Handleiding Eureka K2-XT Tent

Handleiding

Fig.1

B

A

C

G

F

D

E

H

ASSEMBLY INSTRUCTIONS

FOR THE K2-XT

Component List: 1 Tent Body 1 Fly 4 Poles

1 Vestibule Rod 1 Carry Bag 1 Pole Bag 1 Bag w/ Stakes

Assembly:

1 Unpack the carry bag and separate the components.

Unfold the tent body and lay it out with the floor on the

ground and a grommeted web in each corner. Pull the

tent into a rough hexagon. Do not stake down the tent

just yet; but in windy conditions, stake down one corner

that faces into the wind.

2 Assemble the shockcorded tent poles and rod.

Carefully seat each section. Try to keep the poles from

snapping together as this can damage the ends. Set the

shorter vestibule rod aside.

3 Insert the tent poles into the mesh sleeves.

• Near the side of the door, insert and slide a pole

through the continuous mesh sleeve from A to B. Push

the pole rather than pull it.

• At the other side of the door, insert and slide a second

pole from C to D.

• Insert and slide the remaining two poles through the

mesh sleeves from E to F and from G to H. See fig.1.

4 Raise the tent.

• At location A, grasp the end of the pole and

insert the post into the first grommet (the one

closest to the tent) on the web. At location B,

lift the tent and push the pole from B to A to

create an arc. Insert the locking post into one

of the grommets on web to maintain tension.

There are 2 or 3 grommets on each web —

these are for adjustment. If possible, insert the

posts into the grommets closest to the tent to make

the canopy tight and wrinkle free.

• Repeat with the second pole from C to D.

• Move to the side of the tent and insert the locking post into the first

grommet on the side web at E. On the opposite side and at location

F grasp the end of the pole and push from F to E to form an arc.

Insert the post into a grommet on the web.

• Continue with the last pole

from G to H. See fig.2 and fig.3.

6 Attach the fly to the tent.

• Spread the fly on the

ground. Find the front

vestibule; it has a door and

clear plastic window. Drape

the fly, right side up, on top of

the tent so that the vestibule

covers one of the doors.

• Reach under the fly and attach

all the Velcro

®

tabs, through the

openings in the sleeves, to the

poles. See fig.4.

• Connect the six side release buckles

on the fly to their mates on the tent.

See fig.5.

• Move to the rear of the tent and stake

out the web loop on the back

vestibule, but do not adjust the

tension just yet. Go to the front of tent

and stake out the two web loops on

the front vestibule. See fig.7.

7 Tighten the webs until the vestibule

is taut. Work your way around the

tent, tighten the six side release

buckle webs from the fly and from

the rear stake out web. See Fig.8.

8 Stake out the attached guy lines

and adjust the sliders to a proper

tension. See fig.9.

REV D 4.09

Fig.2

Fig.3

Fig.4

Fig.5

Fig.6

Fig.9

Fig.8

Fig.7

Your tent is now ready for use.

Open the two fly roof vents through the zippered slots in the

tent roof. Then, roll up the vestibule door from the bottom or to

the side for better ventilation. The front vestibule also features

an attached snow flap around the bottom.

Take down :

Pull up stakes. Release the fly’s Velcro

®

and

buckles. Remove fly and open door. Pull posts out of the

grommets and push poles out of the sleeves. Collapse the tent

poles and stow. Fold the tent onto itself and fold the fly and lay

it on tent. Roll up both towards the door and stow.

5 Stake the tent down.

Your tent is now free

standing. Place it in the

desired location and

stake it down. Be sure to

drive the stakes through

the web loops or rings-

not the grommets.

• Insert the posts of the

vestibule pole into the

grommets on the web at

either side of the door.

Connect the five clips on the

fly to the poles. See fig.6.

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Eureka K2-XT Tent. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Eureka. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Eureka K2-XT Tent in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Eureka Tenten
Meer handleidingen voor Tenten

Beoordeling

Veelgestelde vragen over Eureka K2-XT Tent

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Eureka Spitfire 2 Tent

Handleiding

Eureka Combat Tent

Handleiding

Eureka Midori 4 Tent

Handleiding

Eureka Tetragon HD 5 Tent

Handleiding

Eureka Taron Basecamp 6 Tent

Handleiding

Eureka Copper Canyon 1512 Tent

Handleiding

Eureka High Camp Tent

Handleiding

Eureka Tetragon Tent

Gerelateerde categorieën