Handleiding Eureka Midori 2 Tent

Handleiding

Good:

4 stakes /4 lines

Best:

4 stakes /8 lines

REV E. AUG 12

SEAM SEALING:

We recommend use of a sealer such as Kenyon Seam Sealer 3 or McNett Outdoor

SeamGrip

®

.

• Work in a fully ventilated area.

• Set the tent up or lay the tent out flat. Taut seams allow for even application and

penetration of the sealer.

• Decide which seams need to be sealed. For example, seams that will be exposed

to rain, runoff, or ground level water are a must for sealing, while seams on

uncoated nylon or mesh panels don’t need treatment. There is no need to seal

the seams in the roof or the factory taped seams. We recommend sealing both

floor and fly seams and reinforcements.

• Apply sealant to the inside and outside of all exposed seams. Several thin layers

will work better than one thick layer. Read and follow manufacture's instructions.

STAKING:

All tents need to be staked down to keep them from blowing away. Securing the

tent by placing heavy objects inside is just not adequate.

• Once the tent body is erected, stake it out before the fly is put on. This enables

you to square the tent up to ensure that the fly goes on properly and that the

seams align with the frame. Pull the base of the tent taut between each web

stake out loop or ring & pin. Make sure that all corners are square. It is important

that you don’t stake the tent out too tightly. You will know it’s too tight, if the door

zippers can not be easily operated. Drive stakes through the web loops, or with

ring & pin, drive the stake just outside the ring so that the “J” hook catches it. Tie

a piece of cord or web into a loop through the ring to be used as a large stake

loop if needed.

• With the tent properly staked, drape the fly over the frame, attach its tent

connection points and stake down any pull outs.

• Do not attempt to remove the stakes by pulling on the tent becket loop, as this

could cause the fabric to tear. The best way is to pry on the stake itself.

Staking in special conditions:

• Sand. Use long, broad stakes with plenty of surface area in loose soil.

• Hard, Rocky, or Frozen Soil. Steel stakes work best. Store steel stakes

separately. Their sharp edges can cut fabric and leave rust stains, which might

damage your tent.

• Snow. Use “dead man” anchors. Tie tent to buried objects (branches, tent bags,

or stuff sacks filled with snow; or tie tents to snow shoes, skis, or ski poles,

which are stuck in the snow.

GUY LINES:

Do not depend upon staking alone to keep your tent secure during high winds. Most

tent models have built-in loops or rings at optimal guy out locations. It’s important

to put in the extra time guying out your tent. Correctly done, it can save your tent

during exceptional weather.

• Make sure that the top fly is securely attached to the tent frame. Ties, hook and

loop, or dog-bones and elastic loops are sewn to the underside of the fly for this

purpose.

• Attach parachute cord to the loops/rings and stake them in the ground three or

four feet from the edge of the tent. If staked too close to the tent, wind can cause

an upward pull that could dislodge the stakes.

• If your tent does not have loops or rings for guy outs, attach guy lines 1/3

to 1/2 of the way up the framework on the main sidewalls. This enables the

guy line to support the lower section of the pole, while the upper pole can

flex and deflect wind gusts. It is best to run two cords at an angle from the

side of the guy out. This prevents all movement, except toward the anchor.

The guy lines will work together through opposition. See illustrations

below:

CONDENSATION & VENTING:

Through perspiration and breathing, an adult gives off about a pint of water

overnight. If it cannot escape, the water vapor condenses to liquid. Most

often, water found in the tent is a result of this condensation rather than

from the tent leaking. Condensation often forms where the sleeping bag

touches the side of the tent, under the sleeping pad, or on coated surfaces

such as the door flaps. A tent’s double wall construction allows the vapor to

escape through the roof to the outside, keeping the inside of the tent dry.

Leave the windows partially open at night to provide cross ventilation and

further reduce condensation. Cross ventilation becomes more important in

very humid or extremely cold conditions when the permeable roof is less

effective. The features that enhance ventilation are windows, short-sheeted

flys (bottom venting), roof vents, and High/Low venting doors. These are

specific to each tent model.

