Handleiding Whirlpool W7 OS4 4S1 P BL Oven

Handleiding

EN

7

1. CONVENTIONAL

Press or to select the function, confirm by

pressing

, and then press to activate.

. CLEANING

• AUTOMATIC CLEANING  PYRO

Do not touch the oven during the Pyro cycle.

Keep children and animals away from the oven

during and after (until the room has finished

airing) running the Pyro cycle.

Remove all accessories - including shelf guides - from

the oven before activating the function. If the oven is

installed below a hob, make sure that all the burners

or electric hotplates are switched off while running

the selfcleaning cycle. For optimum cleaning results,

remove excessive residuals inside the cavity and

clean the inner door glass before using the pyrolytic

function. We recommend only running the Pyro

function if the appliance contains heavy soiling or

gives off bad odours during cooking.

Press

to show “Pyro” on the display.

Pyro

Press or to select the desired cycle, then press

to confirm. Once a cycle has been selected, if

desired, press

or to set end time (start delay),

then press

to confirm. Clean the door and remove

all accessories as prompted, then close the door and

press

when done: the oven will begin the self-

cleaning cycle, while the door locks automatically:

a warning message appears on the display, along

with a countdown indicating the status of the cycle

in progress. Once the cycle has been completed, the

door remains locked until the temperature inside the

oven has returned to a safe level.

Please note: Pyrolytic cycle can also be activated when the

tank is lled with water.

• DRAIN

The drain function allows the water to be drained in

order to prevent stagnation in the tank. For optimal use

of the appliance, it is advisable to always carry out

draining everytime the oven has been used with a

steam cycle.

Once selected the “Drain”

function, press

and follow

the actions indicated: Open

the door and place a large jug

under the drain nozzle located

at the bottom right of the panel.

Once started the draining, keep

the jug in position until the

operation is completed. The

average duration for full load drainage is about three

minutes.

If needed, it is possible to pause the draining process by

pressing BACK or STOP button (for example in case the

jug would be already full of water in the middle of the

draining process).

The jug must be at least 2 liters large.

Please note: to ensure that the water is cold, it is not possible

to perform this activity before 4 hours have elapsed from the

last cycle (or the last time the product was powered). During

this waiting time, the display will show the following feedback

“WATER IS HOT - PLEASE WAIT”.

• DESCALE

This special function, activated at regular intervals,

allows you to keep the tank and the steam circuit in

the best condition.

The message <

PLEASE DESCALE> will be shown on

display, to remind you to execute this operation

regularly.

Descale requirement is triggered by the number of

steam cooking cycles performed or steam boiler

working hours since the last descale cycle (see the

table below).

“PLEASE DESCALE” MESSAGE APPEARS

AFTER

WHAT TO DO

15 cycles of steam cooking

Descale is recommended

22 hours of steam cooking duration

20 cycles of steam cooking

It is not possible to run a

Steam cycle until a Descale

cycle will be carried out

30 hours of steam cooking duration

The descaling procedure can also be performed whenever

the user desires a deeper cleaning of the tank and the internal

steam circuit.

The average duration of the full function is around

180 minutes. Once the function is started, follow all

the steps indicated on the display.

Please note: The function can be paused but, if it is canceled

at any time, the entire descaling cycle must be repeated from

the beginning.

» PHASE 1: DRAINING (up to 3 min.)

When the display will show <PLACE A CONTAINER

UNDER NOZZLE

>, please proceed with the draining

task as described in the dedicated Drain paragraph.

Please note: to ensure that the water is cold, it is not possible

to perform this activity before 4 hours have elapsed from the

last cycle (or the last time the product was powered). During

this waiting time, the display will show the following feedback

“WATER IS HOT - PLEASE WAIT”.

The jug must be at least 2 liters large.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Whirlpool W7 OS4 4S1 P BL Oven. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Whirlpool. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Whirlpool W7 OS4 4S1 P BL Oven in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Whirlpool Ovens
Meer handleidingen voor Ovens

Veelgestelde vragen over Whirlpool W7 OS4 4S1 P BL Oven

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Whirlpool AKP9 140 C IX Oven

Handleiding

Whirlpool W7 MS450 Oven

Handleiding

Whirlpool AKZ9S 8220 NB Oven

Handleiding

Whirlpool OMR35HR0X Oven

Handleiding

Whirlpool WOES3030LS Oven

Handleiding

Whirlpool W6 OS4 4S1 P BL Oven

Handleiding

Whirlpool YWOS52ES4MZ Oven

Handleiding

Whirlpool AKP 454/WH Oven

Gerelateerde categorieën