Handleiding Thor HRH3003U Afzuigkap

Handleiding

Electrical requirements and installation requirements

Power

Requirements

IMPORTANT

Observe all governing codes and ordinances. The customer is responsible for: Contacting an electrician-installer. Check that

the electrical installation is adequate and in conformance with the National Electrical Code, ANSI / NFPA 70 (latest edition *)

or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 (the latest edition **) of the CSA, and all

codes and ordinances in your area. If codes permit and use a wire to separate the ground, it is recommended to check the

path of the wire by an electrician. Do not put the device to land on a gas line. Consult a qualified person if you are not sure

that

the

hood

is

properly

grounded

electrically.

Do

not

install

a

fuse

in

the

neutral

circuit

or

circuit

ground.

Location of the electrical installation

• The cable must enter the rear wall at least 20 to 1/4 "above the height of the installation base, and between 7-5/8" and 4-7/8

"from the left side of the middle line.

MPORTANT

Keep these instructions in order to return them to the electrical inspector. The hood must be plugged directly into a 110 volt

wall outlet.

Before installing the hood

1.

To

ensure

the

most

efficient

ventilation

possible,

install

the

pipe

in

a

straight

line

or

with

the

least

elbows

possible.

CAUTION:

The output of the vent pipe should give to the outside.

2.

Two

people

are

required

for

installation.

3. Supplied hardware can secure the hood to most walls and ceilings, consult a qualified installer to ensure that the hardware

provided is suitable for your type of wall or cabinet.

4. In the case of areas prone to COLD WEATHER, install a check against extra-circulation to minimize the cold air return and

a nonmetallic thermal break to minimize conduction of outside temperature in the duct. The valve must be placed on the side

of

the

cold

air

from

the

heat

insulator.

The

insulation

must

be

placed

as

close

as

possible

to

where

the

pipe

enters

the

heated

part of the house.

5.

Air

booster:

The

building

code

in

your

area

may

require

the

use

of

a

make-up

air

system

if

you

use

a

ventilation

system

which leads the movement of air exceeding a certain number of CFM. The number of ft3/min varies from one region to

another. Consult your HVAC professional for specific requirements in your area.

Remove

the

packaging.

CAUTION

:

Carefully remove the cardboard, gloves to protect against sharp edges.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Thor HRH3003U Afzuigkap. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Thor. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Thor HRH3003U Afzuigkap in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Thor Afzuigkappen
Meer handleidingen voor Afzuigkappen

Veelgestelde vragen over Thor HRH3003U Afzuigkap

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Thor HRH4805U Afzuigkap

Handleiding

Thor HRH3604U Afzuigkap

Handleiding

Thor HRH3603U Afzuigkap

Handleiding

Thor HRH3004U Afzuigkap

Handleiding

Thor HRH3001U Afzuigkap

Handleiding

Thor HRH3002U Afzuigkap

Handleiding

Thor HRH3602U Afzuigkap

Handleiding

Thor HRH3601U Afzuigkap

Gerelateerde categorieën