ON
OFF
POWER
SUB 100P
SUB 100P
3
www.jbl.com
English
TV
1.
2.
3.
Receiver/Processor
Receiver/Processor
NOTE: This subwoofer / LFE cable is not included, but
can be purchased from an electronics retailer.
• Be sure to turn the Crossover on the subwoofer fully
clockwise when using this type of connection. This
type of setting bypasses the subwoofer’s internal
crossover and uses your receiver or processor’s
crossover.
• Check your receiver or processor menu settings and
set the subwoofer selection to ‘On’ or ‘Yes.’
Please be sure to review the owner’s manual for your
receiver or processor for more information on speaker
setup and configuration.
• We recommend setting the subwoofer’s Crossover
setting to 80Hz for mid-sized speakers, higher for
smaller (satellite) speakers, and lower for larger
floorstanding speakers.
NOTE: This special subwoofer / LFE cable is not
included, but can be purchased from an electronics
retailer. An RCA Y-Adapter cable can also be used to
make this type of connection.
PLACING THE SUBWOOFER
CONNECTING THE SUBWOOFER
Front Left
Speaker
Center
Speaker
Front Right
Speaker
SUBWOOFER LFE
OUT
TO A RECEIVER OR PREAMP/PROCESSOR WITH A LOW-PASS FILTERED DEDICATED SUBWOOFER OUTPUT (LFE)
The performance of a subwoofer is directly related to its placement in the listening room
and its physical position relative to the other speakers in the system.
While it is true that in general our ears do not hear directional sounds at the low
frequencies where subwoofers operate, when installing a subwoofer within the limited
confines of a room, the reflections, standing waves and absorptions generated within the
room will strongly influence the performance of any subwoofer system. As a result, the
specific location of the subwoofer in the room does become important to the amount and
quality of bass that is produced.
For example, placing the subwoofer next to a wall generally will increase the amount of
bass in the room; placing it in a corner (1) generally will maximize amount of bass in the
room. However, corner placement can also increase the destructive effect of standing
waves on bass performance. This effect can vary depending on the listening position –
some listening positions may yield very good results while others may have far too much
(or too little) bass at certain frequencies.
In many rooms, placing the subwoofer along the same plane as the left and right
speakers (2) can produce the best integration between the sound of the subwoofer and
that of the left and right speakers. In some rooms, the best performance could even
result from placing the subwoofer behind the listening position (3).
We strongly recommend that you experiment with placement before choosing a final
location for your subwoofer. One way you can determine the best location for the
subwoofer is by temporarily placing it in the listening position and playing music with
strong bass content. Move around to various locations in the room while the system is
playing (putting your ears where the subwoofer would be placed), and listen until you find
the location where the bass performance is best. Place the subwoofer in that location.
TO A RECEIVER OR PREAMP/PROCESSOR WITH PREAMP OUTPUTS
SUBWOOFER
INPUT
POWER
MODE
ON
PHASE
NORMAL
CROSSOVER
VOLUME
SUBWOOFER
INPUT
AUTO REVERSE
PWR
BLUE: ON
RED: STANDBY
50Hz 150Hz
MIN
MAX
PREAMP
OUTPUT
SUBWOOFER
INPUT
POWER
INPUT
ON
OFF
POWER
POWER
MODE
ON
PHASE
NORMAL
CROSSOVER
VOLUME
SUBWOOFER
INPUT
AUTO REVERSE
PWR
BLUE: ON
RED: STANDBY
50Hz 150Hz
MIN
MAX
POWER
INPUT
Surround Left
Speaker
Surround Right
Speaker
Praat mee over dit product
Laat hier weten wat jij vindt van de JBL Arena Sub 100P Subwoofer. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.