Handleiding Sony M-435P Cassetterecorder
Handleiding voor je Sony M-435P Cassetterecorder nodig? Hieronder kun je de handleiding gratis bekijken en downloaden als PDF in het Nederlands en/of Engels. Dit product heeft 0 veelgestelde vragen, 0 comments en heeft 0 stemmen. Is dit niet de handleiding die je zoekt, neem dan contact met ons op.
Is je product kapot en biedt de handleiding geen oplossing meer? Dan kun je voor reparatie gratis terecht bij Repair Café.
Handleiding
Loading…
Playing a Tape
1 Insert a cassette with the side to start playing facing the lid.
2 Select the tape speed to the same speed as that used for
recording.
3 Press n.
4 Adjust the volume.
To Press or slide
Stop playback/stop fast xZ
forward or rewind*
Pause playback Slide >PAUSE in the direction of the arrow.
The REC/BATT (M-535V/530V) or BATT
(M-435P/430) lamp goes off.
Fast forward Slide mCUE/MREVIEW toward mCUE
during stop.
Rewind Slide mCUE/MREVIEW toward
MREVIEW during stop.
Search forward during Keep mCUE/MREVIEW pushed down
playback (CUE) during playback and release it at the point
you want.
Search backward during Keep mCUE/MREVIEW pushed up
playback (REVIEW) during playback and release it at the point
you want.
* If you leave the unit after the tape has been wound or rewound, the
batteries will be consumed rapidly. Be sure to depress xZ.
Note
If the tape is completely wound or rewound while searching forward/
backward during playback (CUE/REVIE), the mCUE/MREVIEW
switch may not return to the center position when you release the switch.
In this case, push back the switch to the center to start playback.
If you plug in headphones (not supplied) to the EAR jack, you
will get monaural output from both left and right channels.
At the end of the tape
In the recording or playback mode, the tape stops at the end of
the tape and the locked buttons will be released automatically
(Automatic shut-off mechanism).
After fast forward or rewind, be sure to set mCUE/
MREVIEW back to the center.
Dubbing onto another tape
recorder
Connect another tape recorder to the EAR jack using the RK-
G64HG connecting cord (not supplied).
Set this unit to the playback mode and another tape recorder to
the recording mode.
Precautions
On power
•Operate the unit only on 3 V DC.
For AC operation, use the AC adaptor recommended for the
unit. Do not use any other type. For battery operation, use two
R6 (size AA) batteries.
On the unit
•Use only the (standard microcassettes) with this
unit. Non-standard cassettes cannot be used because their “L”
dimension (see illustration) is different.
•Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or mechanical
shock.
•Should any solid object or liquid fall into the unit, remove the
batteries or disconnect the AC power adaptor, and have the
unit checked by qualified personnel before operating it any
further.
•Keep personal credit cards using magnetic coding or spring-
wound watches etc. away from the unit to prevent possible
damage from the magnet used for the speaker.
•When you do not use the unit for long, remove the batteries to
avoid damage caused by battery leakage and subsequent
corrosion.
•If the unit has not been used for long, set it in the playback
mode and warm it up for a few minutes before inserting a
cassette.
If you have any questions or problems concerning your unit,
please consult your nearest Sony dealer.
Troubleshooting
Should any problem persist after you have made these checks,
consult your nearest Sony dealer.
A cassette cannot be inserted.
t The cassette is being inserted in the wrong way.
t n has been already pressed.
Playback cannot be made.
t The tape has reached the end. Rewind the tape.
t The batteries are weak. Replace both batteries with new
ones.
t The head is contaminated.
Recording cannot be made.
t There is no cassette in the cassette compartment.
t The cassette tab has been removed.
t The batteries are weak. Replace both batteries with new
ones.
t The head is contaminated.
t Improper setting of the VOR switch (M-535V/530V only).
House current
Connect the AC power adaptor to DC IN 3V and to a wall outlet.
Use the AC-E30HG AC power adaptor (not supplied). Do not
use any other AC power adaptor.
Note
Specifications for AC-E30HG vary for each area. Check your local voltage
and the shape of plug before purchasing.
