Handleiding Westinghouse CHG642WB Kookplaat

Handleiding

installation

Figure 5

110mm

115mm

wall

4. Fitting the cooktop into the bench. Carry out as follows.

• Place the rubber seal provided around the edge of the hob.

NOTE: The rubber seal has talc powder applied to it’s

surface which should be wiped off with a damp cloth

after the unit has been installed.

Figure 6

hob

rubber seal

benchtop

screw

clamp

burner box

• Fit the pull-down clamps supplied to ensure that the

cooktop cannot move after installation.

WARNING

warning

Failure to fix the cooktop to the bench could result in loosening of

the gas connection through movement of the cooktop and a gas

leak may result.

• Use the 4 clamps and 4 screws supplied in the parts bag.

• To assemble, attach the 4 clamps to each corner of the

burner box via the screw provided.

• When placing the cooktop in the cut-out, swing the

clamps parallel with the box to avoid interference with the

cut-out.

• Position the cooktop so it is centred, then swing the

clamps under the benchtop and tighten.

Operation on NG/SNG

Regulator

An appliance regulator is provided. The regulator must be

positioned so that the pressure test nipple is accessible when

the appliance is installed. Connect the gas supply to the ½”

B.S.P. internal thread inlet of the regulator. Refer to ‘bench

cutout’ (Figure 4) for connection point position.

Regulators are supplied pre-adjusted and configured by the

component maker for use with Natural Gas. The appliance

installer is not required to make an adjustment to obtain the

correct outlet pressure setting.

An arrow on the base of the regulator indicates the direction

of gas flow when the inlet and outlet of the regulator is

oriented correctly. When the regulator has been fitted check

for leaks from the connections with soapy water.

Gas connection

This appliance is supplied for use with Natural Gas.

However, it can be converted for use with LPG. Refer to LP

conversion on pages 13-15.

Supply pipe sizing

The total hourly gas consumption for the appliance is shown

on the data label. The required supply pressure (i.e. at inlet

to appliance regulator) for each gas type is shown on the

data label, and given in Table 3. Use this information in

conjunction with the length of run, number of elbows, tees

and bends, the available service pressure and the supply

requirements of other installed appliances to determine

a suitable pipe size. For assistance in this matter refer to

the appropriate section of AS/NZS 5601.1 or

AS/NZS 5601.2.

An AGA certified class B or D flexible connection may be

used to connect the cooktop in accordance with AS/NZS

5601.1, in particular section 5.9 and clause 6.10.1.8, or

AS/NZS 5601.2, in particular section 2.11. Where a hose

assembly is used and the cooktop is in the installed position,

the hose assembly shall be suitable for connection to a fixed

consumer piping outlet located at a point 800 – 850mm

above the floor and in the region outside the width of the

appliance to a distance of 250mm. The point of connection

to consumer piping must be accessible with appliance

installed.

Elbow positioning

It is possible to reposition the elbow if required by loosening

the locking nut and elbow by using two spanners. Re-tighten

the entire assembly after the elbow has been repositioned.

When fitting elbow to appliance, ensure that the sealing

washer is fitted.

USING YOUR COOKTOP Gas Cooktops 11

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Westinghouse CHG642WB Kookplaat. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Westinghouse. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Westinghouse CHG642WB Kookplaat in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Westinghouse Kookplaten
Meer handleidingen voor Kookplaten

Veelgestelde vragen over Westinghouse CHG642WB Kookplaat

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Westinghouse WHG645SA Kookplaat

Handleiding

Westinghouse WHI323BD Kookplaat

Handleiding

Westinghouse WHC643BD Kookplaat

Handleiding

Westinghouse WHG955SC Kookplaat

Handleiding

Westinghouse PHR285S Kookplaat

Handleiding

Westinghouse CHG606SB Kookplaat

Handleiding

Westinghouse CHG646WB Kookplaat

Handleiding

Westinghouse WHC633BC Kookplaat

Gerelateerde categorieën