Handleiding Kichler 16027SS27 VLO Lamp

Handleiding

WARNING – RISK OF ELECTRIC SHOCK

1) Use only in ponds and small decorative fountains where persons will

immerse no more than their hands and lower arms while the product is

energized.

2) DO NOT use in water intended for swimming, wading, immersion, or

bathing.

3) All installer completed cable connections must be located outside of

pond or fountain.

4) Low voltage circuit must be supplied by a power unit marked as suitable

for supplying submersible luminaires.

5) Power unit must be supplied by a branch circuit protected by a Class A

type ground fault circuit interrupter (GFCI).

6) Maximum Depth: 72” (1.8m).

7) Wiring connections must be made with approved/listed wire connection

device(s) suitable for the application. Do not exceed manufacturers’

 wiringcombinationspecicationsforsizeandquantityofconductors.

8) Thisxtureistobeusedonlywithalistedpowerunit(transformer)rateda

maximum of 300 W (25 AMPS) 15 volts.

9) The unit low voltage cable integral to the product is intended for

shallow burial - maximum 6 inches (152 mm).

10) Low voltage cable shall be protected by routing in close proximity to the

luminaire, or next to a building structure such as a house or deck and not

be buried except for a maxiumum of 6 inches (15.2 cm).

11) Direct burial rated wire is to be buried a minimum of 6” (152mm) beneath

the surface of the ground.

12) NOTE: If additional Direct Burial wire is needed, contact your local

Kichler

®

landscape distributor.

• 8 GA wire can be purchased in length of 250’ (76 M), 15503-BK.

• 10 GA wire can be purchased in length of 250’ (76 M), 15504-BK.

• 12 GA wire can be purchased in lengths of 100’ (30 M), 15501-BK; 250’

(76 M), 15502-BK; 500’ (152M), 15505-BK; and 1000’ (304 M),

15506-BK.

SAFETY INSTRUCTIONS

READ THIS FIRST

KEEP THESE INSTRUCTIONS

CAUTION – RISK OF SHOCK –

Disconnect Power at the main circuit breaker panel or main fusebox

before installation.

This xture is intended for installation in accordance with the National

Electric Code (NEC) and Local code specications. Failure to adhere to

these codes and instructions may result in serious injury and/or property

damage and will void the warranty. If you are not familiar with code

requirements, installation by a certied electrician is recommended.

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE

OR LOW VOLTAGE), CARE SHOULD BE TAKEN TO KEEP CLEAR OF

POTENTIALLY COMBUSTIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES,

PINE NEEDLES, GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT

HAS ACCUMULATED ON THE LIGHT BULB, LENS, OR BODY OF THE

FIXTURE.

For warranty information please visit: kichler.com/customer-care/warranty-information/landscape-warranty

Installation for Use as Underwater Fixture:

1) Turno󰀨power.

2) Make wire connections directly to a low voltage transformer or connect to

low voltage power supply cable using approved/listed wire connection

device(s) suitable for the application.

NOTE:Connectionfromthexturecabletopowersupplycablemust

not be submerged.

3) Fixture can be placed in water by itself to be hidden or tucked away into

 rocks.Toadjustthetiltangleofxture,loosenthethumbscrews, 

 adjustthexturetothedesiredangle,andre-securebytighteningthe

thumbscrews. Fixture can be used without cowl and/or bracket. To

remove the cowl and/or bracket, loosen and remove the thumbscrews,

 slidethebracketo󰀨fromtheside,andslidethecowlandrubberwashers

 o󰀨fromthetop.Whenusingxturewithoutbracket,tuckxtureinto 

 rocksandbackllrocksaroundthexturetosecureindesiredlocation.

4) Placextureindesiredlocation.

NOTE: Always keep minimum 3” clearance from face/lens of product.

5) To weight down bracket for in-water use, stones or pebbles can be used

 atbaseofbracket.Bracketcanalsobefastenedtoalargeratstone

using optional size 3/16” stainless steel masonry screws (not supplied).

6) Whenusingxtureinbodiesofwaterthatfreeze,pullxtureoutofwater

 beforewaterfreezes.Donotplacexturebackintowateruntil

after water thaws.

Installation for Out of Water Use:

1) Turno󰀨power.

2) The base of the bracket may be used as a template for marking the

desired mounting screw locations. At the desired location, drive one of

the mounting screws (provided) part way into the mounting surface. Slip

the base of the bracket over the screw by passing the mounting screw

head through center opening. Tighten the mounting screw to hold the

bracket in position. Drive the second mounting screw completely to fully

secure the bracket.

NOTE: Always keep minimum 3” clearance from face/lens of product.

3) Ifyouwishtoconcealthewiretothexture,drillawireopeninginthe

mounting surface through the center of the opening in the base of the

bracket.

4) Toadjustthetiltangleofxture,loosenthethumbscrews,adjustthe

 xturetothedesiredangle,andre-securebytighteningthe  

thumbscrews. Fixture can be used without cowl and/or bracket. To

remove the cowl and/or bracket, loosen and remove the thumbscrews,

 slidethebracketo󰀨fromtheside,andslidethecowlandrubberwashers

 o󰀨fromthetop.Whenusingxturewithoutbracket,tuckxtureinto 

 rocksandbackllrocksaroundthexturetosecureindesiredlocation.

5) Make wire connections directly to a low voltage transformer or connect to

low voltage power supply cable using approved/listed wire connection

device(s) suitable for the application.

NOTE:Connectionfromthexturecabletopowersupplycablemustnot

be submerged.

To change light output setting:

NOTE:Toadjustlumenoutputforthisxture,see“Tochangelight 

output setting” instructions on Page 2.

IS-16027SS-US

We’re here to help 866-558-5706

Hrs: M-F 9am to 5pm EST

FIXTURE

COWL

THUMBSCREW

RUBBER WASHER

BRACKET

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired

operation.

Note:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiateradiofrequencyenergy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturning

theequipmento󰀨andon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowing

measures:

• Reorient or relocate the receiving antenna.

• Increasetheseparationbetweentheequipmentandreceiver.

• Connecttheequipmentintoanoutletonacircuitdi󰀨erentfromthattowhichthereceiverisconnected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC INFORMATION

Page 1

CONFORMS TO ANSI/UL STD. 1838 CERTIFIED TO CSA STD. C22.2 NO. 250.7

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Kichler 16027SS27 VLO Lamp. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Kichler. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Kichler 16027SS27 VLO Lamp in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Kichler Lampen
Meer handleidingen voor Lampen

Veelgestelde vragen over Kichler 16027SS27 VLO Lamp

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.