Recording
1 Press the reset button of the TAPE COUNTER
(M-535V/530V only).
2 Press xZ and insert a standard microcassette with the side
to start recording facing the lid.
3 Select the desired tape speed.
2.4 cm for optimum sound (recommended for normal use):
A 30-minute recording can be made using both sides of the
MC-30 microcassette.
1.2 cm for longer recording time: A 60-minute recording can
be made using both sides of the MC-30 microcassette.
4 Set VOR to H, L or OFF (M-535V/530V only).
If you set VOR to H or L, the unit automatically starts
recording the sound and pauses when there is no sound
(you can save tapes and batteries).
H: To record at meeting or in a quiet and/or spacious place.
L: To record for dictation or in a noisy place.
When the sound is not loud enough, set it to OFF, or the unit
may not start recording.
5 Press z.
n is pressed simultaneously and recording starts. While
the tape runs, the REC/BATT lamp lights and flashes
depending on the strength of the sound (M-535V/530V
only).
Recording level is fixed.
To Press or slide
Stop recording xZ
Start recording during playback z during playback (the unit becomes
in the recording mode)
Review the portion just recorded Push up mCUE/MREVIEW
toward MREVIEW during the
recording. Release the button at the
point to start playback.
Pause recording Slide >PAUSE in the direction of
the arrow. The REC/BATT (M-
535V/530V) or BATT (M-435P/430)
lamp goes off.
Take out a cassette xZ
Note
Select the 2.4 cm tape speed for recording, if you play back the recorded
tape with another unit. Otherwise, the sound quality may be changed.
Notes on VOR (Voice Operated Recording) (M-535V/530V
only)
• The VOR system depends on the environmental conditions. If you
cannot get the desired results, set VOR to OFF.
• When you use the system in a noisy place, the unit will stay in the
recording mode. If the sound is too soft, on the contrary, the unit will
not start recording. Set VOR to H (high) or L (low) depending on the
conditions.
To monitor the sound
Connect an earphone (not supplied) to EAR jack. The monitor
volume cannot be adjusted by VOL.
To prevent a cassette from being accidentally recorded
over
Break out and remove the cassette tabs. To reuse the cassette for
recording, cover the tab hole with adhesive tape.
This warranty is valid only in the United
States.
M-535V/530V/435P/430
Operating Instructions
Mode d’emploi (voir verso)
Sony Corporation © 1999 Printed in China
3-865-285-13 (1)
Microcassette
™
-Corder
For customers in the United States
Owner’s Record
The model number is located at the bottom and the serial
number is located inside the battery compartment. Record
these numbers in the spaces provided below. Refer to these
numbers whenever you call upon your Sony dealer
regarding this product.
Model No. Serial No.
About This Manual
The instructions in this manual are for 4 models. The M-535V is
the model used for illustration purposes.
Their differences are shown in the table below:
M-535V M-530V M-435P/430
TAPE COUNTER aa—
BATT lamp a (REC/BATT) a (REC/BATT) a
REC lamp a (REC/BATT) a (REC/BATT) —
VOR aa—
Handstrap aa
—
a: provided or supplied —: not provided or not supplied
Preparing Power Sources
Choose one of the following power sources.
Dry Batteries
Make sure that nothing is connected to the DC IN 3V jack.
1 Open the battery compartment lid.
2 Insert two R6 (size AA) batteries with correct polarity and
close the lid.
To take out the batteris
If the battery compartment lid is accidentally
detached
Attach it as illustrated.
When to replace the batteries
Replace the batteries with new ones when the REC/BATT
(M-535V/530V) or BATT (M-435P/430) lamp dims.
Note
You do not need to replace the batteries if the REC/BATT lamp or BATT
lamp flashes with the playback sound when you turn up the volume.
Battery life (Approx. hours) (EIAJ*)
Batteries Recording
Sony manganese R6P (SR) 7
Sony alkaline LR6 (SG) 24
* Measured valued by the standard of EIAJ (Electronic Industries
Association of Japan) (Using a Sony Microcassette)
Note
The battery life may shorten depending on the operation of the unit.
