Handleiding Westinghouse WTB4600WC Koel-vries combinatie

Handleiding

INSTALLING YOUR NEW

APPLIANCE

4. Check the alignment of the refrigerator to the

surrounding cupboards to see if it is level. You can adjust

the level as detailed in step 2 and 3.

aligned to

cupboards

ie. even gap

top of refrigerator is

level ie. horizontal

adjust front feet for

uneveness of floor

eg. wind this foot

down or up

5. If you find your refrigerator rocks from corner to corner, it

means your floor is uneven. Find a piece

of plastic or hardboard etc. and pack it firmly under the

roller.

6. You may now need to fine-tune the installation by

repeating steps 3, 4 and 5.

7. When you have the appliance in its final position, it needs

to be stabilised. Wind the stability foot under the door

hinge down to the floor until it just makes contact with

the floor. Lift the front of the appliance to take the weight

off the stability foot, then turn

it half a turn further to ensure firm contact with

the floor. Wind the large height adjusting nut back

up to

ensure all the weight is now on the front stability foot.

Wind the large height adjusting nut back up to ensure all

the weight is now on the front stability foot.

8. Repeat step 7 for the stability foot on the handle side.

Whenever you need to move the appliance, be sure to

wind the feet back up so that the appliance can roll freely

and be sure to reset it when reinstalling.

stability foot

wound down

front view

9. Plug your refrigerator straight into its own power point

and never use a double adapter. If you need to roll the

refrigerator to get to the plug, remember to raise the

stability foot first.

10. Before you put any food in your refrigerator, it’s

recommended you leave it on for 2 or 3 hours to check it

is running properly.

WARNING

Connect to potable water supply only. If using tank or bore

water it is recommended to also use an external filter (not

supplied).

The new hose-sets supplied with the appliances must be

used and old hose-sets should not be reused.

Never connect the appliance to a hot water supply.

Do not use with water that is microbiologically unsafe or

with water of unknown quality without adequate

disinfection.

Water Filter

It should not be used on water that is micro biologically

unsafe or with water of unknown quality. The service life of

the filter may be reduced in water supplies that contain an

excess of particles or other impurities. Reduced flow rate is

an indication that a new filter is required. Failure to replace

the filter when required can affect the function of the ice

maker. Service calls caused by a failure to replace the filter

are not covered by warranty. Replacement water filters are

available from Electrolux Home Products

Spare Parts Centres

and can be posted to you for your convenience (refer to

spare parts contact numbers on the warranty page).

Conteentsntsof tallation kit

4 metres of water tubing

1 x 1/2” tap fitting

Water supply and plumbing

A drinkable water supply to suit a 1/2” tap fitting is required

adjacent to the refrigerator. It is recommended that a

licensed plumber install a new water supply outlet nearer to

the appliance should the tubing supplied not be long enough.

It is not recommended that the tubing be extended as this

could adversely affect the flow of water to the ice maker or

water dispenser. The water dispenser and automatic ice

maker require a drinkable water supply with a pressure range

of between 206kPa and 689kPa

(30psi and 100psi). If the water supply is above 100psi a

pressure limiting valve should be installed.

It is recommended that a noise reduction valve also be fitted

in the water supply line. This will reduce water hammer and

its effects from quick action household taps and fast acting

valves on appliances.

The refrigerator water valve is pre-fitted with a push-fit

connector for inserting the water tube. When the tap

connection is other than 1/2”, adapters can be purchased

from plumbing supply stores or good hardware stores.

ICE

A

ND WATER INSTALLATION

Fitting the handles

For models with ‘Pole’ handles, the handles are supplied

prepackaged inside your refrigerator and will require

fitting.

Refer to the instructions provided in the pack.

Congratulations! Y

ou have successfully installed your new

refrigerator

14 INSTALLATION

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Westinghouse WTB4600WC Koel-vries combinatie. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Westinghouse. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Westinghouse WTB4600WC Koel-vries combinatie in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Westinghouse Koel-vries combinaties
Meer handleidingen voor Koel-vries combinaties

Veelgestelde vragen over Westinghouse WTB4600WC Koel-vries combinatie

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Beoordeling

Gerelateerde producten

Handleiding

Westinghouse WTM5204SB Koel-vries combinatie

Handleiding

Westinghouse WTB5400WC Koel-vries combinatie

Handleiding

Westinghouse WRB5004WC Koel-vries combinatie

Handleiding

Westinghouse WBE4504SC Koel-vries combinatie

Handleiding

Westinghouse WTB3700AG Koel-vries combinatie

Handleiding

Westinghouse WTM4404SB Koel-vries combinatie

Handleiding

Westinghouse WFB4204SC Koel-vries combinatie

Handleiding

Westinghouse WTM2000WC Koel-vries combinatie

Gerelateerde categorieën