Handleiding Smeg KT110AS Afzuigkap

Handleiding

WARNING!

• Read the instructions carefully before installing and/or using the hood.

• Before connecting, make sure that the mains voltage corresponds to the voltage on

the rating plate inside the hood. (see fig. 7)

• Once you remove the appliance from its packaging make sure it is intact. If the

product is damaged, do not use it and contact the Smeg assistance network.

•

It is recommended that a qualified technician performs installation and adjustment

operations

.

• The minimum distance between the cooker and the lower part of the hood must be

750mm for gas cookers and 650 mm for electric cookers.

• Before carrying out any kind of maintenance or cleaning, disconnect the hood from

the mains supply.

• Inspect and clean the filters thoroughly and in accordance with the intervals

suggested by the manufacturer.

• Do not cook or fry in a way that could result in flames being sucked into the hood and

causing a fire.

• The hood surface can be cleaned with a damp cloth and a non-bleach liquid

detergent.

• Make sure the room is properly ventilated when using the hood and other gas

appliances at the same time.

• Comply with the regulations on air discharge when operating the hood.

• The extracted air must not be routed into a duct used to discharge fumes of gas-

operated appliances.

• This appliance must not be used by children without an adult supervision or

by disabled people without assistance.

• THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE ABOVE

INSTRUCTIONS ARE NOT FOLLOWED.

OPERATION

This appliance has been designed to work as a

DUCTING

hood (evacuation of the

air) or RECYCLING hood (recycling of the filtered air).

• DUCTED MODE: In order to use the hood in the ducted mode, connect the motor

intake, by means of a suitable ducting hose not less than 120mm diameter, directly to

the external fumes outlet.

Note:Remove any carbon filters.

• RECIRCULATION MODE: If it is not possible to discharge fumes outside, the hood

can be used to filter and recycle the air. This way, air and fumes are filtered by the

anti-odour carbon filters and recirculated through the aerating grids on the sides of

chimney.

EN 01

INSTALLATION INSTRUCTIONS:

The hood is supplied with all the necessary

accessories for installation. The minimum distance

between the cooker and the lower part of the hood

must be 750 mm for gas cookers and 650 mm for

electric cookers (Fig. 1). The hood is supplied with a

motor intake (Fig 2). If it has not been assembled by

the manufacturer, you can assemble it using the

supplied screws (for type 1) or pushing (for type 2)

If the motor intake is equipped with a non-return

valve, make sure it opens and closes perfectly.

The following instructions will assist installation:

a) The hood should be centred with respect to the

cooker.

b) The hood is supplied with two supports/hooks (a)

(Fig 3) or bracket (b) that need to be fixed to the

wall by means of wall anchors . The L1 holes for

these supports are on the back of the hood (fig.

4)

c) Remove the anti-grease filters, put the hood on

the wall and mark the position of the holes for the

supports/hooks.

d) Drill the two previously marked holes after

removing the hood from the wall.

e) Fix the two supports/hooks to the wall.

f) Mark the L2 holes on the wall to fix the hood

safely. (fig. 4) Drill and put the anchors in the

holes.

g) Hang the hood on to the supports/hooks (fig. 5)

and level by means of the adjusting screw

(

fig.3

).

l) Fix the hood safe by tightening both wall anchors.

Ducted mode or Recirculation mode installation:

Ducted mode:

In the ducted mode, connect the motor outlet to the

fumes outlet duct not less than 120mm diameter.

Warning: if the hood is equipped with an active

carbon filter, it must be removed (see page 7)

EN 02

Fig.2

Hood levelling screw

Fig.3

Type 1

Type 2

Fig.1

(a)

(b)

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Smeg KT110AS Afzuigkap. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Smeg. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Smeg KT110AS Afzuigkap in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Smeg Afzuigkappen
Meer handleidingen voor Afzuigkappen

Veelgestelde vragen over Smeg KT110AS Afzuigkap

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Smeg KIV90XT-2 Afzuigkap

Handleiding

Smeg KSG9P4X Afzuigkap

Handleiding

Smeg KSCB124X Afzuigkap

Handleiding

Smeg KSG52HPE Afzuigkap

Handleiding

Smeg KS89POE Afzuigkap

Handleiding

Smeg KSG6P4X Afzuigkap

Handleiding

Smeg KBCT900XE Afzuigkap

Handleiding

Smeg KICV90BL2 Afzuigkap

Gerelateerde categorieën