Handleiding Shure WCM16 Headset

Handleiding

Model WCM16 User Guide

MODEL WCM16 ISOMAX* HEAD-WORN CONDENSER MICROPHONE

GENERAL

The Shure Model WCM16 head-worn electret condenser

microphone is intended for wireless use by performers, lec-

turers, and others who require the highest quality voice pick-

up with maximum mobility. Its wide frequency response, low

RF susceptibility and reliable operation at temperature and

humidity extremes make the WCM16 suitable for virtually

any vocal application. When used with the Shure Body-Pack

Transmitters, the performance of the WCM16 closely resem-

bles the finest conventional vocal microphones.

Miniaturized active circuitry included in the cartridge as-

sembly provides equalization that tailors the low-frequency

response to resemble the warm proximity effect of larger vo-

cal microphones. Because of this low-end response, it is not

necessary to position the microphone directly in front of the

mouth, thus avoiding much popping and breath noise, even

without the supplied foam pop screen.

The microphone's hypercardioid unidirectional pickup

pattern provides maximum isolation from ambient noise and

from adjacent sound sources such as musical instruments,

loudspeakers and other performers. This permits higher

gain-before-feedback without loss or masking of vocals.

FEATURES:

• Extra lightweight, adjustable headband stays secure

and virtually disappears while being worn

• Response comparable to the finest conventional vocal

microphones

• Hypercardioid polar pattern provides maximum isola-

tion from vocalist's own instrument and those of other

performers

• Uniform polar pattern at all frequencies for maximum

gain before feedback

• High input clipping level eliminates overload distortion

• Supplied acoustic foam pop screen

• Reliable at temperature and humidity extremes

WEARING THE MICROPHONE HEADSET

1. Place the microphone on the user's head so that the

large diameter band is horizontal across the back of the

head. The band may be completely hidden under the

hair. The ends of the headband should fit comfortably

in front of the ears. Extend or retract the adjustable

headband (see Figure 1) to achieve this result.

2. For maximum gain before feedback, carefully extend or

retract the boom (see Figure 1) so that the microphone

grille (silver side) is within 40 mm (1-1/2 in.) of the left

corner of the mouth. It may be necessary to bend the

headband tube just in front of the left ear for optimum

microphone positioning. A slight bend downward and/

or away is usually sufficient.

NOTE: The headband tubing will not withstand

repeated bending, so make this adjustment only once,

if necessary.

3. If breath noise or popping is audible, install the sup-

plied pop screen so that the red dot on the pop screen

corresponds to the location of the microphone grille.

POSITIONING THE MICROPHONE PICKUP

The hypercardioid unidirectional pickup pattern of the

WCM16 has maximum rejection of unwanted sound sourc-

es at about a 110° angle each way from the front axis of the

microphone (see Figure 1). Directly to the rear of the micro-

phone (at 180°) there is as little as 6dB rejection-not much

less pickup than at the front of the microphone (at 0°).

Sound sources that may cause feedback (such as moni-

tor or P.A. speakers) or sound that you do not want to pick

up with the WCM16 (such as percussion instruments or oth-

er performers) should NOT be placed directly to the rear of

the microphone. It is better to adjust positioning so that un-

wanted sound sources are located at the 110° maximum re-

jection points. Note that when wearing the headset the rear

of the microphone points out towards the wearer's left.

1.5 M

(5 FT)

POP SCREEN

CARTRIDGE

ADJUSTABLE

HEADBAND

ADJUSTABLE

BOOM

12.7 MM

(1/2 IN.)

57.2 MM

(2-1/4 IN.)

CABLE

TA4F

CONNECTOR

PARTS OF THE WCM16 HEAD-WORN MICROPHONE

FIGURE 1

Printed in U.S.A.©2006 Shure Incorporated

27D2631 (Rev.6)

*WCM16 is manufactured by Countryman Associates

ISOMAX is a trademark of Countryman Associates

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Shure WCM16 Headset. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Shure. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Shure WCM16 Headset in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Shure Headsets
Meer handleidingen voor Headsets

Beoordeling

Veelgestelde vragen over Shure WCM16 Headset

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Shure SM31FH Headset

Handleiding

Shure TH53 Headset

Handleiding

Shure SM10A Headset

Handleiding

Shure DH5 Headset

Handleiding

Shure SM35 Headset

Handleiding

Shure BRH440M Headset

Handleiding

Shure BRH31M Headset

Handleiding

Shure BRH441M Headset

Gerelateerde categorieën