Handleiding Maytag WVW51UC6FS Afzuigkap

Handleiding

7

INSTALLATION INSTRUCTIONS

Prepare Location

■ It is recommended that the vent system be installed

before hood is installed.

■ Before making cutouts, make sure there is proper

clearance within the ceiling or wall for exhaust vent.

■ Check your ceiling height and the hood height

maximum before you select your hood.

1. Disconnect power.

2. Determine which venting method to use: roof, wall,

or non-vented.

3. Select a flat surface for assembling the range hood.

Place covering over that surface.

4. Using 2 or more people, lift range hood onto

covered surface.

5. Remove wood base from range hood and dispose

of properly.

6. Remove the metal grease filter and the white foam shipping

block from inside the range hood located below the blower.

Range Hood Mounting Screws Installation

1. Determine and mark the centerline on the wall where

the canopy hood will be installed.

2. Select a mounting height between a minimum of 24" (61 cm)

for an electric cooking surface, a minimum of 27" (68.6 cm)

for a gas cooking surface, and a suggested maximum of

36" (91.4 cm) above the range to the bottom of the hood.

Mark a reference line on the wall.

3. Tape template in place, aligning the template centerline

and bottom of template with hood bottom line and with

the centerline marked on the wall.

4. Mark centers of the fastener locations through the template

to the wall.

IMPORTANT: All canopy mounting screws must be installed

into wood where possible. If there is no wood to screw into,

additional wall framing supports may be required or use

the (4) 10 x 60 mm wall anchors and 5.4 x 75 mm screws.

Remove the template.

5. For wood, drill

3

/

16

" (4.8 mm) pilot holes at all locations

where screws are being installed into wood.

For wall anchors, drill

7

/

16

" (10 mm) holes at all locations

where wall anchors are being used.

6. For wood, install (2) 5 x 45 mm mounting screws. Leave

a

1

/

4

" (6.4 mm) gap between the wall and the back of the

screw head to slide range hood into place.

For wall anchors, install the 10 x 60 mm wall anchors

and install the 5.4 x 75 mm screws into the wall anchors.

Tighten until the wall anchors are secure. Back the screws

out

1

/

4

" (6.4 mm).

Vent Cover Bracket Installation

1. Attach vent cover bracket to wall flush to the ceiling using (2)

5 x 45 mm screws. Use the optional wall anchors if needed.

Complete Preparation

1. Determine and make all necessary cuts in the wall for the

vent system. Install the vent system before installing the

hood. See “Venting Requirements” section.

2. Determine the required height for the home power supply

cable and drill a 1

1

/

4

" (3.2 cm) hole at this location.

3. Run the home power supply cable according to the National

Electrical Code or CSA Standards and local codes and

ordinances. There must be enough

1

/

2

" conduit and wires

from the fused disconnect (or circuit breaker) box to make

the connection in the hood’s electrical terminal box.

NOTE: Do not reconnect power until installation is complete.

4. Use caulk to seal all openings.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

Vertical Centerline

C

L

LLAW RAER

ETALPMET GNITNUOM

EGDE MOTTOB NGILA

ENIL LICNEP HTIW

MOTTOB GNITACIDNI

DOOH EHT FO

thgieH noitallatsnI

TROPPUS LLAW RAER RO SDUTS HGUORHT SELOH TOLIP "61/3 )OWT( 2 LLIRD

eniL latnoziroH

A

C

B

A. Centerline

B. Fastener locations

C. Mounting height reference (hood bottom line)

¹⁄₄"

(6.4 mm)

A

C

B

A. Ceiling

B. Wall

C. Centerline

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Maytag WVW51UC6FS Afzuigkap. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Maytag. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Maytag WVW51UC6FS Afzuigkap in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Maytag Afzuigkappen
Meer handleidingen voor Afzuigkappen

Veelgestelde vragen over Maytag WVW51UC6FS Afzuigkap

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Maytag UXT4230ADW Afzuigkap

Handleiding

Maytag WVW75UC0DS Afzuigkap

Handleiding

Maytag UXT5536AAS Afzuigkap

Handleiding

Maytag UXT4236ADS Afzuigkap

Handleiding

Maytag UXT4230ADB Afzuigkap

Handleiding

Maytag UXT5230BDW Afzuigkap

Handleiding

Maytag UXL6036YSS Afzuigkap

Handleiding

Maytag UXT5230BDS Afzuigkap

Gerelateerde categorieën