3
OTHER REQUIRED EQUIPMENT
To operate the Nitro Stampede, you will need these additional items.
All of these items should be available from your hobby shop.
1. 12 “AA” size batteries for your transmitter (8) and receiver (4)
2. Small Phillips head and flat screwdrivers (for adjustments)
3. After-run oil (to protect the engine from corrosion)
THE TQ
™
RADIO SYSTEM
The Nitro Stampede Model 4109 is equipped with the 2-channel
TQ radio system. The following radio system terms will be used
throughout the rest of these operating instructions.
Channel - The 27 MHz (megahertz) frequency band is divided
into six channels so that up to six models can be operated
simultaneously. Each channel is referred to by its flag color and
channel number, as shown below.
Clearing your frequency - A routine, verbal check to make sure
nobody else in your area is operating on the same channel. Always
clear your frequency by calling out your channel number before
operating your model. Wait or move to another area if your
channel is already being used.
Crystal (X-tal) - The plug-in device that determines on which
channel the radio system will operate. For each channel, there are
two crystals, one for the receiver and one for the transmitter. Of
those two crystals, the one marked “RX” with the lower number
(.455 MHz lower) must be inserted into the receiver.
Frequency band - The radio frequency used by the transmitter
to send signals to your Nitro Stampede. All Traxxas RTR models
operate on a 27 MHz frequency band.
mAh – Abbreviation for milliamp hour. Measure of the capacity of
the battery pack. The higher the number, the longer the battery
will last between recharges.
Neutral position - The standing position that the servos seek when
the transmitter controls are at the neutral setting.
NiCad - Abbreviation for nickel-cadmium. The original rechargeable
hobby pack, NiCad batteries have very high current handling, high
capacity, and can last up to 1000 charging cycles. Good charging
procedures are required to reduce the possibility of developing a
“memory” effect and shortened run times.
NiMH - Abbreviation for nickel-metal hydride. Rechargeable NiMH
batteries offer high current handling, and much greater resistance
to the “memory” effect. NiMH batteries generally allow higher
capacity than NiCad batteries. They can last up to 500 charge
cycles. A peak charger designed for NiMH batteries is required
for optimal performance.
Receiver - The radio unit inside your Nitro Stampede that receives
signals from the transmitter and relays them to the servos.
Servos - Small motor units in your Nitro Stampede that operate the
throttle and steering mechanisms.
Two-channel radio system - The TQ radio system, consisting of
the receiver, the transmitter, and the servos. The system uses
two channels: one to operate the throttle and one to operate
the steering.
Transmitter - The hand-held radio unit that sends throttle and
steering instructions to your Nitro Stampede.
Trim - The fine-tuning adjustment of the neutral position of the
servos, made by turning the throttle and steering trim knobs on
the face of the transmitter.
INSTALLING TRANSMITTER BATTERIES
Install 8 “AA” batteries into the bottom of the
transmitter as shown in the drawing.
Antenna
Power Indicator
Steering Trim
Throttle Trim
Throttle Neutral Adjust
Throttle Trigger
Steering Wheel
Power Switch
Servo Reversing Switches
Steering (R), Throttle (L)
Battery
Compartment
27MHZ FLAG COLOR CH# TRAXXAS PART#
26.995 BROWN 1 2031
27.045 RED 2 2032
27.095 ORANGE 3 2033
27.145 YELLOW 4 2034
27.195 GREEN 5 2035
27.255 BLUE 6 2036
CHANNEL 1
STEERING
SERVO
CHANNEL-2
THROTTLE
SERVO
4-CELL
BATTERY HOLDER
PART# 3170
CHANNEL-1
ANTENNA
RECEIVER
ON/OFF
SWITCH
BLACK
NEGATIVE
RED
POSITIVE
CHANNEL-2
BATTERY
WIRE COLORS
BLACK
RED
WHITE
Praat mee over dit product
Laat hier weten wat jij vindt van de Traxxas Nitro Stampede Radiobestuurbare auto. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.