8 Channel 2.4 GHz Aircraft Computer Radio System8 Channel 2.4 GHz Aircraft Computer Radio System
Section 2: Quick Start Guides Section 2: Quick Start Guides
26 27
The following information is designed to guide you through a simple setup of a standard sport plane or
unpowered glider. The operations shown during this exercise will help you understand many of the basic
programming steps used by the Flash 8.
Channel Assignments for a Simple Powered Plane with One or Two Aileron Servos:
Channel 1 - Aileron Channel 4 - Rudder
Channel 2 - Elevator Channel 5 - Aileron #2 (if used)
Channel 3 - Throttle
Channel Assignments for a Simple Un-Powered Glider:
Channel 1 - Aileron (plug rudder or aileron servo in Ch. #1) Channel 3 – Aileron #2 (if used)
Channel 2 – Elevator Channel 4 - Rudder
This exercise assumes two things:
1. That you have already installed the servos in your aircraft.
2. That you bound (linked) the receiver to your transmitter.
Airplane Quick Start Guide
1. Turn on the transmitter by pressing the power button
momentarily. Do not turn on the airplane. To turn o the
transmitter, press and hold the power button for approximately
3 seconds.
2. When prompted if you are “Ready to Transmit” select “No”.
3. Press the jog dial and back button simultaneously to enter the
System Menu list.
4. From the System Menu list highlight “MDL. SEL” and press the
jog dial to enter the model selection menu.
5. Select the rst default model (NONAME-1) and press the jog
dial to bring up the model maintenance prompts. Select “NEW”
to create a new model.
For safety reasons, remove the propeller(s) from electric aircraft during radio system setup.
Warning
Note
TipTip
Tip
Caution
If you are setting up a powered or un-powered glider, we will be programming your plane into
the ACRO menu for this exercise. Later you can explore the functions found in the GLID menus.
Airplane Quick Start Guide cont.
6. When asked to create a new model select “Yes.” This will bring
up the Model Type screen.
Scroll to “ACRO” and press the jog dial to conrm this selection.
Now scroll to “wing” and press the jog dial to activate the
choices. If you have 1 aileron servo, select 1AILE. If your plane
has two aileron servos, select 2AILE. Press the jog dial once to
conrm your selection.
7. Scroll to “TAIL” and press the jog dial to activate the choices.
Select “Normal” and press the jog dial once to conrm your
entry.
8. Now press the back button once. You will be prompted to
choose the receiver type. Press the jog dial once to activate the
receiver selections. Scroll to the receiver you have in your aircraft.
Press the jog dial once to conrm your receiver selection.
We are programming a new model into the model memory slot number two, not the model
memory slot one. For the purpose of this exercise it will ensure a fresh model memory with no
existing programming.
Warning
Note
TipTip
Tip
Caution
Depending on what you select here, and for the following menu choices, the radio will
automatically optimize the functions for your choices. In other words, if you select a wing type
without aps, there will be no ap function control in that model memory’s programming
selection.
Warning
Note
TipTip
Tip
Caution
Praat mee over dit product
Laat hier weten wat jij vindt van de Hitec Flash 8 RC Controller. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.