ELECTRICAL CONNECTIONS
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an
approved 13 amp BS 1363 plug, or a suitably fused isolator switch.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the flexible lead of this appliance may not correspond with the
coloured markings identifying terminals in your plug proceed as follows:
❐ Connect GREEN & YELLOW cord to terminal marked with a letter “E” or Earth
symbol “ ” or coloured GREEN or GREEN & YELLOW.
❐ Connect BROWN cord to terminal marked with a letter “L” or coloured RED.
❐ Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.
non-rewireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
FUSE RATING
The fuse in the plug must be replaced with one of the same rating (13 amps) and
this replacement must be approved to BS1362.
We recommend that this machine is connected to the mains supply via a Residual
Current Device (RCD)
If in any doubt, DO NOT attempt any connections or repairs yourself. Consult a
qualified electrician, your Clarke dealer,
or telephone CLARKE International Service Dep’t on:
020 8556 4443
5
PROBLEM
PROBABLE CAUSE
REMEDY
The compressor
will not start, or
stops and will not
start again.
Bad connections.
Check the electrical
connections.
Clean and tighten as
necessary.
Blown fuse
Overload cutout
switch has tripped.
FAULT FINDING
Compressor does
not start.
Air receiver charged
(Does ot apply to
SHHH2)
(see also item 1)
Open drain valve to expel air.
Compressor should start again
when pressure reduces to
approx 95 psi.
Air leaking from
the pressure
switch valve
when the
compressor is not
running.
Faulty non-return
valve.
First drain the receiver
completely of air. Renew the
non-return valve.
Air pressure from
the regulator will
not adjust.
Replace RegulatorThe diaphragm within
the regulator body is
broken.
The compressor
does not reach
the set pressure
and overheats
easily.
NOTE: It is also possible
that you are using
more air than the
compressor is capable
of delivering.
Inlet Air Filter is blocked
Renew Oil Filler/Air Filter plug
Compressor
operating, but
no air from outlet
Renew Oil Filler/Air Filter Plug
Turn Regulator clockwise to set
required pressure
Close Drain Valve
Reconnect or replace Bleed
Pipe
Inlet Air Filter Blocked
Pressure Regulator
closed
Drain valve open
Bleed Pipe (from
Pressure Switch to non-
return valve) broken or
disconnected
8
Praat mee over dit product
Laat hier weten wat jij vindt van de Clarke SHHH 7/100 Compressor. Als je een vraag hebt, lees dan eerst zorgvuldig de handleiding door. Een handleiding aanvragen kan via ons contactformulier.