Given the importance of proper ventilation, We use High/Low venting in most

of our tents. This allows cooler air in through the low vents and warmer,

moist air up and out through the high vents. High/Low venting is

accomplished within the inner tent via roof vents, doors and windows. It is

important to vent the vestibule. Unvented, it can inhibit airflow into the tent.

Our tent vestibules profit from the ability to “short sheet” by means of

zippers & toggles and staked vestibule pull outs create a bellowing effect.

Most of our tents are equipped with a High/Low venting door. This design

allows increased airflow into the tent from the bottom. Open the low

vent/window to admit cool air, allowing the warmer air out through the high

roof vents. When rain and wind prevent the low vent from being opened,

the high door vent can still be used. Fly overhangs or vestibules protect it.

ULTRAVIOLET LIGHT:

Ultraviolet light damage to tent fabric is caused by excessive exposure to

sunlight. While our fabrics are UV resistant, any synthetic fabric is

susceptible to UV degradation. UV damage will cause nylon and polyester

to become brittle and tear easily. We recommend that you use the rain fly

even on clear days. It acts as a sunscreen to the tent. A rain fly is both

easier and less expensive to replace if damaged. UV damage can be

minimized by erecting tents on shaded sites with low exposure to direct

sunlight.

GENERAL POLE CARE:

• Never let tent poles snap together as this can damage the pole end.

• Do not drop tent or pole bags on their ends and do not bounce a tent bag

on its end to get the tent out. These actions may cut the shock cord and

damage the pole ends.

• The aluminum frame may bend slightly and take a “set” through usage; this

normally does not affect the performance of the frame.

GENERAL TENT CARE:

• Sweep the tent floor daily to prevent damage from stones.

• Try not to wear shoes inside your tent.

• Use a ground cloth whenever possible.

• Do not keep food inside a tent. Hungry critters will chew through tent fabric

in search of food.

STORAGE:

• Make sure the tent is completely dry, then store loosely rolled, in a dry, cool

place. To prevent dust from collecting on the tent, cover it with a cloth. This

allows the nylon/polyester fabric to breathe.

• Ideally, the tent poles should be stored in their fully assembled state. This

reduces the tension on the shock cord, prolonging its life.

• The tent bag should be used only as a carry sack and not for storage.

COLOR TRANSFER:

• Do to the nature of tent fabrics, color can transfer from darker to lighter

fabrics when the two fabrics are in contact over time when wet, damp or

exposed to the combination of moisture and high heat. This does not effect

the tent's performance. To prevent / minimize color transfer, always make

sure your tent is completely dry prior to packing and storage.

CLEANING:

• Clean the tent by setting it up and wiping it down with a mild soap (liquid

hand soap) and lukewarm water solution. Rinse thoroughly and dry

completely. Never use detergent, washing machines or dryers because they

can damage the tent’s protective coating and seams. After cleaning, be sure

the tent is completely dry, especially the heavier, double-stitched areas such

as the seams, before storing or mold / mildew are likely to grow.

• Clean the tent poles with a cloth and lubricate them with silicone spray. This

is especially necessary after ocean side camping to remove salt spray so the

poles don’t corrode or stay gritty.

• Clean the zippers with a quick dip in water and then dry them off. This is

especially important if you’ve been camping in a location with sand/dirt. If

you don’t clean the zippers, the sliders will wear out and eventually the teeth

will become inoperable.

ALTERATIONS OR MODIFICATIONS:

DO NOT misuse, modify or alter this product in any way from its condition at

the time of sale. Alteration, modification or any use of this product contrary

to the accompanying written instructions shall void the warranty. Moreover,

any misuse, alteration or modification of the product shall absolve Johnson

Outdoors Gear LLC of any liability for property damages or injuries sustained

as a result of such misuse, modification or alteration.

LIMITED WARRANTY:

What Is Covered: Johnson Outdoors Gear LLC

warrants to the original

purchaser that its products are free from defects in material and workmanship,

for the life of the product, except as qualified below. The life of the product is

determined from the date of purchase until such time as the product is no

longer serviceable due to normal wear and tear.