Polarity of the plug
Standard
Only standard microcassettes
have a small indention of side A.
Non-standard
Approx. 5 mm Approx. 2.5 mm
Recording is interrupted.
t The VOR switch (M-535V/530V only) is set to H or L.
When you do not use VOR, set it to OFF.
During CUE/REVIEW the tape stops or does not run.
You cannot fast-forward or rewind.
t The batteries are weak. Replace both batteries with new
ones.
The unit does not operate.
t The batteries have been inserted with incorrect polarity.
t The batteries are weak. Replace both batteries with new
ones.
t>PAUSE is slid in the direction of the arrow.
t The AC power adaptor is connected to the unit only and
you are going to use the unit on batteries.
No sound comes from the speaker.
t The earphone is plugged in.
t The volume is turned down completely.
The sound drops out or comes with excessive noise.
t The volume is turned down completely.
t The batteries are weak. Replace both batteries with new
ones.
t The head is contaminated. See “Maintenance”.
Tape speed is too fast or too slow in the playback
mode.
t Improper setting of the TAPE SPEED switch. Set it to the
same speed as that used for recording.
Recording cannot be erased completely.
t The head is contaminated.
Maintenance
To clean the tape head and path
Press n and wipe the head, capstan and the pinch roller with a
cotton swab, moistened with alcohol every 10 hours of use.
To clean the exterior
Use a soft cloth slightly moistened in water. Do not use alcohol,
benzine or thinner.
Specifications
Tape
(normal position type)
Recording system
2-track 1-channel monaural
Speaker
Approx. 3.6 cm (1
7
⁄16 in.) dia.
Tape speed
2.4 cm/s (
15
⁄16 ips), 1.2 cm/s (
15
⁄32 ips)
Frequency range
300 - 4,000 Hz (with TAPE SPEED switch at 2.4 cm/s)
Output
Earphone jack (minijack) for 8 - 300 ohms earphone
Power output (at 10% harmonic distortion)
M-535V/530V 250 mW
M-435P/430 160 mW
Power requirements
3 V DC batteries R6 (size AA) × 2/External DC 3V power sources
Dimensions (w/h/d)
Approx. 62.2 × 121.5 × 24.3 mm (2
1
⁄2 × 4
7
⁄8 ×
31
⁄32 in.) incl. projecting
parts and controls
Mass
Approx. 125 g (4.5 oz)
Supplied accessories
Microcassette tape MC-30 (3) (M-535V for U.S.A., Canada and Europe
only)
Microcassette tape MC-60 (6) (M-435P for U.S.A. only)
Batteries LR6 (SG) (2) (M-535V for Canada and Europe and M-435P
for U.S.A. only)
Design and specifications are subject to change without notice.
AC power adaptor (not supplied)
to the wall outlet
Microphone
REC/BATT
z
> PAUSE
m CUE/
REVIEW M
xZ
Pinch roller
Capstan
Head
Voor de Klanten in Nederland (alleen de M-535V)
Bij dit product zijn batterijen geleverd. Wanneer
deze leeg zijn, moet u ze niet weggooien maar
inleveren als KCA.
EAR
VOR
TAPE SPEED
TAPE COUNTER
EAR
VOL
n
> PAUSE
m CUE/
REVIEW M
xZ
TAPE SPEED
Insert the # side
first for each
battery.
xZ
Loading…
Beoordeling
Laat ons weten wat je van de Sony M-435P Cassetterecorder vindt door een beoordeling achter te laten. Wil je je ervaringen met dit product delen of een vraag stellen? Laat dan een bericht achter onderaan de pagina.Meer over deze handleiding
We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Sony M-435P Cassetterecorder. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Sony. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Sony M-435P Cassetterecorder in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.
Specificaties
| Merk | Sony |
| Model | M-435P |
| Categorie | Cassetterecorders |
| Bestandstype | |
| Bestandsgrootte | 0.29 MB |
Alle handleidingen voor Sony Cassetterecorders
Meer handleidingen voor Cassetterecorders
Praat mee over dit product
Laat hier weten wat jij vindt van de Sony M-435P Cassetterecorder. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.