Problem
Indicator light not coming On
Indicator light flickering
Loss of power
Incubator not heating to 100°F
Incubator drying out
Temperature & humidity are too low during hatch
Uncover
Is unit plugged in?
Is there power to this outlet?
Are you using a surge protector?
This is normal.
Is unit plugged in?
Are you using a surge protector?
Is room temperature between 65º and 72º?
Is the ambient temperature consistent?
Is the unit located near any drafts?
Did you add water to rings?
How much?
Add a wet sponge?
Replace the vent plug(s)
Possible Reasons
Erratic power source
The unit is adjusting to temperature
changes or variations
Erratic power source or loose wire
Room may be too cold or drafty
Room is excessively dry
Washing the Automatic Egg Turner (continued)
Assembly:
Select one of the six egg trays and attach the position cover to the egg tray location
nearest the offset arm end by inserting the circular pins on the position cover into the
aligning holes on the egg tray (large egg trays only). Once in place, press cover
firmly into holes.
Attach egg tray with cover to the motor end of the base. The motor location is rec-
ognizable by the two holes in the extended plastic end. Holding the egg tray vertical,
with the offset arm in a horizontal position, insert the round pin on the end of the
tray into the corresponding hole in the base. With the egg tray still vertical, rotate the
egg tray downwards so the offset arm end pivot slides into the corresponding notch
in the base. Repeat with remaining five egg trays until all six are aligned with the
base.
Once all egg trays are in the base, keep all egg trays vertical and offset
arms in a horizontal position. Bring the connecting rod into position by
holding it parallel to the base and slightly above the offset arms. The T-
shaped end of the connecting rod should align with the motor location.
Lower the connecting rod so each egg tray offset arm slips into place into
the corresponding notch in the connecting rod.
Carefully rotate the six egg trays while holding the offset arms in the
notches in the base and connecting rod until all offset arms are in a verti-
cal position and the egg trays are level. Place a flat object on the level egg
trays to retain position for motor installation.
Slide the white plastic lever on the side reverse of the power cord on the
motor down into the T-shaped bracket at the end of the connecting rod.
When in place, the two holes at the base of the motor should align direct-
ly with the two holes in the projecting plastic of the base. Insert two
screws through the frame and tighten into holes in motor flange to secure.
Line up the power cord exiting the motor with the side of base that has a
notch molded in it. Find the larger groove in power cord and slide into the
notch in the base.
Troubleshooting Tips For Incubator Use
Praat mee over dit product
Laat hier weten wat jij vindt van de Little Giant 6302 Broedmachine. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.