Handleiding Truma Trumove T Caravanmover

Handleiding

4

When the Trumove S / T is switched off

using the remote control, the control unit

remains in standby. In order to switch off com-

pletely the battery must be disconnected or

switched off using the isolating switch.

Batteries

We recommend the Truma Mover® PowerSet which contains

batteries with round cell technology and a matching charger

to ensure optimum operation. Drive, lighting and gel batteries

with adequate capacities are also suitable.

Recommended battery capacities

Round cell technology min. 55 Ah

Gel / AGM min. 70 Ah

Lead-acid battery (liquid electrolyte) min. 80 Ah

Starter batteries are not suitable

Batteries with a greater capacity allow longer operation.

Charger

To ensure that the batteries are charged to the optimum, we

recommend the Truma charger BC 10 that is suitable for all

battery types up to 200 Ah.

Battery care (also maintenance-free batteries)

The following points should be observed to extend the

battery life:

– Batteries should be fully charged before and after they have

been used.

– Disconnect from the power circuit in the case of longer

standstills (e.g. with a circuit-breaker or by disconnecting

the battery terminal).

– In the case of longer standstill periods, the battery must be

disconnected and charged for 24 hours at the latest every

12 weeks.

Store fully charged batteries in a cool but frost-free place

during the winter and recharge regularly (every 12weeks)

Function description

Always observe the operating instructions and “Safety

instructions” prior to starting! The vehicle owner is re-

sponsible for correct operation of the appliance.

Please note that the Trumove S is only suitable for

single-axle towed vehicles, and the Trumove T is only

suitable for dual-axle towed vehicles.

The Trumove S / T is a manoeuvring system with which a

caravan can be moved without the assistance of a towing

vehicle.

It consists of two separate drive units, each of which has a

12 Volt DC motor. These units are attached to the frame of the

vehicle near the wheels and are connected by lateral bars.

Once the drive rollers have been engaged to the tyres using

the remote control, the Trumove S / T is ready for operation.

All operation takes place using the remote control. This trans-

mits radio signals to the control unit. A separate 12 V lead-

acid battery or suitable lead-gel battery (not included in scope

of delivery) supplies the control unit with current.

Operating instructions

Remote control

a = On / Off slide switch

❙ On (green LED illuminates)

 Off (green LED goes off)

b = Caravan forwards (both wheels

rotate in forwards direction)

c = Caravan reverse (both wheels

rotate in reverse direction)

d = Caravan right forwards

(left wheel rotates in forwards

direction)

e = Caravan left forwards

(right wheel rotates in forwards

direction)

f = Caravan right reverse (left wheel

rotates in reverse direction)

g = Caravan left reverse (right wheel

rotates in reverse direction)

Fig. 2

Trumove S only

The caravan can be turned in a circle on the spot without

moving forward.

d + g = Turn caravan to the right

(left wheel rotates forwards + right wheel rotates

backwards)

e + f = Turn caravan to the left

(left wheel rotates backwards + right wheel rotates

forwards)

Trumove T only

Turning on the spot without moving forward is not possible

because of the two axles. Pressing the d, g, e or f buttons

causes the Trumove T to move in a circle, whereby the outer

motor runs continuously and the inner motor pulsates.

Trumove S / T

h = Two-hand operation, engage drive rollers

i = Two-hand operation, disengage drive rollers

To engage and / or disengage the drive rollers both keys

always need to be pressed at the same time for about

3 seconds (safety lag) until the drive rollers start to engage or

disengage.

The keys can be released again when the drive rollers move

toward the direction of the respective final position. The drive

rollers reach their final position automatically.

Pressing the two buttons for disengaging whilst the

Trumove S / T is engaging causes the procedure to be

aborted. The drive rollers will disengage and automatically

move to the end position.

The remote control switches off:

– after approx. 2 minutes, if no button is pressed

– after approx. 7 minutes, if one of the movement buttons is

permanently held down. The green LED goes off.

To reactivate the remote control, move slide switch to “Off”



and then back to “On”

❙ after approximately 1 second.

There is no “On / Off” switch on the caravan to be operated.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Truma Trumove T Caravanmover. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Truma. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Truma Trumove T Caravanmover in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Truma Caravanmovers
Meer handleidingen voor Caravanmovers

Beoordeling

Gerelateerde producten

Handleiding

Truma SX Caravanmover

Handleiding

Truma XT Caravanmover

Handleiding

Truma Mover XT4 Caravanmover

Handleiding

Truma Mover SX Caravanmover

Handleiding

Truma Mover XT Caravanmover

Handleiding

Truma Mover SE Caravanmover

Handleiding

Truma Mover TE Caravanmover

Handleiding

Truma Mover Smart M Caravanmover

Gerelateerde categorieën