injury.

Transport and storage

○ Carry the unit/machine by hand with the engine stopped and the

muffl er away from your body.

○ Allow the engine to cool, empty the fuel tank, and secure the

unit/machine before storing or transporting in a vehicle.

○ Empty the fuel tank before storing the unit/machine. It is

recommended that the fuel be emptied after each use. If fuel is

left in the tank, store so fuel will not leak.

○ Store unit/machine out of the reach of children.

○ Clean and maintain the unit carefully and store it in a dry place.

○ Make sure stop switch is off when transporting or storing.

○ When transporting or storage, cover chain with guide bar cover.

If situations occur which are not covered in this manual, take care

and use common sense. Contact HiKOKI Authorized Service

Centers if you need assistance. Pay special attention to statements

preceded by the following words:

WARNING

Indicates a strong possibility of severe personal injury or loss of

life, if instructions are not followed.

CAUTION

Indicates a possibility of personal injury or equipment damage, if

instructions are not followed.

NOTE

Helpful information for correct function and use.

WARNING

KICKBACK DANGER (Fig. 1)

One of the most severe dangers when working with a chain saw is

the possibility of kickback. Kickback may occur when the upper tip

of the guide bar touches an object, or when the wood closes in and

pinches the saw chain in the cut. Tip contact in some cases may

cause a lightning fast reverse reaction, kicking the guide bar up and

back toward you. Pinching the saw chain along the top of the guide

bar may also push the guide bar rapidly back towards you. Either of

these reactions may cause you to lose control of the saw which could

result in serious personal injury. Even though your saw has safety

built into its design, you should not rely on these safety features

exclusively. Know where your bar tip is at all times. Kickback does

occur if you allow the kickback zone (1) of the bar to touch an object.

Do not use that area. Kickback from pinching is caused by a cut

closing and pinching the upper side of the guide bar. Study your cut

and make sure it will open as you cut through. Maintain control when

the engine is running by always keeping a fi rm grip on the saw with

your right hand on the rear handle, your left hand on the front handle

and your thumbs and fi ngers encircling the handles. Always hold the

saw with both hands during operation and cut at high engine speed.

Follow manufacturer's sharpening and maintenance instructions

for the saw chain. The lack of this maintenance may increase the

possibility of kickback.

1

Fig. 1

000Book̲CS51EA̲Eng.indb4000Book̲CS51EA̲Eng.indb4 2017/12/1313:16:362017/12/1313:16:36

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Hikoki CS 51EA Kettingzaag. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Hikoki. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Hikoki CS 51EA Kettingzaag in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Hikoki Kettingzagen
Meer handleidingen voor Kettingzagen

Veelgestelde vragen over Hikoki CS 51EA Kettingzaag

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Hikoki CS 30Y Kettingzaag

Handleiding

Hikoki CS 30SB Kettingzaag

Handleiding

Hikoki CS 33EDP Kettingzaag

Handleiding

Hikoki CS 33EB Kettingzaag

Handleiding

Hikoki CS 33ED Kettingzaag

Handleiding

Hikoki CS 33EDT Kettingzaag

Handleiding

Hikoki CS 3630DA Kettingzaag

Handleiding

Vito VIMS45B Kettingzaag

Gerelateerde categorieën