6
ASSEMBLY INSTRUCTIONS
1. Carefully remove all contents from the packaging and ensure all components and
parts are in good order.
2. Insert pole onto the top of unit. Match the grooves on the pole with the notches in
the pole connector and push down. Securely screw the cap on the pole over the
connector by turning it clockwise
3. To attach the clothes rack, align tabs in clothes rack with grooves on pole and push
down.
4. Fully extend the telescopic pole by opening the 3 clips on the pole and pulling the
pole upwards. When fully extended close the clips. Ensure that the pole is securely
locked into place and cannot be pushed downwards.
5. Insert and turn on the hose connector until it is locked. You may hang the steamer
handle on the Handle Hook
NOTE: Do not hang the hose on the hanger attachment until after it has been
connected on the base to prevent the hose from falling.
OPERATING INSTRUCTIONS
1. Remove the water tank from the unit by grasping the handle and turning it upside
down. Unscrew the cap from the bottom of the water tank. Position and hold the
water tank under cold running water and fill to the desired level. After filling, screw
the cap back on and turn over. Place water tank back into unit and make sure it is
properly and securely positioned in the cavity.
NOTE: Only fill the water tank with cold water, DO NOT use hot water.
2. Insert the power plug into the power supply.
3. Press the power switch, and the light will illuminate. Steam will emit in 40-45
seconds.
4. When finished with garment steaming, press the power switch to power off the
appliance and remove the power plug from the power supply.
7
CLEANING AND MAINTENANCE
1. Make sure the appliance has cooled down completely. Unplug the unit from the
power supply and remove the steam hose from the main unit. Collapse the telescopic
pole.
2. Fill the water tank with fresh water and attach it to the main unit again, allowing
water to fill the boiler.
3. Remove the water tank from main unit and empty the water from the boiler
through the open hose connector into a sink. Scale to remove and rinse away
residues.
4. Repeat Steps 2 and 3 several times until scale has been removed.
PROBLEM POSSIBLE CAUSE SOLUTION
Steamer fails to heat Steamer not plugged into power Plug into a power supply
supply
The appliance is not connected to Press the power switch
the power supply
No steam Water level is low Power off the appliance and refill
the water tank
Steam is intermittent Sediment build-up in container Clean the appliance
Water drips from Condensation inside hose Hold the hose vertically and allow
nozzle water to drain back into tank
Nozzle gurgles Condensation inside hose Hold the hose vertically and allow
water to drain back into tank
TROUBLESHOOTING
MSI-GB206(IM)110117.qxp_Layout 1 1/17/17 12:37 PM Page 4
Praat mee over dit product
Laat hier weten wat jij vindt van de Morgan MSI-GB206 Kledingstomer. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.