14
j
B 3.9 x 33
(3 x)
i
h
g
PT 4 x 10
k
Fig. 36
Secure safety socket to the (plastic) shaft cover of the cara-
van with 4 bolts, nuts and washers.
M 4 x 16
(4 x)
Washer 4,3
(4 x)
Nut M 4 (4 x)
Fig. 37
No holes must be drilled in the chassis.
Alternatively, the safety socket can be secured using the two
worm drive hose clamps.
Fig. 38
Lay one wire to the control unit (this may have to be short-
ened), crimp the flat connector and then connect as shown in
the wiring diagram.
Lay the second wire to the control unit (this may have to be
shortened), crimp the ring lug and then screw to the negative
terminal of the battery as shown in the wiring diagram.
The connection to the control unit follows the following
sequence – nut, ring lug, negative battery connection,
nut, ring lug cable safety socket, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
Commissioning the Trumove S / T
Check whether the battery is fully charged for operating the
Trumove S / T and that the isolating switch is in the “ON”
position.
Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from
the tyres and the corner steadies are raised.
Connect battery terminals to battery, check that all cables are
secure and not hot or indicating signs of short circuits, etc.
Plug the 7-pin or 13-pin plug into the safety socket.
If there is a fault in both caravan brake lights, the power
circuit of the safety socket is not closed. In this case the
Trumove S / T cannot be operated.
Move slide switch on remote control to the “On”
❙ position.
This switches the remote control on – green LED flashes for
5 seconds in combination with the acoustic alarm until the
control unit is ready for operation. If LED does not illuminate,
check polarity and condition of batteries in remote control.
The remote control switches itself off after about 2 minutes if
no buttons are pressed.
Check whether both drive motors are stationary. Press the
“forwards” button with the remote control switched on – both
drive motors must now move in the forward direction.
Engage the drive rollers against the tyres by using the remote
control.
Please ensure that there are no obstructions beneath the cara-
van, then release the handbrake. Now check all functions as
per the operating instructions.
Apply caravan handbrake. Disengage the drive rollers and
move slide switch on remote control to the “Off”
posi-
tion to switch the remote control and the Trumove S / T off.
Re-check distance between drive rollers and tyres. Adjust if
necessary.
The distance between the disengaged drive rollers and
the tyres is 20 mm.
Warnings
The yellow sticker with the warning information, which is
enclosed with the appliance, must be affixed by the installer
or vehicle owner to a place in the vehicle where it is clearly
visible to all users (e.g. on the wardrobe door)! Ask Truma to
send you a sticker, if necessary.
Praat mee over dit product
Laat hier weten wat jij vindt van de Truma Trumove T Caravanmover. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.