Handleiding Roper RS20CKXZL00 Koel-vries combinatie

Handleiding

Automatic ice maker

Models RS22AR and RS25AW are

equipped with a factory-installed ice

maker. The ice maker is an optional

accessory for model RSZOCK.

I

.

.

.

.

.

.

.

.

.

Connect the ice maker to the water

supply before turning it on.

Instructions for ice maker water

supply hook-up are attached to the

back of the refrigerator cabinet.

The ON/OFF lever is a wire signal

arm. Lower signal arm to make ice.

Raise signal arm to turn off the ice

maker.

Freezer must be cold enough for the

ice maker to work. This may take

eight hours or more before the right

temperature is reached.

“First” ice may be discolored or off-

flavored because of new plumbing

connections. Throw away first few

batches of ice.

Change ice cube size with the dial

or lever on the side of the ice maker.

Ice crescents are normally attached

at the corner. They break apart

easily.

Normal sounds include water

running when the ice maker is

working and the thud of ice as it

falls into the bin.

If ice is not being made fast enough

and more ice is needed, turn the

Refrigerator Control to a higher

number. Wait 24 hours, and if this

does not increase the ice supply,

turn the Freezer Control to C.

Raise the signal arm before you

remove the ice bin. When you

replace the bin, push it in a.ll the

way. Then lower the arm to the ON

position.

Cubes left in the bin for long

periods of time may develop an off-

flavor, like stale water. Throw old

cubes away. Cubes may also

become smaller if stored for a long

time.

.

Good water quality is important for

good ice quality. It is not

recommended that you connect the

ice maker to a softened water

supply. If a softened water supply

cannot be avoided, it is important to

maintain the water softener so it

operates properly. Water softener

chemicals, such as salt from a

malfunctioning softener, can

damage the ice maker mold and

lead to poor quality ice.

Ice cube trays

(Model RSZOCK)

Remove ice by slightly twisting the tray

with both hands.

NOTE:

The longer ice cubes are stored,

the smaller they get. Slow evaporation is

caused by the movement of cold air.

Cold water and ice dispenser

(M&de1 RS25AW)

Ice dispenser only

(Model RS22AR-1 dispenser arm)

The small tray below the dispenser is

designed to evaporate

small

spills. Do

not pour water into it. There is no drain

in this tray.

Dispensing ice:

1. Press a

sturdy

glass against the ice

dispenser bar. (Pressure and

tumbling ice can break a fragile

glass.)

2. Remove glass to stop dispensing.

NOTE:

“First” ice may be discolored or

off-flavored because of new plumbing

connections. Throw away first few

batches of ice.

Ice comes from the ice maker storage bin

in the freezer. When the dispenser bar is

pressed, ice falls through a chute

between the ice bin and dispenser and

out an open trap door. When the

dispenser bar is released, a faint buzzing

sound may be heard for a few seconds

as the trap door closes

Dispensing water:

1, Press a

sturdy

glass against the

water dispenser bar. (Pressure can

break

a

fragile glass.)

2. Remove glass to stop dispensing.

Chilled water comes from a 50-ounce

(1.5 L) tank (approximate) behind the

meat drawer. When the refrigerator is

first hooked up, rinse the tank and pipes

by pressing the water dispenser bar

with a sturdy glass or jar. Discard 2 to 3

quarts (1.9 to 2.8 L). Then allow the first

tankful of water to chill for several hours.

Removing ice maker storage

bin

Remove, empty and clean ice maker

storage bin if: ice dispenser has not or

will not be used for a week or more; a

power failure causes ice to melt and

freeze together; or ice dispenser is not

used regularly.

1. Lift covering panel up from the

bottom and slide it back to the rear.

2. Lift the ice maker signal arm until it

clicks into the OFF position. Ice can

be dispensed, but no more will be

made.

3. Lift the front of the storage bin and

pull the bin out.

4. Empty the bin. Use hot or warm

water to melt any remaining ice.

Do

not use sharp objects to break up

ice in the bin. This can damage

the bin and dispenser mechanism.

5. Wash the bin with mild detergent.

Rinse well.

Do not use harsh or

abrasive cleaners or solvents.

6. Slide the bin back into place. Make

sure it is pushed in all the way.

7. Lower the signal arm to the ON

position to restart ice production.

8.

Lower covering panel.

Cold water and ice dispenser

tips

. Use only ice crescents from the ice

maker. Other shapes will not

dispense properly.

. Large amounts of ice (more than 2

glasses) should be taken from the

ice maker storage bin, not the

dispenser. The dispenser motor

may stop if the dispenser bar is held

in too long. If the motor stops, it will

restart in about 3 minutes.

Page 7

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Roper RS20CKXZL00 Koel-vries combinatie. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Roper. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Roper RS20CKXZL00 Koel-vries combinatie in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Roper Koel-vries combinaties
Meer handleidingen voor Koel-vries combinaties

Veelgestelde vragen over Roper RS20CKXZL00 Koel-vries combinatie

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Roper RT18DKXFN01 Koel-vries combinatie

Handleiding

Roper RS20AKXDW00 Koel-vries combinatie

Handleiding

Roper RS20EKXBL00 Koel-vries combinatie

Handleiding

Roper RT18DKXKT09 Koel-vries combinatie

Handleiding

Roper RS20EKXBW00 Koel-vries combinatie

Handleiding

Roper RS20DKXDN00 Koel-vries combinatie

Handleiding

Roper RT18DKXKT06 Koel-vries combinatie

Handleiding

Roper RT18DKYWW01 Koel-vries combinatie

Gerelateerde categorieën