Handleiding McCulloch Mac 545E Kettingzaag

Handleiding

produce general numbness. Continual or regular users

should therefore monitor closely the condition of their

hands or fingers. If any of the symptoms appear, seek

immediate medical advice.

3 Never carry the chainsaw with the engine running.

Whenever carrying a chainsaw, even for short distances,

the chain should be covered by the chain guard (scabbard)

and the bar should point backwards.

When transporting the chainsaw in a vehicle, secure the

saw to prevent fuel spillage.

4 To avoid kick-back, do not attempt to cut with the nose of

the bar. Ensure the engine is running at full throttle before

commencing to cut. To avoid kick-back, do not let the

nose of the bar come into contact with logs, branches, the

ground or any other obstruction. Do not allow any part of

the chain to come into contact with rock, nails or wire

fence

Ensure the chain is kept sharp and correctly tensioned.

Keep the spike or the saw body against the wood when

cutting. Use only genuine accessories and spare parts. We

recommend you have your unit periodically checked and

serviced by an authorised dealer.

Do not use chainsaw above shoulder height.

5 Do not operate the chainsaw near a naked flame or spilled

fuel. Only operate the chainsaw outside and in well ventila-

ted areas.

After re-fuelling, always wipe off any spilled fuel. Move the

chainsaw away from the fuelling point before starting the

engine.

6 Keep by-standers and animals out of the work area; at a

minimum distance of 10 m or twice the timber length. If

necessary, use warning signs to keep on-lookers at a

distance.

Carefully survey the working site to note any hazards, eg.

roads, paths, electricity cables, dangerous trees etc. Do not

use the chainsaw if the device for stopping the chain (safety

chainbrake) does not work correctly. Never place hands on

the chain whilst the engine is running. Ensure someone is

within hearing distance in case of an accident. If this is not

possible, it is recommended that users operating chain-

saws in remote areas carry an adequate first-aid kit with

them and ensure someone knows their location. Never

leave the engine running while the tool is unattended.

ONLY USE ORIGINAL SPARE PARTS AND ACCESSO-

RIES.

BAR AND CHAIN

INSTALLATION - INTENZ

Ensure engine is always switched off before fitting or

adjusting chain. Wear a pair of protective gloves when fit-

ting or adjusting chain.

1 Ensure chain brake lever is in disengaged position (A).

Remove retaining nuts (B) and cover.

2 Turn the adjusting screw (D) counterclockwise taking it

fully back.

3 Feed chain into bar groove ensuring correct direction of

chain (P).

4 Work the chain around sprocket and set the bar as illustra-

ted, make the lower hole (F) coincide with the pin (G) of the

adjusting screw.

5 Reposition side cover. Fit spike as illustrated.

6 Lock nuts (B) finger tight.

Adjust chain tension pin by turning screw (D) so that when

lifting the chain an entire drive link is just visible.

The chain is correctly tensioned when there is no slack on

the underside of the bar, and it runs freely in bar groove.

Tighten the bar retaining nuts with the wrench, pushing bar

tip upwards.

INTENZ

Turn the adjusting screw (I) counterclockwise taking it fully

back.

Feed chain into bar groove ensuring correct direction of chain

(P).

Lock nuts (B) finger tight.

Adjust chain tension pin by turning screw (I) so that when lif-

ting the chain an entire drive link is just visible.

The chain is correctly tensioned when there is no slack on the

underside of the bar, and it runs freely in bar groove. Tighten the

bar retaining nuts with the wrench, pushing bar tip upwards.

FUEL MIX

Use only fuel recommended by this manual. This product

is fitted with a 2-stroke engine and therefore requires a

2-stroke petrol and oil mix. Use leaded (4 Star) or unleaded

petrol with a minimum octane rating of 90.

UNLEADED PETROL: if using unleaded petrol, you must use

a totally synthetic 2-stroke engine oil or branded 2-stroke

engine oil (see table).

Only use oil from sealed containers. In order to obtain a good

fuel mix, put the oil into the container before the petrol.

IMPORTANT

Always shake this fuel mix vigorously each time you use it.

We recommend to carry out this operation each time you use

the fuel.

Fuel mix properties deteriorate with time, we therefore recom-

mend that you only make the quantity of fuel mix you will

need for each usage. Do not use fuel mix more than a week

old as this could damage the engine.

WARNING

Do not smoke when re-fuelling.

Always open the fuel cap slowly.

Re-fuel in open spaces only, keeping away from naked fla-

mes or sparks.

Always store fuel in an approved container.

SAFE STORAGE OF FUEL

Petrol is highly inflammable. Put out all cigarettes, pipes and

cigars before working with petrol. Avoid spilling petrol. Store

fuel in a cool, well ventilated place, in an approved container

specifically designed for the purpose.

2

UK

C

D

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je McCulloch Mac 545E Kettingzaag. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met McCulloch. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van McCulloch Mac 545E Kettingzaag in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor McCulloch Kettingzagen
Meer handleidingen voor Kettingzagen

Veelgestelde vragen over McCulloch Mac 545E Kettingzaag

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

McCulloch MS1415 Kettingzaag

Handleiding

McCulloch CS 340 Kettingzaag

Handleiding

McCulloch EB356a Kettingzaag

Handleiding

McCulloch CS 410 Elite Kettingzaag

Handleiding

McCulloch Promax 40 II Kettingzaag

Handleiding

McCulloch MS1635AV Kettingzaag

Handleiding

McCulloch CSE 1835 Kettingzaag

Handleiding

McCulloch EB358a Kettingzaag

Gerelateerde categorieën