Handleiding Orbit 94922 Besproeiingscomputer

Handleiding

11

ENGLISH

the current station to the next station in the cycle. This can

be done during scheduled, manual, or remote actuated

watering.

Section 4: Using the Remote

Control Device

NOTE: The timer will accept commands from the remote control

device only when the selection dial is turned to AUTO or OFF. (If

the selection dial is turned to any other setting, commands from the

Remote Control Device will be stored in memory and executed when

the selection dial is turned to AUTO).

Install a Battery in the Remote Control Device:

• Open the battery compartment door.

• Install a 9-volt battery in the battery compartment.

• Replace the battery compartment door.

To Synchronize the Remote Control Device

with the Timer:

The remote device provided with your timer is already synchro-

nized to your timer. If the remote is not functioning properly or

if you are adding a new remote or RF sensor to your system do

the following:

• With the remote device in your hand press the “RF Sync”

button on the timer (this will activate a red light on

the timer).

• Press the OFF button on the remote or depress the stem of

the RF sensor (the red light should start blinking).

• If the red light blinks you have successfully synchronized the

devices. If the light does not blink check that the remote has a

fresh 9V battery or that the RF sensor switch is not OFF and

try the steps again.

To Water All Stations:

• Press and release the ALL button on the remote control

device to select all stations for watering.

• Press and release the ON “X” MIN button to command the

timer to water all the stations sequentially for the desired

(“X”) number of minutes.

• If you wish to advance to the next station before a station's

watering duration is complete, press NEXT.

To Water One Station:

• Press the number of the station you wish to water.

• Press ON "X" MIN to water the station for the desired ("X")

number of minutes.

To Water More Than One Specific Station:

• Press the numbers of the stations you wish to water. (Example:

3, 7, 10, and 6. The timer will water in sequence from lowest

to the highest. 3, 6, 7, 10.) (No matter which order you press

the keys, the timer will water them sequentially from the

lowest to the highest number.)

Downloaded from www.Manualslib.com manuals search engine

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Orbit 94922 Besproeiingscomputer. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Orbit. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Orbit 94922 Besproeiingscomputer in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Orbit Besproeiingscomputers
Meer handleidingen voor Besproeiingscomputers

Beoordeling

Gerelateerde producten

Handleiding

Orbit 94874 Besproeiingscomputer

Handleiding

Orbit 94162 Besproeiingscomputer

Handleiding

Orbit 57854 Besproeiingscomputer

Handleiding

Orbit 57896 Besproeiingscomputer

Handleiding

Orbit 94148 Besproeiingscomputer

Handleiding

Orbit 91926 Besproeiingscomputer

Handleiding

Orbit 96874 Easy Dial 4 Besproeiingscomputer

Handleiding

Orbit 27894 Besproeiingscomputer

Gerelateerde categorieën