Handleiding Cuisinart CGG-608 Barbecue

Handleiding

8

9

5.3 Installing the Gas Cylinder

(The propane gas cylinder is not provided with the appliance.)

A gas cylinder complying with the requirements listed in section 5.2 must be obtained before the grill can operate.

Connect the LP cylinder to the grill outdoors only.

Read and follow all direction on the cylinder.

1. Turn the burner control knob to “OFF” position.

2. Remove the protective caps from the cylinder valve and

coupling nut, if present.

3. Ensure grill legs are extended as shown in

Assembly Instruction, Step 1 (page 6).

4. Push the cylinder into the threaded regulator

connector and turn clockwise until tight.

5. TIGHTEN BY HAND ONLY. Do not use tools.

Removal Of The Gas Cylinder

1. Turn the regulator’s knob to “OFF” position.

2. Turn the cylinder counterclockwise until it comes off.

5.4 Checking for Gas Leak

m DANGER

Check gas system for leaks to prevent fire or explosion hazard

1. The “Leak Check” must be performed before lighting the

grill and each time the cylinder is connected for use.

2. Do not smoke or allow other sources of ignition in the area

while conducting a leak test.

3. Conduct the leak test outdoors in a well-ventilated area.

4. Do not use matches, lighters or a ame to check for leaks.

5. Do not use grill until all leaks have been stopped. If you

are unable to stop a leak, disconnect the propane supply,

and call for gas application service or your local propane

gas supplier.

Leak Check Method

1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.

2. Make sure control knob is in the “OFF” position.

3. Spray or paint some leak solution on the cylinder and regulator connection.

4. Inspect the solution at the connections, looking for bubbles. If no bubbles appear, the connection is secure.

5. If bubbles appear, a leak is detected. Go to step 6.

6. Disconnect the cylinder from the regulator, and reconnect. Make sure the connection is secure

and no leak is found before using the grill.

7. If you continue to see bubbles,

DO NOT USE THE GRILL. Repeat the above process

with a different LP cylinder. If leaks are still present, contact the customer service center.

5.5 Lighting Instructions

1. Read all instructions before lighting.

2. Open lid during lighting.

3. Make sure the regulator’s knob is in “OFF” position.

4. Push the gas control knob and quickly turn counterclockwise to “HIGH” position. The igniter will click and light the

burner.

5. If ignition does not occur in 5 seconds, turn the gas control knob off, wait 5 minutes, and repeat steps 2 - 5.* Before

cooking on this grill for the rst time, operate the grill for about 15 minutes with the lid closed and the gas turned on

“HIGH”. This will “heat clean” the internal parts and dissipate odor from the painted nish.

*Clean your grill after each use.

See Section 6.3 for instructions

*If the burner does not light, turn the gas control knob off and wait 5 minutes to let the gas clear before you try again.

5.6 Match lighting

IMPORTANT!

A match lighting hole is located on the left side of the rebox.

Match lighting instructions:

1. Read all instructions before lighting.

2. Open lid during lighting.

3. Make sure the knob on the regulator is in “OFF” position.

4. Strike a long wooden match and position the burning match through the match lighting hole in the left side of the

rebox. Place the ame near the bottom edge of the burner.

5. Push down and turn the burner control knob counterclockwise to the high setting.

6. The burner should light. The ame will carry around the burner. Allow grill to pre-heat with the grill lid closed for 2-3

minutes before cooking.

mCAUTION:

Do not touch any hot grill parts. The outside of the grill bottom especially becomes very hot during use. Use protective

gloves to handle any parts that might become hot during use.

5.7 Using the Grill

Inspect the burner ame by looking through the match lighting holes.

A good ame should be blue with some yellow tips coming from the

burner holes. Yellow tips on ames up to 1/4“ in height are acceptable as

long as no carbon or soot deposits appear.

During operation, stand to the side of grill when opening the grill lid.

Do not expose any part of your body directly above the cooking area.

The burner opening must be positioned properly over the valve orices.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Cuisinart CGG-608 Barbecue. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Cuisinart. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Cuisinart CGG-608 Barbecue in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Cuisinart Barbecues
Meer handleidingen voor Barbecues

Veelgestelde vragen over Cuisinart CGG-608 Barbecue

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Cuisinart BQ800BE Barbecue

Handleiding

Cuisinart BQ400BE Barbecue

Handleiding

Cuisinart BQ900BE Barbecue

Handleiding

Cuisinart BQ600BE Barbecue

Handleiding

Campingaz Party Grill 600 Barbecue

Handleiding

Livoo DOC283C Kamado Barbecue

Handleiding

Livoo DOC172VE Barbecue

Handleiding

Cobb Pro Compact Barbecue

Gerelateerde categorieën