What Is Not Covered:

Johnson Outdoors Gear LLC

shall not be responsible for the

natural breakdown of materials that occurs inevitably with extended use (e.g., Ultra

Violet (UV) light damage on tents, exhausted zippers), or defects caused by

accident, abuse, alteration, animal attack, storm damage, misuse or improper care.

THERE ARE NO OTHER EXPRESS WARRANTIES BEYOND THE TERMS OF THIS

LIMITED WARRANTY. IN NO EVENT SHALL JOHNSON OUTDOORS GEAR LLC BE

LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.

Some states do not allow the exclusion or limitation of incidental or consequential

damages, so the above limitation or exclusion may not apply to you.

What Johnson Outdoors Gear LLC Will Do: If after inspection we find that a

product failed due to a manufacturing or material defect, we will repair or

replace the product, at our option, without charge.

How to Obtain Warranty Service: Return the product, freight prepaid, to the

Dealer from whom it was purchased; or, contact our Customer Satisfaction

Department for return authorization: toll free

905-634-0023

. Collect shipments

or shipments without return authorization cannot be accepted. The product

registration card packaged with our product need not be returned for the

warranty to be effective and for you to receive warranty service.

Repairs: If your

Johnson Outdoors Gear LLC

product needs service or repair

due to normal wear and tear, animal attack, accident or some other reason

that is not covered under the warranty we will provide the necessary service

for a reasonable charge, plus shipping and handling. We require that products

accepted for any repair be properly cleaned according to our recommended

care instructions. Please send your product or component that requires repair

(e.g., tent fly), postage prepaid, along with a description of what needs

attention. For service and repairs, please contact our Customer Satisfaction

Department: toll free

905-634-0023

How State Law Relates To This Warranty: This warranty gives you specific

legal rights, and you may have other rights that vary from state to state.

Our experience building quality outdoor

equipment goes back over 100 years!

Today, we manufacture sleeping bags,

screen houses, day-use shelters and

camping tents. We also design and

manufacture tents for the United

States Military and for the rental

industry.

See eurekatentscanada.com

From baseplate and digital

compasses to electronic

instruments, our sister brands,

Silva and Tech4o, put outdoor

technology at your fingertips.

See tech4o.com and silvausa.com

Our brands are part of the Johnson

Outdoors family of products. Visit all

the brands at johnsonoutdoors.com

We support the "Leave No Trace"

Seven Principles:

1. PLAN AHEAD AND PREPARE

2. TRAVEL & CAMP ON DURABLE SURFACES

3. DISPOSE OF WASTE PROPERLY

4. LEAVE WHAT YOU FIND

5. MINIMIZE CAMPFIRE IMPACTS

6. RESPECT WILDLIFE

7. BE COURTEOUS OF OTHER VISITORS

WARNING:

KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.

• This tent meets the flammability requirements of CPAI-84. The fabric may

burn if left in continuous contact with any flame source. The application

of any foreign substance to the tent fabric may render the flame-resistant

properties ineffective.

• Do NOT operate any device which burns fuel inside your tent. Combustion

consumes oxygen and can produce dangerous levels of carbon monoxide,

which could lead to serious injury or death.

JOHNSON OUTDOORS CANADA INC.

4180 Harvester Road, Burlington, Ontario L7L 6B6

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Eureka Midori 2 Tent. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Eureka. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Eureka Midori 2 Tent in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Eureka Tenten
Meer handleidingen voor Tenten

Beoordeling

Veelgestelde vragen over Eureka Midori 2 Tent

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Eureka Assault Outfitter Tent

Handleiding

Eureka K2-XT Tent

Handleiding

Eureka El Capitan 3 Tent

Handleiding

Eureka Titan Tent

Handleiding

Eureka Down Range 2 Tent

Handleiding

Eureka Taron Basecamp 4 Tent

Handleiding

Eureka Taron Basecamp 6 Tent

Handleiding

Eureka Apex XT Tent

Gerelateerde categorieën