Handleiding Kichler 84322MBK Jestin Lamp

Handleiding

For warranty informaon please visit: kichler.com/warranty

Fixture Diagram

Parts List

Cauons

CAUTION – RISK OF SHOCK –

Disconnect Power at the main circuit breaker panel or main

fusebox before starng and during the installaon.

WARNING:

This xture is intended for installaon in accordance with the

Naonal Electrical Code (NEC) and all local code specicaons.

If you are not familiar with code requirements, installaon by a

cered electrician is recommended.

DIMMING:

This LED xture is compable with most standard incandescent

dimmers, LED dimmers, and electronic low voltage dimmers.

For opmal performance, an electronic low voltage dimmer should

be used.

See kichler.com/dimming for a list of compable dimmers.

CLEANING:

• Always be certain that electric current is turned o before

cleaning.

• Only a so damp cloth should be used. Harsh cleaning

products may damage the nish.

[A] Outlet Box

[B] Mounting

Plate

[C] Canopy

[D] Countersunk

Mounting

Screw

[E] Plate Mounting

Screw

[F] Cable Strain

Relief

[G] Support Cable

[H] Drywall

Anchors

[I] Drywall

Mounting

Screws

1) Remove mounng plate[B] from canopy[C] by unscrewing

four (4) countersunk mounng screws[D] from canopy: two (2)

screws on front of canopy, two (2) screws on back of canopy.

Retain screws for re-aaching canopy to mounng plate.

2) Aach mounng plate[B] to outlet box[A] using the plate

mounng screws[E]. Mounng plate can be adjusted to suit

posion of xture.

3) Using the mounng plate as a template, mark the posions

for the two (2) drywall anchors[H], one on each end of the

mounng plate. Unscrew the plate mounng screws, and

remove the plate mounng screws and mounng plate.

4) Drill 5mm (3/16”) holes in ceiling where marked, and insert the

two (2) drywall anchors[H].

5) Aach mounng plate[B] to outlet box[A] using the plate

mounng screws[E]. Secure mounng plate to ceiling by

screwing the two (2) drywall mounng screws[I] through the

drywall mounng screw holes in the mounng plate, and into

the drywall anchors.

6) Adjust each support cable[G] to the desired length. To

shorten the cable, push up on the cable at the cable strain

relief[F] aached to the canopy and push cable into canopy.

To lengthen the cable, push up on the cable strain relief and

gently pull down on the cable to the desired length.

7) Grounding instrucons: (See Illus. a or b).

a) On xtures where mounng plate is provided with a hole

and two raised dimples, wrap ground wire from outlet

box around green ground screw, and thread into hole.

b) On xtures where a cupped washer is provided, aach

ground wire from outlet box under cupped washer and

green ground screw, and thread into mounng plate.

If xture is provided with ground wire, connect xture ground

wire to outlet box ground wire with wire connector aer

following the above steps. Never connect ground wire to black

or white power supply wires.

8) Make wire connecons. Reference chart below for correct

connecons and wire accordingly.

Connect Black or Red

Supply Wire to:

Connect White Supply Wire

to:

Black White

*Parallel cord (round &

smooth)

*Parallel cord (square &

ridged)

Clear, Brown, Gold or Black

without Tracer

Clear, Brown, Gold or Black

with Tracer

Insulated wire (other

than green) with copper

conductor

Insulated wire (other than

green) with silver conductor

*Note: When parallel wire (SPT 1 &

SPT 2) are used. The neutral wire

is square shaped or ridged and the

other wire will be round in shape or

smooth (See illus.) Neutral Wire

9) Raise xture to ceiling, carefully passing canopy[C] over

mounng plate[B].

NOTE: Make sure wires do not get pinched between canopy

and ceiling.

10) Align holes on front and back of canopy with holes on anges

of mounng plate.

11) Secure canopy to mounng plate using countersunk mounng

screws[D] previously removed from canopy.

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

a

b

Installaon Instrucons

This device complies with part 15 of the FCC Rules. Operaon is subject to the following two

condions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause

undesired operaon.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protecon against harmful interference in a residenal installaon. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instrucons, may cause harmful interference to radio communicaons. However, there is

no guarantee that interference will not occur in a parcular installaon. If this equipment does

cause harmful interference to radio or television recepon, which can be determined by turning

the equipment o and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separaon between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Informaon:

IS-84322-US

We’re here to help 866-558-5706

Hrs: M-F 9am to 5pm EST

REV 22-APR-2021

84322

A

E

B

D

C

F

G

H

I

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Kichler 84322MBK Jestin Lamp. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Kichler. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Kichler 84322MBK Jestin Lamp in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Kichler Lampen
Meer handleidingen voor Lampen

Beoordeling

Veelgestelde vragen over Kichler 84322MBK Jestin Lamp

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Kichler 15450TZT Mica Lamp

Handleiding

Kichler 15236TZT Eclipse Lamp

Handleiding

Kichler 15800AZT30R Ripley Lamp

Handleiding

Kichler 15784CBR Small Lamp

Handleiding

Kichler 15322AGZ Cross Lamp

Handleiding

Kichler 16016AZT30 VLO Lamp

Handleiding

Kichler 10766WHLED Ceiling Lamp

Handleiding

Kichler 16017BKT27 VLO Lamp

Gerelateerde categorieën