8
WWW.BBTA.COM.AU BBT-TILL-6.5HPBS
Operation Safety
• NEVER start the engine or operate the tiller with the wheels in the free-wheel position. Make sure the
wheel lockouts or lock pins are engaged through wheel axle. The wheels act as a brake to keep the tiller at
a controlled speed.
• Disengage wheels to permit free-wheeling only when engine is stopped.
• Keep hands, feet, and clothing away from rotating parts. Keep clear of the tiller tynes at all times.
• Tynes and wheels rotate when tiller is engaged in forward or reverse-in forward, tynes and wheels rotate
when the drive safety control levers are pulled down; in reverse, wheels and tynes rotate when the reverse
handle is pulled back towards the operator. Releasing the drive safety control lever to neutral shift stops the
wheels and tynes.
• Be extremely cautious when operating in reverse. Take extra care to avoid slipping or falling, and to keep
feet clear of tynes.
• After striking a foreign object, stop the engine, remove the wire from the spark plug, thoroughly inspect the
tiller for any damage, and repair the damage before restarting and operating the tiller.
• If vegetation clogs the tynes, raise the handlebars to elevate the tynes, and run the tiller in reverse, If this
does not clean clogged vegetation from the tynes, STOP THE ENGINE AND DISCONNECT THE SPARK PLUG
WIRE before removing vegetation by hand.
• The engine muffler will be hot from operation. DO NOT touch it with bare skin or a severe burn will result.
• If the unit should start to vibrate abnormally, stop the engine and check immediately for the cause. Vibration
is generally a warning of trouble.
• NEVER run the engine in an enclosed and/or poorly ventilated area, engine exhaust contains carbon
monoxide, a colourless and odourless gas. Breathing exhaust fumes can cause loss of consciousness and may
lead to death.
• DO NOT overload the machine capacity by attempting to till too deep at too fast a rate.
• NEVER operate the machine at high transport speeds on slippery surfaces. Look behind and use care when
backing.
• NEVER allow bystanders near the unit.
• Use only attachments and accessories approved by the manufacture for the tiller.
• NEVER operate the tiller without good visibility or light.
• Be careful when tilling in hard ground. The tynes may catch in the ground and propel the tiller forward. If
this occurs, let go of the handlebars and do not attempt to hold back the machine.
• Take all possible precautions when leaving the machine unattended. Disengage all controls levers, stop the
engine, wait for all moving parts to stop, and make certain guards and shields are in place.
• Keep machine, attachments, and accessories in safe working condition.
• Check shear bolts, engine mounting bolts, and other bolts at frequent intervals for proper tightness to be
sure the equipment is in safe working condition.
• To prevent accidental starting, always disconnect and secure the spark plug wire from the spark plug before
performing any tiller maintenance.
• Always allow muffler to cool before filling fuel tank.
• NEVER store the tiller with petrol in the tank or in an enclosed area where petrol fumes could reach a strong
heat source or a flame. Allow the engine to cool down before you store tiller in storage.
• Always refer to the Owner’s Manual for important details if the tiller is to be stored for an extended period.
GENERAL SAFETY RULES
Praat mee over dit product
Laat hier weten wat jij vindt van de BBT BBT-TILL-6.5HPBS Cultivator. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.