10
11. Mud guard set (no illustration)
Replacement for the standard mud guards, if these cannot be
adapted to the Trumove S / T.
Part. no. 60031-08200
Installation is not possible in some cases because of
attachments to the underbody. Contact your dealer if
necessary.
The Trumove S / T is not approved for installation
on caravans / trailers with any other chassis!
Detailed installation instructions are provided with the
relevant mounting set.
No holes may be drilled into or welding work performed on
the vehicle frame (except when using the low chassis kit* and
the Eriba-Touring mounting set). Under no circumstances re-
move any suspension components from the chassis.
* In the case of the AL-KO Vario III / AV Chassis, never drill
into the vehicle frame even if the flat frame kit is used.
Choice of location
The Trumove S / T should preferably be installed in front of the
axle, but can also be installed behind the axle under special
circumstances (e.g. lack of space). Only the bolts that are pro-
vided must be used to secure the Mover® (or the add-on parts
provided as special accessories).
Mud guards
When a Trumove S / T is fitted, the existing mud guards may
have to be moved or adapted (max. distance between tyre /
mud guard 300 mm).
If the original mud guards cannot be used, the Truma mud
guard set (part no. 60031-08200) must be used and adapted.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
max. 200 mm
Driving direction
max.
300 mm
Trumove S / T
Fig. 19
Adapting the mud guards to the Trumove S / T
1. Remove the mud guards.
2. Fit Trumove S / T according to the following installation
instructions
3. Determine dimensions a and b and transfer to mud guards.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Determining the cut-out dimensions
a
b
a
b
Trumove S / T
Fig. 20
Cut out the template on the last page of the installation in-
structions, place it onto the mud guard, transfer the contours
and cut out.
Pay attention to left and right sides.
If necessary, make recesses in mud guard for apron contour
and attach mud guard to underside of caravan 300 mm from
tyre.
Installation of the drive units
The frame of the vehicle must be kept free of rust and
heavy soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be
of the same size and model and inflated as per the manufac-
turer’s instructions.
Remove all components from packing and place on the floor.
Fig. 21
The provided factory plates (f) must be attached on the
left and right sides of the cross strut between the drive
unit retaining plates.
f
Fig. 22
Mark connection pipe in the centre. Loosely attach the drive
assemblies to the connection pipe.
Do not screw in the supplied threaded bolts (g) yet.
Praat mee over dit product
Laat hier weten wat jij vindt van de Truma Trumove T Caravanmover. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.