Handleiding Midland LXT114 Walkie-talkie

Handleiding

LXT114 Series

OWNER'S MANUAL

www.midlandradio.com

GMRS/FRS Radio

Welcome to the world of Midland electronics

Congratulations on your purchase of a high quality MIDLAND product. Your

2-way radio represents the state-of-the-art in high-tech engineering.

Designed for GMRS (General Mobile Radio Service) operation, this

compact package is big in performance. It is a quality piece of electronic

equipment, skillfully constructed with the finest components. The circuitry

is all solid-state and mounted on a rugged printed circuit board. Your two-

way radio is designed for reliable and trouble-free performance for years to

come.

LCD DISPLAY

1. TRANSMIT (TX) ICON – Indicates

radio is transmitting a signal.

2. VOLUME METER – Indicates the

volume setting of the radio.

3. RECEIVE (RX) ICON – Indicates

radio is receiving a transmission.

4. LOW BATTERY ICON – Indicates the

battery level is low.

5. VOX ICON – Indicates when VOX

mode is active.

6. CHANNEL NUMBER – Changes from

1~22 on GMRS/FRS band.

1

CONTR

OLS

7. PTT Button – Press and hold to

transmit voice communication.

8. SCAN/LOCK Button – Press to enter

SCAN mode. Press and hold to turn

KEY LOCK on/off.

9. UP

s

and DOWN

t

Button – Make

adjustments in MENU mode.

10. SPEAKER – Built-in speaker.

11. ANTENNA

12. EXTERNAL SPEAKER/MIC/CHG.

JACK

13. POWER / MODE Button – Press and

hold for at least 3 seconds to turn the

radio on/off. Press momentarily to

access Menu mode.

14. MIC – Built-in microphone.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions : (1) this device does not cause harmful interference, and (2)

this radio must accept any interference that may cause undesired operation.

To maintain compliance with FCC’s RF exposure guidelines, for body-worn operation,

this radio has been tested and meets the FCC RF exposure guidelines when used with

Midland Radio Corp. accessories supplied or designated for this product. Use of other

accessories may not ensure compliance with FCC RF exposure guidelines.

14

13

12

11

10

9

8

7

6

5

4

3

2

IMPORTANT NOTICE, FCC LICENSE REQUIRED FOR GMRS OPERATION

(Only Applicable for GMRS Radio Use in the United States)

The LXT114 Series operates on GMRS (General Mobile Radio Service)

frequencies which require an FCC (Federal Communications Commission)

license. You must be licensed prior to operating on channels 1 - 7 or 15 - 22,

which comprise the GMRS channels of the LXT114 Series. Serious penalties

could result for unlicensed use of GMRS channels, in violation of FCC rules,

as stipulated in the Communications Act's Sections 501 and 502 (amended).

You will be issued a call sign by the FCC which should be used for station

identification when operating the radio on GMRS channels. You should also

cooperate by engaging in permissible transmissions only, avoiding channel

interference with other GMRS users, and being prudent with the length of their

transmission time.

To obtain a license or ask questions about the license application, contact

the FCC at 1-888-CALL FCC or go to the FCC's website:

http://www

.fcc.gov and request form 605.

Exposure To Radio Frequency Energy

Your Midland radio is designed to comply with the following national and

international standards and guidelines regarding exposure of human being to

radio frequency electromagnetic energy:

- United States Federal Communications Commission, Code of Federal

Regulations: 47 CFR part 2 sub-part J

- American National Standards Institute (ANSI)/Institute of Electrical &

Electronic Engineers (IEEE) C95. 1-1992

- Institute of Electrical and Electronic Engineer (IEEE) C95. 1-1999 Edition

- National Council on Radiation Protection and Measurements (NCRP) of the

United States, Report 86, 1986

- International Commission on Non-lonizing Radiation Protection (ICNIRP)

1998

To control your exposure and ensure compliance with the general population

or uncontrolled environment exposure limits, transmit no more than 50% of

the time. The radio generates measurable RF energy exposure only when

transmitting.

IMPORTANT: Changes or modifications to this unit not expressly approved by

MIDLAND RADIO CORP. could void your right to operate this unit. Your radio

is set up to transmit a regulated signal on an assigned frequency. It is against

the law to alter or adjust the settings inside the COMMUNICATOR to exceed

those limitations. Any adjustment to your radio must be made by qualified

technicians.

MMIIDDLLAANNDD RRAADDIIOO CCOORRPPOORRAATTIIOONN

5900 Parretta Drive

Kansas City, MO 64120

Call 816.241.8500

visit us at http://www.midlandradio.com

Note: Features & Specifications are subject to change without notice.

MIDLAND is not responsible for unintentional errors or omissions on its

packaging.

BATTER

Y INSTALLA

TION

Your LXT114 Series radio operates with 3 AAA alkaline batteries or a NiMH

rechargeable batteries. The belt clip should be removed to ease installa-

tion or removal of the batteries.

To install the batteries:

1. With the back of the radio facing you, remove the belt clip (see diagram

below) for easy access, then remove the Battery Cover by pressing

down on the top center and sliding it down from the radio.

2. Insert 3 AAA batteries observing the polarity as shown on the Battery

Compartment. Installing the batteries incorrectly will prevent the unit

from operating or may damage the unit.

3. Return the Battery Cover by sliding it up on the radio. Replace the belt

clip, making sure it locks into place.

BATTERY

COMPARTMENT

BATTERY

COMPARTMENT

COVER

Press here and

push down to open

BELT CLIP

LOCK TAB

BELT CLIP

LATCH

CHARGING THE BATTERY

Your LXT114 Series is equipped for using rechargeable NiMH batteries

which can be recharged by inserting the AC adapter into the radio charge

jack. Initial charge time is 24 hours. Charge time is about 12 hours

thereafter. For maximum battery life, we recommend charging the

batteries when the low battery icon comes on. Remove the radios from the

charger when the charge time expires.

1. Only use our NiMH batteries.

2. Do not attempt to charge alkaline batteries or any batteries or

battery packs other than the one indicated in the manual. This

may cause leakage and damage to the radio.

3. For long term storage of the radio, turn the radio OFF and

remove the batteries from the radio.

EXTERNAL SPEAKER/MICROPHONE JACK

To use an optional speaker / microphone or headset:

l Insert the plug(s) into the SPK/MIC jacks

l Place the earbud into your ear, and adjust the mic into

your desired position.

!

SPK

MIC

CHG

POWER ON/OFF

AND VOLUME

Press the POWER/MODE button for at least 3 seconds to turn the radio

on/off. To increase/decrease the volume level, press the

s

\

t

button

during RX or STANDBY mode. The VOLUME METER will indicate the

volume setting of the radio.

TRANSMITTING AND RECEIVING A CALL

1. For maximum clarity, hold the radio 2 to 3 inches from your mouth.

2. Press and hold the PTT button and speak in a normal voice into the

microphone. The TX icon will appear continuously on the LCD Display

while transmitting.

3. To receive a call, release the PTT button. The RX icon will appear on

the display when your radio is receiving a transmission.

SCAN

Your radio can scan all 22 channels for activity. To enter, quickly press the

SCAN button. Repeat the same procedure to exit. Your radio will rapidly

scan each of the 22 channels and stop on any active channel for 4 seconds

before resuming scan. When you press the PTT button to transmit on an

active channel, the scanning function will stop and remain on the active

channel. To resume scanning, quickly press the SCAN button.

CALL ALERT

Your LXT114 Series can transmit a call alert. To send, press the PTT

button twice rapidly. The TX icon will appear while transmitting a call alert

and a tone can be heard on the speaker for confirmation.

KEYPAD LOCK

Press the LOCK button for 4 seconds. The “Lo” icon will appear on the

display. PTT will still be active. Repeat the same procedure to unlock the

keypad, a “LF” icon will appear on the display.

CHANNEL SELECTION (GMR

S/FRS BAND)

Press the MODE button once, and then the

s

\

t

buttons to select one of

the 22 GMRS/FRS channels. To confirm the selection, press the PTT

button or press the MODE button again to move to the next feature setting.

Note : To communicate between two LXT114 Series radios, all radios in

your group must be set to the same channel.

VOX

To turn VOX on, press the MODE button twice, the display shows “VOX”

blinking while below the “oF” icon appears. Select “on” by pressing the

s

\

t

buttons and push the PTT key or MODE button again to confirm.

To turn VOX off, press the MODE button twice, the display shows “VOX”

blinking while below the “on” icon appears. Select “oF” by pressing the

s

\

t

buttons and push the PTT key or MODE button again to confirm.

OPERATING YOUR RADIO

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Midland LXT114 Walkie-talkie. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Midland. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Midland LXT114 Walkie-talkie in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Midland Walkie-talkies
Meer handleidingen voor Walkie-talkies

Beoordeling

Gerelateerde producten

Handleiding

Midland LXT560 Walkie-talkie

Handleiding

Midland XT-60 Walkie-talkie

Handleiding

Midland LXT535 Walkie-talkie

Handleiding

Midland LXT600 Walkie-talkie

Handleiding

Midland LXT385 Walkie-talkie

Handleiding

Midland LXT118 Walkie-talkie

Handleiding

Midland G10 Pro Walkie-talkie

Handleiding

Midland CT590 Walkie-talkie

Gerelateerde categorieën